- 您現在的位置：買賣IC網 > PDF目錄384461 > HY27SF161G2M-TPMB (Hynix Semiconductor Inc.) 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory PDF資料下載
參數資料
| 型號： | HY27SF161G2M-TPMB |
| 廠商： | Hynix Semiconductor Inc. |
| 英文描述： | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| 中文描述： | 1Gbit的（128Mx8bit / 64Mx16bit）NAND閃存 |
| 文件頁數： | 16/48頁 |
| 文件大小： | 476K |
| 代理商： | HY27SF161G2M-TPMB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
Rev 0.7 / Apr. 2005
16
Preliminary
HY27UF(08/ 16)1G2M Series
HY27SF(08/ 16)1G2M Series
1Gbit (128Mx8bit / 64Mx16bit) NAND Flash
4. OTHER FEATURES
4.1 Data Protection.
The device is designed to offer protection from any involuntary program/erase during power-transitions. An internal
voltage detector disables all functions whenever Vcc is below about 1.1V(1.8V device), 2V(3.3V device). WP# pin pro-
vides hardware protection and is recommended to be kept at VIL during power-up and power-down. A recovery time
of minimum 10us is required before internal circuit gets ready for any command sequences as shown in Figure 26. The
two-step command sequence for program/erase provides additional software protection.
4.2 Ready/ Busy.
The device has a Ready/Busy output that provides method of indicating the completion of a page program, erase,
copy-back, cache program and random read completion. The RB# pin is normally high and goes to low when the
device is busy (after a reset, read, program, erase operation). It returns to high when the internal controller has fin-
ished the operation. The pin is an open-drain driver thereby allowing two or more RB# outputs to be Or-tied. Because
pull-up resistor value is related to tr(RB#) and current drain during busy (Ibusy), an appropriate value can be obtained
with the following reference chart (Fig.27). Its value can be determined by the following guidance.
4.3 Power-On Auto-Read
The device is designed to offer automatic reading of the first page without command and address input sequence dur-
ing power-on.
An internal voltage detector enables auto-page read functions when Vcc reaches about 1.8V. PRE pin controls activa-
tion of auto- page read function. Auto-page read function is enabled only when PRE pin is logic high state. Serial
access may be done after power-on without latency. Power-On Auto Read mode is available only on 3.3V device
(HY27UF(08/16)1G2M).
相關PDF資料 |
PDF描述 |
|---|---|
| HY27SF161G2M-TPMS | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VEP | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VES | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VIB | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VIP | 1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HY27SF161G2M-TPMP | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-TPMS | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VCB | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VCP | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
| HY27SF161G2M-VCS | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:1Gbit (128Mx8bit / 64Mx16bit) NAND Flash Memory |
發布緊急采購，3分鐘左右您將得到回復。