參數資料
型號: ISL12029IVZ
廠商: Intersil
文件頁數: 11/29頁
文件大小: 0K
描述: IC RTC/CALENDAR EEPROM 14-TSSOP
標準包裝: 960
類型: 時鐘/日歷
特點: 警報器,閏年,監控器,監視計時器
時間格式: HH:MM:SS(12/24 小時)
數據格式: YY-MM-DD-dd
接口: I²C,2 線串口
電源電壓: 2.7 V ~ 5.5 V
電壓 - 電源,電池: 1.8 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 14-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 14-TSSOP
包裝: 管件
19
FN6206.10
December 16, 2010
In the read mode, the device will transmit 8 bits of data,
release the SDA line, then monitor the line for an
acknowledge. If an acknowledge is detected and no stop
condition is generated by the master, the device will continue
to transmit data. The device will terminate further data
transmissions if an acknowledge is not detected. The master
must then issue a stop condition to return the device to
Standby mode and place the device into a known state.
Device Addressing
Following a start condition, the master must output a Slave
Address Byte. The first 4 bits of the Slave Address Byte
specify access to either the EEPROM array or to the CCR.
Slave bits ‘1010’ access the EEPROM array. Slave bits
‘1101’ access the CCR.
When shipped from the factory, EEPROM array is
UNDEFINED, and should be programmed by the customer
to a known state.
Bit 3 through Bit 1 of the slave byte specify the device select
bits. These are set to ‘111’.
The last bit of the Slave Address Byte defines the operation
to be performed. When this R/W bit is a one, then a read
operation is selected. A zero selects a write operation (refer
to Figure 19).
After loading the entire Slave Address Byte from the SDA bus,
the ISL12029 compares the device identifier and device select
bits with ‘1010111’ or ‘1101111’. Upon a correct compare, the
device outputs an acknowledge on the SDA line.
Following the Slave Byte is a two byte word address. The
word address is either supplied by the master device or
obtained from an internal counter. On power-up the internal
address counter is set to address 0h, so a current address
read of the EEPROM array starts at address 0. When
required, as part of a random read, the master must supply
the 2 Word Address Bytes as shown in Figure 19.
In a random read operation, the slave byte in the “dummy
write” portion must match the slave byte in the “read”
section. That is if the random read is from the array the slave
byte must be 1010111x in both instances. Similarly, for a
random read of the Clock/Control Registers, the slave byte
must be 1101111x in both places.
SLAVE ADDRESS BYTE
BYTE 0
D7
D6
D5
D2
D4
D3
D1
D0
A0
A7
A2
A4
A3
A1
DATA BYTE
BYTE 3
A6
A5
00
0
A8
0
1
0
1
0
1
0
1
R/W
1
DEVICE IDENTIFIER
ARRAY
CCR
0
WORD ADDRESS 1
BYTE 1
WORD ADDRESS 0
BYTE 2
FIGURE 19. SLAVE ADDRESS, WORD ADDRESS, AND DATA BYTES (64 BYTE PAGES)
ISL12029, ISL12029A
相關PDF資料
PDF描述
ISL12030IBZ IC RTC/CALENDAR EEPROM 8-SOIC
ISL12032IVZ IC RTC LP BATT BACK SRAM 14TSSOP
ISL12057IUZ IC RTC/CALENDAR I2C 8-MSOP
ISL12058IUZ IC RTC/CALENDAR I2C-BUS 8-MSOP
ISL12059IBZ IC RTC/CALENDAR I2C-BUS 8-SOIC
相關代理商/技術參數
參數描述
ISL12029IVZ-T 功能描述:實時時鐘 REAL TIME CLKRTC W/ EPROM IN 14LD T RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
ISL12030 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power RTC with 50/60 Cycle AC Input, Alarms and Daylight Savings Correction
ISL12030IBZ 功能描述:實時時鐘 REAL TIME CLK W/ EEPROM 8LD RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
ISL12030IBZ-T 功能描述:實時時鐘 REAL TIME CLK W/ EEPROM 8LD RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube
ISL12032 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Power RTC with Battery Backed SRAM and 50/60 Cycle AC Input and Xtal Back-up