參數(shù)資料
型號: I5108E
廠商: WINBOND ELECTRONICS CORP
元件分類: 音頻合成
英文描述: SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
中文描述: 480 SEC, SPEECH SYNTHESIZER WITH RCDG, PDSO28
封裝: 8 X 13.40 MM, PLASTIC, TSOP1-28
文件頁數(shù): 12/88頁
文件大?。?/td> 612K
代理商: I5108E
ISD5100 – SERIES
- 12 -
Digital data is sent and received serially over the I
2
C interface. The data is serial-to-parallel converted
and stored in one of two alternating (commutating) 64-bit shift registers. When an input register is full,
it becomes the register that is parallel written into the array. The prior write register becomes the new
serial input register. A mechanism is built-in to ensure there is always a register available for storing
new data.
Storing data in the memory is accomplished by accepting data one byte at a time and issuing an
acknowledge. If data is coming in faster than it can be written, the chip issues an acknowledge to the
host microcontroller, but holds SCL LOW until it is ready to accept more data. (See section 7.5.2 for
details).
The read mode is the opposite of the write mode. Data is read into one of two 64-bit registers from the
array and serially sent to the I
2
C interface. (See
section 7.5.3
for details).
7.3. O
PERATIONAL
M
ODES
D
ESCRIPTION
7.3.1. I
2
C Interface
To use more than four ISD5100 Series devices in an application requires some external switching of
the I
2
C interface.
I
2
C interface
Important note:
The rest of this data sheet will assume that the reader is familiar with the
I
2
C serial interface. Additional information on I
2
C may be found in
section 10
on page 72 of
this document. If you are not familiar with this serial protocol, please read this section to
familiarize yourself with it. A large amount of additional information on I
2
C can also be
found on the Philips web page at
http://www.philips.com/
.
I
2
C Slave Address
The ISD5100 Series have 7-bit slave address of <100 00xy> where x and y are equal to the state,
respectively, of the external address pins A1 and A0. Because all data bytes are required to be 8
bits, the LSB of the address byte is the Read/Write selection bit that tells the slave whether to transmit
or receive data. Therefore, there are 8 possible slave addresses for the ISD5100-Series. These
are:
相關PDF資料
PDF描述
I5108EI SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108S SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108SI SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108X SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5116E SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
相關代理商/技術參數(shù)
參數(shù)描述
I5108EI 制造商:WINBOND 制造商全稱:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108S 制造商:WINBOND 制造商全稱:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108SI 制造商:WINBOND 制造商全稱:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I5108X 制造商:WINBOND 制造商全稱:Winbond 功能描述:SINGLE-CHIP 1 TO 16 MINUTES DURATION VOICE RECORD/PLAYBACK DEVICES WITH DIGITAL STORAGE CAPABILITY
I510E11 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:R88S S Power Unit Manual DX CODE ZA