參數資料
型號: IRU3038CS
廠商: International Rectifier
英文描述: SYNCHRONOUS PWM CONTROLLER FOR TERMINATION POWER SUPPLY APPLICATIONS
中文描述: 同步PWM控制器終止電源應用
文件頁數: 10/18頁
文件大小: 139K
代理商: IRU3038CS
10
Rev. 2.0
09/12/02
IRU3038
www.irf.com
6)
Place second pole at the ESR zero.
F
P2
= F
ESR
Check if R
8
>
If R
8
is too small, increase R
7
and start from step 2.
7)
Place second zero around the resonant frequency.
8)
Use equation (1) to calculate R
5
:
These design rules will give a crossover frequency ap-
proximately one-tenth of the switching frequency. The
higher the band width, the potentially faster the load tran-
sient speed. The gain margin will be large enough to
provide high DC-regulation accuracy (typically -5dB to -
12dB). The phase margin should be greater than 45
8
for
overall stability.
IC Quiescent Power Dissipation
Power dissipation for IC controller is a function of ap-
plied voltage, gate driver loads and switching frequency.
The IC's maximum power dissipation occurs when the
IC operating with single 12V supply voltage (Vcc=12V
and Vc
24V) at 400KHz switching frequency and maxi-
mum gate loads.
This IC's power dissipation results to an excessive tem-
perature rise and should be considered when using
IRU3038 for such an application.
Layout Consideration
The layout is very important when designing high fre-
quency switching converters. Layout will affect noise
pickup and can cause a good design to perform with
less than expected results.
Start to place the power components. Make all the con-
nections in the top layer with wide, copper filled areas.
The inductor, output capacitor and the MOSFET should
be close to each other as possible. This helps to reduce
the EMI radiated by the power traces due to the high
switching currents through them. Place input capacitor
directly to the drain of the high-side MOSFET. To reduce
the ESR, replace the single input capacitor with two par-
allel units. The feedback part of the system should be
kept away from the inductor and other noise sources
and be placed close to the IC. In multilayer PCB, use
one layer as power ground plane and have a separate
control circuit ground (analog ground), to which all sig-
nals are referenced. The goal is to localize the high cur-
rent path to a separate loop that does not interfere with
the more sensitive analog control function. These two
grounds must be connected together on the PC board
layout at a single point.
1
g
m
R
5
= V
×
R
6
OUT
- V
REF
V
REF
R
6
= 1
8
2
π ×
C
10
×
F
Z2
F
Z2
= F
LC
R
8
=
1
2
π ×
C
10
×
F
P2
相關PDF資料
PDF描述
IRU431AL LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR
IRU431ALCL3 LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR
IRU431ALCL5 LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR
IRU431L LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR
IRU431LCL3 LOW -VOLTAGE ADJUSTABLE PRECISION SHUNT REGULATOR
相關代理商/技術參數
參數描述
IRU3038CSTR 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR
IRU3039 制造商:IRF 制造商全稱:International Rectifier 功能描述:SYNCHRONOUS PWM CONTROLLER WITH OVER CURRENT PROTECTION
IRU3039CH 制造商:IRF 制造商全稱:International Rectifier 功能描述:SYNCHRONOUS PWM CONTROLLER WITH OVER CURRENT PROTECTION
IRU3039CHTR 功能描述:IC REG CTRLR BUCK PWM VM 20-MLPQ RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR)
IRU3046 制造商:IRF 制造商全稱:International Rectifier 功能描述:DUAL SYNCHRONOUS PWM CONTROLLER WITH CURRENT SHARING CIRCUITRY AND LDO CONTROLLER