- 您現在的位置：買賣IC網 > PDF目錄5550 > HFA1412IPZ (Intersil)IC BUFFER QUAD 350MHZ LP 14-PDIP PDF資料下載
參數資料
| 型號： | HFA1412IPZ |
| 廠商： | Intersil |
| 文件頁數： | 10/13頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BUFFER QUAD 350MHZ LP 14-PDIP |
| 標準包裝： | 250 |
| 放大器類型： | 緩沖器 |
| 電路數： | 4 |
| 轉換速率： | 1700 V/µs |
| -3db帶寬： | 350MHz |
| 電流 - 輸入偏壓： | 1µA |
| 電壓 - 輸入偏移： | 2000µV |
| 電流 - 電源： | 5.9mA |
| 電流 - 輸出 / 通道： | 55mA |
| 電壓 - 電源，單路/雙路(±)： | 9 V ~ 11 V，±4.5 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 14-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-PDIP |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁
6
FN4152.4
January 23, 2006
PC Board Layout
This amplifier’s frequency response depends greatly on the
care taken in designing the PC board (PCB). The use of low
inductance components such as chip resistors and chip
capacitors is strongly recommended, while a solid
ground plane is a must!
Attention should be given to decoupling the power supplies.
A large value (10
F) tantalum in parallel with a small value
(0.1
F) chip capacitor works well in most cases.
Terminated microstrip signal lines are recommended at the
input and output of the device. Capacitance directly on the
output must be minimized, or isolated as discussed in the
next section.
An example of a good high frequency layout is the
Evaluation Board shown in Figure 3.
Driving Capacitive Loads
Capacitive loads, such as an A/D input, or an improperly
terminated transmission line will degrade the amplifier’s
phase margin resulting in frequency response peaking and
possible oscillations. In most cases, the oscillation can be
avoided by placing a resistor (RS) in series with the output
prior to the capacitance.
Figure 1 details starting points for the selection of this
resistor. The points on the curve indicate the RS and CL
combinations for the optimum bandwidth, stability, and
settling time, but experimental fine tuning is recommended.
Picking a point above or to the right of the curve yields an
overdamped response, while points below or left of the curve
indicate areas of underdamped performance.
RS and CL form a low pass network at the output, thus limiting
system bandwidth well below the amplifier bandwidth of
350MHz. By decreasing RS as CL increases (as illustrated in
the curves), the maximum bandwidth is obtained without
sacrificing stability. In spite of this, bandwidth decreases as
the load capacitance increases. For example, at AV =+2,
RS =22, CL = 100pF, the overall bandwidth is 125MHz, and
bandwidth drops to 100MHz at RS =12, CL = 220pF.
Evaluation Board
The performance of the HFA1412 may be evaluated using
the HA5025 Evaluation Board, slightly modified as follows:
1. Remove the four feedback resistors, and leave the
connections open.
2. a. For AV = +1 evaluation, remove the gain setting
resistors (R1), and leave pins 2, 6, 9, and 13 floating.
b. For AV = +2, replace the gain setting resistors (R1) with
0
resistors to GND.
3. Replace the 0
series output resistors with 50.
The modified schematic for amplifier 1, and the board layout
are shown in Figures 2 and 3.
To order evaluation boards (part number HA5025EVAL),
please contact your local sales office.
0
100
200
300
400
0
10
20
30
40
50
LOAD CAPACITANCE (pF)
SERI
ES
OUTP
U
T
RESI
ST
AN
CE
(
)
AV =+1
AV =+2
150
250
350
50
FIGURE 1. RECOMMENDED SERIES RESISTOR vs LOAD
CAPACITANCE
+5V
10
F0.1F
50
GND
R1
-5V
0.1
F
10
F
50
IN
OUT
∞ (AV = +1)
or 0
(A
V = +2)
1
2
3
4
5
6
7
14
13
12
11
10
9
8
NOTE: R1 =
FIGURE 2. MODIFIED EVALUATION BOARD SCHEMATIC
+
-
(NOTE)
FIGURE 3A. TOP LAYOUT
FIGURE 3B. BOTTOM LAYOUT
FIGURE 3. EVALUATION BOARD LAYOUT
HFA1412
相關PDF資料 |
PDF描述 |
|---|---|
| N3314-L303RB | CONN HEADER STKD 14POS R/A LO |
| HA7-5102-2 | IC OPAMP DUAL 8MHZ PREC 8-DIP |
| N3314-D202RB | CONN HEADER STKD 14POS R/A SH |
| MVG24-110/32DFX-BOTTLE | CONN FEMALE DISCONN INSUL 100PC |
| 81036-600203-RB | CONN HEADER 36POS STR NO LATCH |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HFA1412MJ/883 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| HFA150066-0A0 | 制造商:Laird Technologies Inc 功能描述:SPLIT CORE FOR ROUND CABLE W/WHITE CASE,BULK - Bulk 制造商:Laird Technologies Inc 功能描述:FERRITE CORE 6.6MM 350R 50 制造商:LAIRD TECHNOLOGIES / STEWARD 功能描述:HFA150066-0A0 - Pro Line: S200 |
| HFA150066-0A2 | 功能描述:EMI/RFI 抑制器及鐵氧體 274ohms 300MHz 7.05mm Inside Slot RoHS:否 制造商:Fair-Rite 產品:Ferrite Cores 阻抗:365 Ohms 容差: 最大直流電流: 最大直流電阻: 工作溫度范圍:- 55 C to + 125 C 封裝 / 箱體: 端接類型:SMD/SMT |
| HFA150068-0A2 | 功能描述:EMI/RFI 抑制器及鐵氧體 275ohms 300MHz 8.13mm Inside Slot RoHS:否 制造商:Fair-Rite 產品:Ferrite Cores 阻抗:365 Ohms 容差: 最大直流電流: 最大直流電阻: 工作溫度范圍:- 55 C to + 125 C 封裝 / 箱體: 端接類型:SMD/SMT |
| HFA15PB60 | 功能描述:整流器 600 Volt 15 Amp RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。