- 您現在的位置：買賣IC網 > PDF目錄384524 > ISL6297CRZ-T (INTERSIL CORP) Li-ion/Li Polymer Battery Charger PDF資料下載
參數資料
| 型號： | ISL6297CRZ-T |
| 廠商： | INTERSIL CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Li-ion/Li Polymer Battery Charger |
| 中文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC16 |
| 封裝： | 4 X 4 MM, ROHS COMPLIANT, PLASTIC, MO-220VGGC, QFN-16 |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 432K |
| 代理商： | ISL6297CRZ-T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁
11
FN9215.0
September 27, 2005
Specification table and the charge current needs to drop
below the I
MIN
level for 3 to 4 cycles of the internal oscillator.
Internal Oscillator
The internal oscillator establishes a timing reference. The
oscillation period is programmable with an external timing
capacitor, C
TIME
, as shown in Typical Applications. The
oscillator charges the timing capacitor to 1.5V and then
discharges it to 0.5V in one period, both with 10
μ
A current.
The period T
OSC
is:
(EQ. 6)
A 15nF capacitor results in a 3ms oscillation period. The
accuracy of the period is mainly dependent on the accuracy
of the capacitance and the internal current source.
Total Charge Time and C
TIME
Selection
The time allowed for the battery to charge before an end of
charge indication is limited to the duration of the TIMEOUT
counter. The TIMEOUT period can be calculated by:
(EQ. 7)
where C
TIME
is the timing capacitor shown in the Typical
Application circuit. A 1nF capacitor leads to 14 minutes of
TIMEOUT. For example, a 15nF capacitor sets the
TIMEOUT to be 3.5 hours. The EOC indication goes active
when the TIMEOUT counter expires, even if the battery has
not reached full charge. At this point, if the voltage is above
4.05V, the recharge mechanism will continue to charge the
cell until the current drops below I
MIN
. If the TIMEOUT
counter expires before the battery reaches 4.05V, then the
end of charge indication goes active, but the charger turns
off. The charger cannot leave this condition without toggling
the enable pin or cycling the power.
The trickle mode charge has a time limit of 1/8 TIMEOUT. If
the battery voltage does not reach V
MIN
within that time
period, a TIMEOUT fault is issued and the charger turns off
with a flashing Yellow LED indicator. The charger stays in
trickle mode for at least 15 cycles of the internal oscillator
and, at most, 1/8 of TIMEOUT.
Once the ISL6297 detects that the battery reaches the EOC
condition, it resets the TIMEOUT counter. At the end of this
TIMEOUT period, the charger turns off and does not start
again until the battery reaches a recharge condition.
Recharge Threshold
Once the charger reaches an end of charge condition and
the charger turns off, if the battery voltage drops below the
recharge threshold given in the Electrical Specification table,
the charger starts a re-charge cycle. This is identical to an
inital charge cycle, except the indicator remains green.
LED Indications
The LED indicators show a number of conditions. On initial
power on reset, the LEDs sequence through red, green and
T
OSC
0.2
10
6
C
TIME
×
×
=
onds
sec
(
)
TIMEOUT
14
C
1nF
-----------------
×
=
minutes
(
)
FIGURE 6. OPERATION WAVEFORMS
V
IN
V2P9
DT
RED
GRN
V
SEN
I
CHG
Impedance
EN
POR Threshold
500ms
15 cycles to 1/8 TIMEOUT
2.8V min.
I
MIN
Charge Cycle
Charge Cycle
15 cycles
Recharge
TIMEOUT
I
MIN
ISL6297
相關PDF資料 |
PDF描述 |
|---|---|
| ISL6298-2CR3Z-T | Li-ion/Li-Polymer Battery Charger |
| ISL6298 | Li-ion/Li-Polymer Battery Charger |
| ISL6298-2CR3 | Li-ion/Li-Polymer Battery Charger |
| ISL6298-2CR3Z | Quadruple 2-Input Exclusive-OR Gates 14-SOIC -40 to 85 |
| ISL6298-2CR4Z | Li-ion/Li-Polymer Battery Charger |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL6298 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Li-ion/Li-Polymer Battery Charger |
| ISL6298_06 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Li-ion/Li-Polymer Battery Charger |
| ISL6298-2CR3 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Li-ion/Li-Polymer Battery Charger |
| ISL6298-2CR3Z | 功能描述:IC CHARGER LI-ION 4.2V 3X3 10DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| ISL6298-2CR3Z-T | 功能描述:IC CHARGER LI-ION POLYMER 10-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。