- 您現在的位置：買賣IC網 > PDF目錄1925 > ISL22316WFU10Z-TK (Intersil)IC POT DGTL 128TP LN LP 10-MSOP PDF資料下載
參數資料
| 型號： | ISL22316WFU10Z-TK |
| 廠商： | Intersil |
| 文件頁數： | 5/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC POT DGTL 128TP LN LP 10-MSOP |
| 產品培訓模塊： | Solutions for Industrial Control Applications |
| 標準包裝： | 1,000 |
| 系列： | XDCP™ |
| 接片： | 128 |
| 電阻（歐姆）： | 10k |
| 電路數： | 1 |
| 溫度系數： | 標準值 ±50 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
13
FN6186.2
September 1, 2009
Write Operation
A Write operation requires a START condition, followed by a
valid Identification Byte, a valid Address Byte, a Data Byte,
and a STOP condition. After each of the three bytes, the
ISL22316 responds with an ACK. At this time, the device
enters its standby state (see Figure 18).
The non-volatile write cycle starts after STOP condition is
determined and it requires up to 20ms delay for the next
non-volatile write.
Read Operation
A Read operation consists of a three byte instruction
followed by one or more Data Bytes (See Figure 19). The
master initiates the operation issuing the following
sequence: a START, the Identification byte with the R/W bit
set to “0”, an Address Byte, a second START, and a second
Identification byte with the R/W bit set to “1”. After each of
the three bytes, the ISL22316 responds with an ACK. Then
the ISL22316 transmits Data Bytes as long as the master
responds with an ACK during the SCL cycle following the
eighth bit of each byte. The master terminates the read
operation (issuing a ACK and STOP condition) following the
last bit of the last Data Byte (see Figure 19).
In order to read back the non-volatile IVR, it is recommended
that the application reads the ACR first to verify the WIP bit
is 0. If the WIP bit (ACR[5]) is not 0, the host should repeat
its reading sequence again.
ISL22316
相關PDF資料 |
PDF描述 |
|---|---|
| ISL22317WFRTZ | IC POT DGTL 128TP LN LP 10-TDFN |
| ISL22319UFU8Z-TK | IC POT DGTL 128TP LN LP 8-MSOP |
| ISL22323TFV14Z | IC POT DGTL 256TP LN LP 14-TSSOP |
| ISL22326WFV14Z | IC POT DGTL 128TP LN LP 14-TSSOP |
| ISL22329WFU10Z-TK | IC POT DGTL 128TP LN LP 10-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL22316WMUEP | 制造商:Intersil Corporation 功能描述:DGTL POTENTIOMETER 128POS 10KOHM SGL 10MSOP - Rail/Tube |
| ISL22316WMUEP-TK | 制造商:Intersil Corporation 功能描述:DGTL POTENTIOMETER 128POS 10KOHM SGL 10MSOP - Tape and Reel |
| ISL22317 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Precision Single Digitally Controlled Potentiometer (XDCP?) |
| ISL22317_10 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Precision Single Digitally Controlled Potentiometer (XDCP?) |
| ISL22317TFRTZ | 功能描述:數字電位計 IC 128 TAP FL RNG PRECISION 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。