參數資料
型號： IDT72T3685L6-7BB
廠商： IDT, Integrated Device Technology Inc
文件頁數： 27/57頁
文件大?。?/td> 0K
描述： IC FIFO 16384X36 6-7NS 208-BGA
標準包裝： 1
系列： 72T
功能： 異步，同步
存儲容量： 576K（16K x 36）
數據速率： 66MHz
訪問時間： 3.8ns
電源電壓： 2.375 V ~ 2.625 V
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 208-BGA
供應商設備封裝： 208-PBGA（17x17）
包裝： 托盤
其它名稱： 72T3685L6-7BB
33
COMMERCIAL AND INDUSTRIAL
TEMPERATURE RANGES
IDT72T3645/55/65/75/85/95/105/115/125 2.5V TeraSync
36-BIT FIFO
1K x 36, 2K x 36, 4K x 36, 8K x 36, 16K x 36, 32K x 36, 64K x 36, 128K x 36 and 256K x 36
FEBRUARY 4, 2009
Figure 8. TAP Controller State Diagram
Test-Logic
Reset
Run-Test/
Idle
1
0
Select-
DR-Scan
Select-
IR-Scan
1
Capture-IR
0
Capture-DR
0
EXit1-DR
1
Pause-DR
0
Exit2-DR
1
Update-DR
1
Exit1-IR
1
Exit2-IR
1
Update-IR
1
0
1
5907 drw13
0
Shift-DR
0
Shift-IR
0
Pause-IR
0
1
Input = TMS
0
1
Refer to the IEEE Standard Test Access Port Specification (IEEE Std.
1149.1) for the full state diagram
All state transitions within the TAP controller occur at the rising edge of the
TCLK pulse. The TMS signal level (0 or 1) determines the state progression
that occurs on each TCLK rising edge. The TAP controller takes precedence
over the FIFO memory and must be reset after power up of the device. See
TRST description for more details on TAP controller reset.
Test-Logic-ResetAlltestlogicisdisabledinthiscontrollerstateenablingthe
normaloperationoftheIC.TheTAPcontrollerstatemachineisdesignedinsuch
awaythat,nomatterwhattheinitialstateofthecontrolleris,theTest-Logic-Reset
state can be entered by holding TMS at high and pulsing TCK five times. This
is the reason why the Test Reset (
TRST) pin is optional.
Run-Test-Idle In this controller state, the test logic in the IC is active only if
certaininstructionsarepresent.Forexample,ifaninstructionactivatestheself
test, then it will be executed when the controller enters this state. The test logic
in the IC is idles otherwise.
Select-DR-Scan This is a controller state where the decision to enter the
Data Path or the Select-IR-Scan state is made.
Select-IR-Scan This is a controller state where the decision to enter the
InstructionPathismade.TheControllercanreturntotheTest-Logic-Resetstate
other wise.
Capture-IR In this controller state, the shift register bank in the Instruction
Register parallel loads a pattern of fixed values on the rising edge of TCK. The
last two significant bits are always required to be “01”.
Shift-IR In this controller state, the instruction register gets connected
betweenTDIandTDO,andthecapturedpatterngetsshiftedoneachrisingedge
ofTCK.TheinstructionavailableontheTDIpinisalsoshiftedintotheinstruction
register.
Exit1-IR ThisisacontrollerstatewhereadecisiontoentereitherthePause-
IR state or Update-IR state is made.
Pause-IR This state is provided in order to allow the shifting of instruction
register to be temporarily halted.
Exit2-DR This is a controller state where a decision to enter either the Shift-
IR state or Update-IR state is made.
Update-IR In this controller state, the instruction in the instruction register is
latched in to the latch bank of the Instruction Register on every falling edge of
TCK. This instruction also becomes the current instruction once it is latched.
Capture-DR In this controller state, the data is parallel loaded in to the data
registers selected by the current instruction on the rising edge of TCK.
Shift-DR, Exit1-DR, Pause-DR, Exit2-DR and Update-DR These
controller states are similar to the Shift-IR, Exit1-IR, Pause-IR, Exit2-IR and
Update-IR states in the Instruction path.
NOTES:
1. Five consecutive TCK cycles with TMS = 1 will reset the TAP.
2. TAP controller does not automatically reset upon power-up. The user must provide a reset to the TAP controller (either by
TRST or TMS).
3. TAP controller must be reset before normal FIFO operations can begin.
相關PDF資料
PDF描述
MS27468T13F35P EDR CONN RCPT 22POS JAM NUT W/PINS
ICL3217ECBZ IC 5DRVR/3RCVR RS232 3V 24-SOIC
MS27468T13F35P CONN RCPT 22POS JAM NUT W/PINS
IDT72T1885L6-7BB IC FIFO 32768X18 6-7NS 144BGA
ICL3217ECAZ IC 5DRVR/3RCVR RS232 3V 24-SSOP
相關代理商/技術參數
參數描述
IDT72T3695L4-4BB 功能描述:IC FIFO 32768X36 4-4NS 208BGA RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:72T 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72T3695L5BB 功能描述:IC FIFO 32768X36 5NS 208BGA RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:72T 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72T3695L5BBI 功能描述:IC FIFO 32768X36 5NS 208BGA RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:72T 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72T3695L6-7BB 功能描述:IC FIFO 32768X36 6-7NS 208BGA RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:72T 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
IDT72T40108L10BB 功能描述:IC FIFO DDR/SDR 10NS 208-BGA RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:72T 標準包裝:15 系列:74F 功能:異步 存儲容量:256（64 x 4） 數據速率:- 訪問時間:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:24-DIP（0.300"，7.62mm） 供應商設備封裝:24-PDIP 包裝:管件 其它名稱:74F433
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*