- 您現在的位置：買賣IC網 > PDF目錄384512 > ISD MicroTAD-16M (WINBOND ELECTRONICS CORP) Single-Chip Voice Record/Playback Device（Single-chip Durations of 16 minutes)(單片的錄音/錄音重放器(單片信息存儲持續時間16分鐘）) PDF資料下載
參數資料
| 型號： | ISD MicroTAD-16M |
| 廠商： | WINBOND ELECTRONICS CORP |
| 英文描述： | Single-Chip Voice Record/Playback Device（Single-chip Durations of 16 minutes)(單片的錄音/錄音重放器(單片信息存儲持續時間16分鐘）) |
| 中文描述： | 單芯片語音記錄/播放設備（單芯片的持續時間16分鐘）（單片的錄音/錄音重放器（單片信息存儲持續時間16分鐘）） |
| 文件頁數： | 9/28頁 |
| 文件大?。?/td> | 650K |
| 代理商： | ISD MICROTAD-16M |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ISD MicroTAD-16M
5
ISD
SERIAL PERIPHERAL INTERFACE (SPI) DESCRIPTION
The ISD MicroTAD-16M operates from an SPI serial
interface. The SPI interface operates with the fol-
lowing protocol.
The data transfer protocol assumes that the mi-
crocontroller’s SPI shift registers are clocked on
the falling edge of the SCLK. With the ISD Micro-
TAD-16M, data is clocked in on the MOSI pin on
the rising clock edge. Data is clocked out on the
MISO pin on the falling clock edge.
1.
All serial data transfers begin with the fall-
ing edge of SS pin.
2.
SS is held LOW during all serial communica-
tions and held HIGH between instructions.
3.
Data is clocked in on the rising clock edge
and data is clocked out on the falling
clock edge.
4.
Play and Record operations are initiated
by enabling the device by asserting the SS
pin LOW, shifting in an opcode and an
address field to the ISD MicroTAD-16M de-
vice (refer to the Opcode Summary on
the page 6).
5.
The opcodes and address fields are as fol-
lows: <8 control bits> and <16 address
bits>.
6.
Each operation that ends in an EOM or
Overflow will generate an interrupt, in-
cluding the Message Cueing cycles. The
Interrupt will be cleared the next time an
SPI cycle is initiated.
7.
As Interrupt data is shifted out of the ISD
MicroTAD-16M MISO pin, control and ad-
dress data is simultaneously being shifted
into the MOSI pin. Care should be taken
such that the data shifted in is compatible
with current system operation. It is possible
to read interrupt data and start a new op-
eration within the same SPI cycle.
8.
An operation begins with the RUN bit set
and ends with the RUN bit reset.
9.
All operations begin with the rising edge
of SS.
MESSAGE CUEING
Message cueing allows the user to skip through
messages, without knowing the actual physical
location of the message. This operation is used
during playback. In this mode, the messages are
skipped 1600 times faster than in normal play-
back mode. It will stop when an EOM marker is
reached. Then, the internal address counter will
point to the next message.
If you are utilizing the Message Cueing Com-
mand, you must perform the following Message
Cueing procedure to ensure proper Message
Cueing for the MicroTAD product. Failure to fol-
low this procedure may result in inaccurate Mes-
sage Cueing.
Procedure for Proper Message Cueing:
A single “dummy” STOP command must be sent
to the device before executing a Message Cue-
ing (MC) or SET Message Cueing (SET MC) In-
struction.
The “dummy” STOP instruction consists of a com-
mand with control bits set as follows:
RUN bit = 0
PLAY/RECORD bit = 0
PU bit = 1
IAB bit = 1
MC bit = 0
That is, a hex “30” is shifted into the device as a
command.
One or more MC or SET MC commands may be
executed following this command. It is not nec-
essary to repeat the “dummy” STOP command
until after a subsequent playback operation.
相關PDF資料 |
PDF描述 |
|---|---|
| ISD-T267SA | Digital Speech Processor With Multiple Supplier,Flash Memory Interface(適應多供應商器件、閃速存儲器存接口的數字語音處理器) |
| ISD-T267SC | Digital Speech Processor With Caller ID Support and Multiple Supplier Flash Memory Support(具有呼叫身份保證、多供應商閃速存儲器支持的數字語音處理器) |
| ISD-T267SP | Digital Speech Processor With Full-Duplex SpeakerPhone and Multiple Supplier Flash Memory Support(具有雙向擴音器、多供應商閃速存儲器支持的數字語音處理器) |
| ISD-T360SA | VoiceDSP Digital Speech Processor(數字語音處理器) |
| ISD1110P | SINGLE CHIP VOICE RECORD / PLAYBACK DEVICES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISDN | 制造商:TI 制造商全稱:Texas Instruments 功能描述:ISDN Basic Rate Interface Software for the HPC16400E High Performance Data Communications Microcontroller |
| ISDNRNYNG | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| ISD-NU-LINK | 制造商:Nuvoton Technology Corp 功能描述:USB DONGLE A PORTABILITY PROGR 制造商:Nuvoton Technology 功能描述:USB DONGLE A PORTABILITY PROGR |
| ISD-PRO | 制造商:Silicon Laboratories Inc 功能描述:EMBER DESKTOP PROFESSIONAL EDITION (1 SEAT) - Boxed Product (Development Kits) 制造商:Silicon Laboratories Inc 功能描述:EMBER DESKTOP PROFESSIONAL 1SEAT |
| ISD-SR3000 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。