- 您現在的位置：買賣IC網 > PDF目錄1997 > ICS8430AYI-61LF (IDT, Integrated Device Technology Inc)IC SYNTHESIZER LVPECL 32-LQFP PDF資料下載
參數資料
| 型號： | ICS8430AYI-61LF |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 12/20頁 |
| 文件大小： | 0K |
| 描述： | IC SYNTHESIZER LVPECL 32-LQFP |
| 標準包裝： | 1 |
| 系列： | HiPerClockS™ |
| 類型： | 頻率合成器 |
| PLL： | 帶旁路 |
| 輸入： | 晶體 |
| 輸出： | LVPECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:2 |
| 差分 - 輸入:輸出： | 無/是 |
| 頻率 - 最大： | 500MHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-LQFP |
| 供應商設備封裝： | 32-TQFP（7x7） |
| 包裝： | 標準包裝 |
| 其它名稱： | 800-1924-6 |
8430AYI-61
www.icst.com/products/hiperclocks.html
REV. C JUNE 2, 2006
2
Integrated
Circuit
Systems, Inc.
ICS8430I-61
500MHZ, CRYSTAL-TO-3.3V, 2.5V DIFFERENTIAL
LVPECL FREQUENCY SYNTHESIZER
specific default state that will automatically occur during
power-up. The TEST output is LOW when operating in the
parallel input mode. The relationship between the VCO fre-
quency, the crystal frequency and the M divider is defined as
follows:
The M value and the required values of M0 through M8 are
shown in Table 3B, Programmable VCO Frequency Function
Table. Valid M values for which the PLL will achieve lock for a
16MHz reference are defined as 250
≤ M ≤ 500.The frequency
out is defined as follows:
Serial operation occurs when nP_LOAD is HIGH and S_LOAD
is LOW. The shift register is loaded by sampling the S_DATA
bits with the rising edge of S_CLOCK. The contents of the
shift register are loaded into the M divider and N output di-
vider when S_LOAD transitions from LOW-to-HIGH. The M
divide and N output divide values are latched on the HIGH-to-
LOW transition of S_LOAD. If S_LOAD is held HIGH, data at
the S_DATA input is passed directly to the M divider and N
output divider on each rising edge of S_CLOCK. The serial
mode can be used to program the M and N bits and test bits
T1 and T0. The internal registers T0 and T1 determine the state
of the TEST output as follows:
FIGURE 1. PARALLEL & SERIAL LOAD OPERATIONS
Time
SERIAL LOADING
PARALLEL LOADING
t
S
t
H
t
S
t
H
t
S
M, N
T1
T0
N2
N1
N0
M8
M7
M6
M5
M4
M3
M2
M1
M0
S_CLOCK
S_DATA
S_LOAD
nP_LOAD
M0:M8, N0:N2
nP_LOAD
S_LOAD
FUNCTIONAL DESCRIPTION
NOTE: The functional description that follows describes op-
eration using a 16MHz crystal. Valid PLL loop divider values
for different crystal or input frequencies are defined in the In-
put Frequency Characteristics, Table 5, NOTE 1.
The ICS8430I-61 features a fully integrated PLL and there-
fore requires no external components for setting the loop band-
width. A parallel-resonant, fundamental crystal is used as the
input to the on-chip oscillator. The output of the oscillator is
divided by 16 prior to the phase detector. With a 16MHz crys-
tal, this provides a 1MHz reference frequency. The VCO of
the PLL operates over a range of 250MHz to 500MHz. The
output of the M divider is also applied to the phase detector.
The phase detector and the M divider force the VCO output
frequency to be M times the reference frequency by adjusting
the VCO control voltage. Note that for some values of M (ei-
ther too high or too low), the PLL will not achieve lock. The
output of the VCO is scaled by a divider prior to being sent to
each of the LVPECL output buffers. The divider provides a
50% output duty cycle.
The programmable features of the ICS8430I-61 support two
input modes and to program the M divider and N output di-
vider. The two input operational modes are parallel and serial.
Figure 1 shows the timing diagram for each mode. In parallel
mode, the nP_LOAD input is initially LOW. The data on inputs
M0 through M8 and N0 through N2 is passed directly to the M
divider and N output divider. On the LOW-to-HIGH transition
of the nP_LOAD input, the data is latched and the M divider
remains loaded until the next LOW transition on nP_LOAD or
until a serial event occurs. As a result, the M and N bits can
be hard-wired to set the M divider and N output divider to a
T1
T0
TEST Output
0
LOW
0
1
S_Data, Shift Register Input
1
0
Output of M divider
1
CMOS Fout
16
M
fVCO =
fxtal x
N
fout =
fVCO
=
16
M
fxtal x
N
相關PDF資料 |
PDF描述 |
|---|---|
| ICS8430S07AKILF | IC CLK GENERATOR PLL 32VFQFN |
| ICS8430S10BYI-02LF | IC CLK GENERATOR PLL 48TQFP |
| ICS84314AY-02LFT | IC SYNTHESIZER 700MHZ 32-LQFP |
| ICS843156AKILF | IC CLK GENERATOR 32VFQFP |
| ICS843156AKLF | IC CLK GENERATOR 32VFQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS8430AYI-61LFT | 功能描述:IC SYNTHESIZER LVPECL 32-LQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:* 標準包裝:1,000 系列:- 類型:時鐘/頻率合成器，扇出分配 PLL:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 除法器/乘法器:- 電源電壓:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:56-VFQFN 裸露焊盤 供應商設備封裝:56-VFQFP-EP（8x8） 包裝:帶卷 (TR) 其它名稱:844S012AKI-01LFT |
| ICS8430AYI-61T | 制造商:ICS 制造商全稱:ICS 功能描述:500MHZ, CRYSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER |
| ICS8430BI-71L | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, LOW JITTER, CRYSTAL INTERFACE / LVCMOS-TO-3.3V LVPECL FREQUENCY SYNTHESIZER |
| ICS8430BY-71 | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, LOW JITTER, CRYSTAL INTERFACE / LVCMOS-TO-3.3V LVPECL FREQUENCY SYNTHESIZER |
| ICS8430BY71L | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, LOW JITTER, CRYSTAL INTERFACE / LVCMOS-TO-3.3V LVPECL FREQUENCY SYNTHESIZER |
發布緊急采購，3分鐘左右您將得到回復。