- 您現在的位置：買賣IC網 > PDF目錄383159 > ISL6567CRZ-T (INTERSIL CORP) Multipurpose Two-Phase Buck PWM Controller with Integrated MOSFET Drivers PDF資料下載
參數資料
| 型號： | ISL6567CRZ-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Multipurpose Two-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| 中文描述： | SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PQCC24 |
| 封裝： | 4 X 4 MM, ROHS COMPLIANT, PLASTIC, MO-220VGGD-2, QFN-24 |
| 文件頁數： | 12/26頁 |
| 文件大?。?/td> | 659K |
| 代理商： | ISL6567CRZ-T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
12
OVERCURRENT PROTECTION
The individual channel currents, as sensed via the PHASE
pins and scaled via the ISEN resistors, as well as their
combined average are continuously monitored and
compared with an internal overcurrent (OC) reference. If the
combined channel current average exceeds the reference
current, the overcurrent comparator triggers an overcurrent
event. Similarly, an OC event is also triggered if either
channel’s current exceeds the OC reference for 7
consecutive switching cycles.
As a result of an OC event, output drives turn off both upper
and lower MOSFETs, and the SS capacitor is discharged via
a 20
μ
A current source. The behavior following this standard
response varies depending whether the controller is
operating in internal (using internal reference; MON > 3.5V)
or external reference mode (using external reference; MON
< 3.5V). As shown in Figure 6, the soft-start capacitor
discharge prompted by the OC event is followed by two SS
cycles, during which the ISL6567 stays off. Following the
dormant SS cycles, the controller attempts to re-establish
the output. Should the OC condition been removed, the
output voltage is ramped up and operation resumes as
normal. Should the OC condition still be present and result in
another OC event, the entire behavior repeats until the OC
condition is removed or the IC is disabled. Figure 7 details
the OC behavior while in external reference mode. Following
the OC event, the output drives are turned off, the ISL6567
latches off, and the SS capacitor is discharged to ground.
Resetting the OC latch involves removal of bias power or
cycling of the EN pin (pictured in Figure 7). Should the OC
event been removed, the controller initiates a new SS cycle
and restores the output voltage.
SETTING THE OUTPUT VOLTAGE
The ISL6567 uses a precision internal reference voltage to
set the output voltage. Based on this internal reference, the
output voltage can thus be set from 0.6V up to a level deter-
mined by the input voltage, the maximum duty cycle, and the
conversion efficiency of the circuit; the following equation
estimates this maximum amplitude the output voltage can be
regulated to. Obviously, insure that the input voltage and all
the voltages sampled by the ISL6567 do not exceed the con-
troller’s absolute maximum limits, or any other limits specified
in this document.
OUTPUT CURRENT
FIGURE 6. OVERCURRENT BEHAVIOR WHILE IN INTERNAL
REFERENCE MODE
OUTPUT VOLTAGE
SS
EN
GND>
GND>
OUTPUT CURRENT
FIGURE 7. OVERCURRENT BEHAVIOR WHILE IN EXTERNAL
REFERENCE MODE
OUTPUT VOLTAGE
SS
EN
GND>
GND>
V
OUTMAX
d
MAX
V
IN
Efficiency
=
FIGURE 8. SETTING THE OUTPUT VOLTAGE AT THE INPUT
OF THE DIFFERENTIAL AMPLIFIER
-
+
EXTERNAL CIRCUIT
ISL6567
VSEN
RGND
VDIFF
R
S
R
P
DIFFERENTIAL
AMPLIFIER
X1
FB
-
+
To V
OUT
+
-
V
REF
ERROR
AMPLIFIER
R
1
ISL6567
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6567 | Dual Low-Noise Wide-Bandwidth Precision Amplifier 8-SOIC -40 to 85 |
| ISL6567IRZ | Multipurpose Two-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| ISL6567IRZ-T | Multipurpose Two-Phase Buck PWM Controller with Integrated MOSFET Drivers |
| ISL6568CR | Two-Phase Buck PWM Controller with Integrated MOSFET Drivers for VRM9, VRM10, and AMD Hammer Applications |
| ISL6568CRZ | Two-Phase Buck PWM Controller with Integrated MOSFET Drivers for VRM9, VRM10, and AMD Hammer Applications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6567IRZ | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6567IRZS2698 | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6567IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6567IRZ-TS2698 | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ISL6568CR | 功能描述:IC CTRLR PWM BUCK 2PHASE 32-QFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,000 系列:- 應用:電源，ICERA E400，E450 輸入電壓:4.1 V ~ 5.5 V 輸出數:10 輸出電壓:可編程 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:42-WFBGA，WLCSP 供應商設備封裝:42-WLP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。