參數資料
型號： IRS2540PBF
廠商： International Rectifier
英文描述： LED BUCK REGULATOR CONTROL IC
中文描述： 發光二極管降壓穩壓器控制IC
文件頁數： 8/14頁
文件大?。?/td> 456K
代理商： IRS2540PBF
IRS254(0,1)(S)PbF
www.irf.com Page 8
Watchdog Timer
During an open circuit condition, without the
watchdog timer, the HO output would remain high at
all times and the charge stored in the bootstrap
capacitor C
BOOT
would gradually discharge the
floating power supply for the high-side driver, which
would then be unable to fully switch on the upper
MOSFET causing high losses. To maintain
sufficient charge on the bootstrap capacitor, a
watchdog timer has been implemented. In the
condition where V
IFB
remains below V
IFBTH
, the HO
output will be forced low after 20 μs and the LO
output forced high. This toggling of the outputs will
last for approximately 1 μs to maintain and replenish
sufficient charge on C
BOOT
.
Fig.4 Illustration of Watchdog Timer
Bootstrap Capacitor and Diode
The bootstrap capacitor value needs to be chosen
so that it maintains sufficient charge for at least the
approximately 20 μs interval until the watchdog timer
allows the capacitor to recharge. If the capacitor
value is too small, the charge will dissipate in less
than 20 μs. The typical bootstrap capacitor is
approximately 100 nF.
The bootstrap diode should be a fast recovery or
ultrafast recovery component to maintain good
efficiency. Since the cathode of the bootstrap diode
will be switching between zero and to the high
voltage bus, the reverse recovery time of this diode
is of critical importance. For additional information
concerning the bootstrap components, refer to the
Design Tip (DT 98-2),
“Bootstrap Component
Selection For Control ICs”
at
www.irf.com
under
Design Support
Disable (ENN) Pin
The disable pin can be used for dimming and open-
circuit protection. When the ENN pin is held low, the
chip remains in a fully functional state with no
alterations to the operating environment. To disable
the control feedback and regulation, a voltage
greater than V
ENTH
(approximately 2.5 V) needs to be
applied to the ENN pin. With the chip in a disabled
state, HO output will remain low, whereas the LO
output will remain high to prevent V
S
from floating, in
addition to maintaining charge on the bootstrap
capacitor. The threshold for disabling the
IRS254(0,1) has been set to 2.5 V to enhance
immunity to any externally generated noise, or
application ground noise. This 2.5 V threshold also
makes it ideal to receive a drive signal from a local
microcontroller.
Dimming Mode
To achieve dimming, a signal with constant
frequency and set duty cycle can be fed into the
ENN pin. There is a direct linear relationship
between the average load current and duty cycle. If
the ratio is 50%, 50% of the maximum set light
output will be realized. Likewise if the ratio is 30%,
70% of the maximum set light output will be realized.
A sufficiently high frequency of the dimming signal
must be chosen to avoid flashing or “strobe light”
effect. A signal on the order of a few kHz should be
sufficient.
The minimum amount of dimming achievable (light
output approaches 0%) will be determined by the
“on” time of the HO output, when in a fully functional
regulating state. To maintain reliable dimming, it is
recommended to keep the “off” time of the enable
signal at least 10 times that of the HO “on” time. For
example, if the application is running at 75 kHz with
an input voltage of 100 V and an output voltage of
20 V, the HO “on” time will be 3.3
μ
s (one-fourth of
the period – see calculations below) according to
standard buck topology theory. This will set the
minimum “off” time of the enable signal to 33
μ
s.
V
Cycle
Duty
100
=
s
kHz
HO
V
V
V
on
in
*
out
μ
3
75
1
%
20
%
20
100
*
100
20
time
=
=
=
=
HO
LO
相關PDF資料
PDF描述
IRS2540STRPbF LED BUCK REGULATOR CONTROL IC
IRS2541PbF LED BUCK REGULATOR CONTROL IC
IRS2541SPbF LED BUCK REGULATOR CONTROL IC
IRS2541STRPbF LED BUCK REGULATOR CONTROL IC
IRSF3021 FULLY PROTECTED POWER MOSFET SWITCH(Vds(50V), Rds(on)=200mohm)
相關代理商/技術參數
參數描述
IRS2540PBF 制造商:International Rectifier 功能描述:LED Driver IC 制造商:International Rectifier 功能描述:IC, LED CURRENT REGULATOR, BUCK, DIP-8
IRS2540SPbF 功能描述:LED照明驅動器 200V HALF BRDG DRVR LED BUCK REGULATOR RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
IRS2540SPBF 制造商:International Rectifier 功能描述:LED Driver IC 制造商:International Rectifier 功能描述:IC, LED CURRENT REGULATOR, BUCK, SOIC-8
IRS2540STRPBF 功能描述:LED照明驅動器 200V Half Bridge LED Driver Buck Regulatr RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N
IRS25411 制造商:IRF 制造商全稱:International Rectifier 功能描述:LED BUCK REGULATOR CONTROL IC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*