- 您現在的位置：買賣IC網 > PDF目錄384527 > ISL6740AIVZA-T (INTERSIL CORP) Flexible Double-Ended Voltage-Mode PWM Controller with Voltage Feed Forward PDF資料下載
參數資料
| 型號： | ISL6740AIVZA-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Flexible Double-Ended Voltage-Mode PWM Controller with Voltage Feed Forward |
| 中文描述： | 1 A SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | LEAD FREE, PLASTIC, MO-153-AC, TSSOP-16 |
| 文件頁數： | 12/15頁 |
| 文件大小： | 320K |
| 代理商： | ISL6740AIVZA-T |
12
FN9195.0
February 7, 2005
stops at least 50
μ
s prior to the soft-start voltage decreasing
to 4.25V, the soft-start charging currents revert to normal
operation and the soft-start voltage is allowed to recover.
Figure 7 shows the overcurrent behavior during SS.
Although an overcurrent condition exists, a shutdown is not
allowed prior to completion of the SS cycle. Only peak
current limit operates during the soft-start cycle. If the
overcurrent condition were to continue beyond the soft-start
cycle, a delayed overcurrent shutdown would occur as
shown in Figure 8.
Figure 8 portrays the typical delayed overcurrent shutdown
behavior. Once SS has discharged to 4.25V, the outputs are
disabled and remain that way until SS has discharged to
0.27V, and then a new SS cycle begins.
If the overcurrent condition is removed prior to a shutdown, a
recovery can occur as indicated in Figure 9. When the load
decreases below the overcurrent threshold and an additional
50
μ
s elapses without the SS dropping below 4.25V, the
overcurrent circuitry resets and the soft-start voltage
recovers.
The duration of the OC shutdown period can be increased
by adding a resistor between VREF and SS. The value of
the resistor must be large enough so that the minimum
specified SS discharge current is not exceeded. Using a
422k
resistor, for example, will result in a small current
being injected into SS, effectively reducing the discharge
current. This will nearly double the OFF time. The external
pull-up resistor will also decrease the SS duration, so its
effect should be considered when selecting the value of the
SS capacitor.
Latching OC shutdown is also possible by using a lower
valued resistor between VREF and SS. If the SS node is not
allowed to discharge below the SS reset threshold, the IC
will not recover from an overcurrent fault. The value of the
resistor must be low enough so that the maximum specified
discharge current is not sufficient to pull SS below 0.33V. A
200k
resistor, for example, prevents SS from discharging
below ~0.4V. Again, the external pull-up resistor will
decrease the SS duration, so its effect should be considered
when selecting the value of the SS capacitor
Short Circuit Operation
If the output current increases beyond the overcurrent
threshold, peak current limit will reduce the duty cycle. As
the load current continues to increase, the duty cycle
continues to decrease. A short circuit event is defined as the
simultaneous occurrence of current limit and a reduced duty
cycle.
The degree of reduced duty cycle that defines a short circuit
condition is user adjustable using the SCSET input. A
resistor divider between R
TD
, R
TC
, or V
REF
and GND to
RCSET sets a threshold that is compared to the voltage on
the timing capacitor, C
T
. The resistor divider voltage divided
SS
0.6 V OC
CS
OUTA
OUTB
4.5 V
FIGURE 7. PULSE-BY-PULSE OC BEHAVIOR DURING SS
SS
CS
OUTA
OUTB
4.5 V
4.25 V
0.27 V
0.6 V OC
FIGURE 8. OC SHUTDOWN BEHAVIOR
FIGURE 9. OC RECOVERY PRIOR TO SHUTDOWN
SS
CS
OUTA
OUTB
4.5 V
4.25 V
0.6 V OC
50
μ
S
OC
SS
VREF
1
2
4
3
5
6
7
8
9
10
11
12
13
14
15
16
C
SS
R
ISL6740A
FIGURE 10. MODIFYING OC SHUTDOWN TIMING
ISL6740A
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6742 | Octal Buffers/Drivers With 3-State Outputs 20-SSOP -40 to 85 |
| ISL6742AAZA-T | Advanced Double-Ended PWM Controller |
| ISL6742AAZA | Octal Buffers/Drivers With 3-State Outputs 20-SSOP -40 to 85 |
| ISL6744 | Octal Buffers/Drivers With 3-State Outputs 20-SOIC -40 to 85 |
| ISL6744AB | Octal Buffers/Drivers With 3-State Outputs 20-SOIC -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6740EVAL1 | 功能描述:EVALUATION BOARD 1 ISL6740 RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓?fù)浣Y(jié)構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| ISL6740EVAL2 | 功能描述:EVALUATION BOARD 2 ISL6740 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| ISL6740EVAL2Z | 功能描述:EVALUATION BOARD 2 ISL6740 RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓?fù)浣Y(jié)構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| ISL6740EVAL3Z | 制造商:Intersil Corporation 功能描述:ISL6740 EVALUATION BOARD 3 - ROHS COMPLIANT - SOIC - DSL - Bulk 制造商:Intersil Corporation 功能描述:Power Management IC Development Tools ISL6740 EVAL RD 3 ROHS CMPL DSL |
| ISL6740IB | 功能描述:IC REG CTRLR PWM VM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:100% 電源電壓:8.2 V ~ 30 V 降壓:無 升壓:無 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:0°C ~ 70°C 封裝/外殼:8-DIP（0.300"，7.62mm） 包裝:管件 產品目錄頁面:1316 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。