參數資料
型號: ISL6551IRZ
廠商: INTERSIL CORP
元件分類: 穩壓器
英文描述: ZVS Full Bridge PWM Controller
中文描述: DUAL SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PQCC28
封裝: 6 X 6 MM, ROHS COMPLIANT, PLASTIC, MO-220VJJC, QFN-28
文件頁數: 10/26頁
文件大?。?/td> 604K
代理商: ISL6551IRZ
10
FN9066.5
January 3, 2006
Block/Pin Functional Descriptions
Detailed descriptions of each individual block in the functional
block diagram on page 3 are included in this section.
Application information and design considerations for each pin
and/or each block are also included.
IC Bias Power (VDD, VDDP1, VDDP2)
- The IC is powered from a 12V
±
10% supply.
- VDD supplies power to both the digital and analog circuits
and should be bypassed directly to the VSS pin with an
0.1
μ
F low ESR ceramic capacitor.
- VDDP1 and VDDP2 are the bias supplies for the upper
drivers and the lower drivers, respectively. They should be
decoupled with ceramic capacitors to the PGND pin.
- Heavy copper should be attached to these pins for a better
heat spreading.
IC GNDs (VSS, PGND)
- VSS is the reference ground, the return of VDD, of all
control circuits and must be kept away from nodes with
switching noises. It should be connected to the PGND in
only one location as close to the IC as practical. For a
secondary side control system, it should be connected to
the net after the output capacitors, i.e., the output return
pinout(s). For a primary side control system, it should be
connected to the net before the input capacitors, i.e., the
input return pinout(s).
- PGND is the power return, the high-current return path of
both VDDP1 and VDDP2. It should be connected to the
SOURCE pins of two lower power switches or the
RETURNs of external drivers as close as possible with
heavy copper traces.
- Copper planes should be attached to both pins.
Undervoltage Lockout (UVLO)
- UVLO establishes an orderly start-up and verifies that VDD
is above the turn-on threshold voltage (VDD
ON
). All the
drivers are held low during the lockout. UVLO incorporates
hysteresis VDD
HYS
to prevent multiple startup/shutdowns
while powering up.
- UVLO limits are not applicable to VDDP1 and VDDP2.
Bandgap Reference (BGREF)
- The reference voltage VREF is generated by a precision
bandgap circuit.
- This pin must be pulled up to VDD with a resistance of
approximately 399k
for proper operation. For additional
reference loads (no more than 1mA), this pull-up resistor
should be scaled accordingly.
- This pin must also be decoupled with an 0.1
μ
F low ESR
ceramic capacitor.
Clock Generator (CT, RD)
- This free-running oscillator is set by two external
components as shown in Figure 1. A capacitor at CT is
charged and discharged with two equal constant current
sources and fed into a window comparator to set the clock
frequency. A resistor at RD sets the clock dead time. RD
and CT should be tied to the VSS pin on their other ends
as close as possible. The corresponding CT for a particular
frequency can be selected from Figure 2.
- The switching frequency (Fsw) of the power train is half of
the clock frequency (Fclock), as shown in Equation 1.
Fsw
-------------------
=
(EQ. 1)
SET CLOCK
DEAD TIME (DT)
RD
RD
CT
CT
VMAX
VMIN
VDD
-
+
-
+
OUT
OUT
S
R
Q
Q
Q
CLK
CLK
Q
DT
DT
FIGURE 1. SIMPLIFIED CLOCK GENERATOR CIRCUIT
I_CT
I_CT
ISL6551
相關PDF資料
PDF描述
ISL6564A Multiphase PWM Controller with Linear 6-Bit DAC Capable of Precision rDS(ON) or DCR Differential Current Sensing
ISL6564ACRZ Multiphase PWM Controller with Linear 6-Bit DAC Capable of Precision rDS(ON) or DCR Differential Current Sensing
ISL6564AIRZ Multiphase PWM Controller with Linear 6-Bit DAC Capable of Precision rDS(ON) or DCR Differential Current Sensing
ISL6566CRR5184 Three-Phase Buck PWM Controller with Integrated MOSFET Drivers for VRM9, VRM10, and AMD Hammer Applications
ISL6566CR-TR5184 Three-Phase Buck PWM Controller with Integrated MOSFET Drivers for VRM9, VRM10, and AMD Hammer Applications
相關代理商/技術參數
參數描述
ISL6552CB 功能描述:IC REG CTRLR BUCK PWM 20-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR)
ISL6552CB-T 功能描述:IC REG CTRLR BUCK PWM 20-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR)
ISL6552CBZ 功能描述:IC REG CTRLR BUCK PWM 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR)
ISL6552CBZA 功能描述:IC REG CTRLR BUCK PWM 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR)
ISL6552CBZA-T 功能描述:IC REG CTRLR BUCK PWM 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:275kHz 占空比:50% 電源電壓:18 V ~ 110 V 降壓:無 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:是 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 包裝:帶卷 (TR)