參數資料
型號： ICX414AL
廠商： Sony Corporation
英文描述： Diagonal 8mm Progressive Scan CCD Solid-state Image Sensor with Square Pixel for EIA B/W Cameras
中文描述： 對角線毫米逐行掃描CCD固體狀態與廣場像素圖像傳感器的環境影響評估/黑白攝像機
文件頁數： 12/30頁
文件大?。?/td> 278K
代理商： ICX414AL
– 12 –
ICX414AL
Image Sensor Characteristics Measurement Method
Measurement conditions
(1) In the following measurements, the substrate voltage is set to the value indicated on the device, and the
device drive conditions are at the typical values of the bias and clock voltage conditions.
(2) In the following measurements, spot blemishes are excluded and, unless otherwise specified, the optical
black level (OB) is used as the reference for the signal output, which is taken as the value measured at
point [
B] of the measurement system.
(3) In the following measurements, this image sensor is operated in 1/60s progressive scan mode.
Definition of standard imaging conditions
(1) Standard imaging condition
I
:
Use a pattern box (luminance: 706cd/m
2
, color temperature of 3200K halogen source) as a subject.
(Pattern for evaluation is not applicable.) Use a testing standard lens with CM500S (t = 1.0mm) as an IR
cut filter and image at F8. The luminous intensity to the sensor receiving surface at this point is defined as
the standard sensitivity testing luminous intensity.
(2) Standard imaging condition
II
:
Image a light source (color temperature of 3200K) with a uniformity of brightness within 2% at all angles.
Use a testing standard lens with CM500S (t = 1.0mm) as an IR cut filter. The luminous intensity is adjusted
to the value indicated in each testing item by the lens diaphragm.
1. Sensitivity
Set to standard imaging condition
I
. After setting the electronic shutter mode with a shutter speed of
1/250s, measure the signal voltage (Vs) at the center of the screen, and substitute the value into the
following formula.
S = Vs
×
250
2. Saturation signal
Set to standard imaging condition
II
. After adjusting the luminous intensity to 10 times the intensity with the
average value of the signal output, 150mV, measure the minimum value of the signal output.
3. Smear
Set to standard imaging condition
II
. With the lens diaphragm at F5.6 to F8, first adjust the luminous intensity
to 500 times the intensity with the average value of signal output, 150mV. Then after the readout clock is
stopped and the charge drain is executed by the electronic shutter at the respective H blankings, measure
the maximum value (VSm [mV]) of the signal output and substitute the value into the following formula.
Sm = 20
×
log VSm
×
×
1
500
150
10
4. Video signal shading
Set to standard imaging condition
II
. With the lens diaphragm at F5.6 to F8, adjust the luminous intensity so
that the average value of the signal output is 150mV. Then measure the maximum (Vmax [mV]) and
minimum (Vmin [mV]) values of the signal output and substitute the values into the following formula.
SH = (Vmax – Vmin)/150
×
100 [%]
30
1
相關PDF資料
PDF描述
ICX418AKL Diagonal 8mm (Type 1/2) CCD Image Sensor for NTSC Color Video Cameras
ICX418ALL Diagonal 8mm (Type 1/2) CCD Image Sensor for EIA B/W Video Cameras
ICX419AKL Diagonal 8mm (Type 1/2) CCD Image Sensor for PAL Color Video Cameras
ICX419ALL Diagonal 8mm (Type 1/2) CCD Image Sensor for CCIR B/W Video Cameras
ICX422 Diagonal 11mm (Type 2/3) CCD Image Sensor for EIA B/W Video Cameras
相關代理商/技術參數
參數描述
ICX414AQ 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Diagonal 8mm(Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for Color Cameras
ICX415AL 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Diagonal 8mm(Type 1/2) Progressive Scan CCD Solid-state Image Sensor with Square Pixel forCCIR B/W Cameras
ICX415ALE 制造商:Sony Batteries 功能描述:
ICX415AQ 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Diagonal 8mm(Type 1/2) Progressive Scan CCD ImageSensor with Square Pixel for Color Cameras
ICX418AKB 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CCD IMAGE SENSOR Diag. 8mm (Type 1/2) CCD Image Sensor for NTSC Color Video Cameras (20 pages 195K Rev. E01907)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*