- 您現在的位置：買賣IC網 > PDF目錄359559 > JW075A Power Modules: dc-dc Converters; 36 to 75 Vdc Input, 5 Vdc Output; 50 W to 150 W PDF資料下載
參數資料
| 型號： | JW075A |
| 元件分類： | DC/DC變換器 |
| 英文描述： | Power Modules: dc-dc Converters; 36 to 75 Vdc Input, 5 Vdc Output; 50 W to 150 W |
| 中文描述： | 電源模塊：型DC - DC轉換器，36至75伏直流電輸入，5伏直流電輸出，50瓦至150瓦 |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 1036K |
| 代理商： | JW075A |
10
Tyco Electronics Corp
Data Sheet
July 1999
dc-dc Converters; 36 to 75 Vdc Input, 5 Vdc Output; 50 W to 150 W
JW050A, JW075A, JW100A, JW150A Power Modules:
Safety Considerations
For safety-agency approval of the system in which the
power module is used, the power module must be
installed in compliance with the spacing and separation
requirements of the end-use safety agency standard,
i.e.,
UL
1950,
CSA
C22.2 No. 950-95, and VDE 0805
(EN60950, IEC950).
If the input source is non-SELV (ELV or a hazardous
voltage greater than 60 Vdc and less than or equal to
75 Vdc), for the module’s output to be considered meet-
ing the requirements of safety extra-low voltage
(SELV), all of the following must be true:
I
The input source is to be provided with reinforced
insulation from any hazardous voltages, including the
ac mains.
I
One V
the input and output pins are to be kept floating.
I
pin and one V
O
pin are to be grounded or both
I
The input pins of the module are not operator acces-
sible.
I
Another SELV reliability test is conducted on the
whole system, as required by the safety agencies, on
the combination of supply source and the subject
module to verify that under a single fault, hazardous
voltages do not appear at the module’s output.
Note:
Do not ground either of the input pins of the
module without grounding one of the output pins.
This may allow a non-SELV voltage to appear
between the output pin and ground.
The power module has extra-low voltage (ELV) outputs
when all inputs are ELV.
The input to these units is to be provided with a maxi-
mum 20 A normal-blow fuse in the ungrounded lead.
Feature Descriptions
Overcurrent Protection
To provide protection in a fault (output overload) condi-
tion, the unit is equipped with internal current-limiting
circuitry and can endure current limiting for an unlim-
ited duration. At the point of current-limit inception, the
unit shifts from voltage control to current control. If the
output voltage is pulled very low during a severe fault,
the current-limit circuit can exhibit either foldback or tai-
lout characteristics (output current decrease or
increase). The unit operates normally once the output
current is brought back into its specified range.
Remote On/Off
Two remote on/off options are available. Positive logic
remote on/off turns the module on during a logic-high
voltage on the ON/OFF pin, and off during a logic low.
Negative logic remote on/off turns the module off dur-
ing a logic high and on during a logic low. Negative
logic (code suffix “1”) is the factory-preferred configura-
tion.
To turn the power module on and off, the user must
supply a switch to control the voltage between the
on/off terminal and the V
I
(–) terminal (V
switch can be an open collector or equivalent (see
Figure 20). A logic low is V
maximum I
on/off
during a logic low is 1 mA. The switch
should maintain a logic-low voltage while sinking 1 mA.
on/off
). The
on/off
= 0 V to 1.2 V. The
During a logic high, the maximum V
the power module is 15 V. The maximum allowable
leakage current of the switch at V
on/off
generated by
on/off
= 15 V is 50 μA.
If not using the remote on/off feature, do one of the
following:
For negative logic, short ON/OFF pin to V
For positive logic, leave ON/OFF pin open.
I
I
(–).
I
8-720 (C).c
Figure 20. Remote On/Off Implementation
SENSE(+)
V
O
(+)
SENSE(–)
V
O
(–)
V
I
(–)
+
–
I
on/off
ON/OFF
V
I
(+)
LOAD
V
on/off
相關PDF資料 |
PDF描述 |
|---|---|
| JW075A1 | Power Modules: dc-dc Converters; 36 to 75 Vdc Input, 5 Vdc Output; 50 W to 150 W |
| JTN1ASPAFDC5V | COMPACT ECONOMICAL 30 AMP. RELAY |
| JTN1ASPAFDC6V | COMPACT ECONOMICAL 30 AMP. RELAY |
| JTN1ASTMPFDC15V | COMPACT ECONOMICAL 30 AMP. RELAY |
| JTN1ASTMPFDC18V | COMPACT ECONOMICAL 30 AMP. RELAY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| JW075A1 | 功能描述:DC/DC轉換器 5V 10A 50W 9-Pin RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| JW075A1-E | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DC-to-DC Voltage Converter |
| JW075A5 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DC-to-DC Voltage Converter |
| JW075A-E | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DC-to-DC Voltage Converter |
| JW075B | 制造商:Alcatel-Lucent 功能描述: 制造商:Lucent 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。