- 您現在的位置：買賣IC網 > PDF目錄11800 > FT245RQ-REEL (FTDI, Future Technology Devices International Ltd)IC USB TO PARALLEL FIFO 32-QFN PDF資料下載
參數資料
| 型號： | FT245RQ-REEL |
| 廠商： | FTDI, Future Technology Devices International Ltd |
| 文件頁數： | 4/37頁 |
| 文件大小： | 0K |
| 描述： | IC USB TO PARALLEL FIFO 32-QFN |
| 產品培訓模塊： | USB Introduction |
| 標準包裝： | 1 |
| 應用： | USB 至 FIFO 控制器 |
| 接口： | USB，F(xiàn)IFO，（同步/異步） |
| 電源電壓： | 1.8 V ~ 5.25 V |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-QFN 裸露焊盤（5x5） |
| 包裝： | 標準包裝 |
| 安裝類型： | 表面貼裝 |
| 產品目錄頁面： | 634 (CN2011-ZH PDF) |
| 配用： | 768-1020-ND - MOD USB PARALLEL FIFO DEV FT245R |
| 其它名稱： | 768-1012-6 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Copyright 2010 Future Technology Devices International Limited
12
Document No.: FT_000052
FT245R USB FIFO IC Datasheet Version 2.12
Clearance No.: FTDI# 39
Pin
No.
Name
Type
Description
6
D5
I/O
FIFO Data Bus Bit 5
7
D6
I/O
FIFO Data Bus Bit 6
8
D3
I/O
FIFO Data Bus Bit 3
9
PWREN# Output
Goes low after the device is configured by USB, then high during USB
suspend. Can be used to control power to external logic P-Channel logic
level MOSFET switch. Enable the interface pull-down option when using the
PWREN# pin in this way. Should be pulled to VCCIO with 10kΩ resistors.
10
RD#
Input
Enables the current FIFO data byte from D0…D7 when low. Fetched the next
FIFO data byte (if available) from the receive FIFO buffer when RD# goes
from high to low. See Section 3.5 for timing diagram.
11
WR
Input
Writes the data from byte from D0...D7 pins into the transmit FIFO buffer
when WR goes from high to low. See section 3.6 for timing diagram.
21
TXE#
Output
When high, do not write data into the FIFO. When low, data can be written
into the FIFO by strobing WR high, then low. During reset this signal pin is
tri-state. See Section 3.6 for timing diagram.
22
RXF#
Output
When high, do not read data from the FIFO. When low, there is data
available in the FIFO which can be read by strobing RD# low, then high
again. During reset this signal pin is tri-state. See Section 3.5 for timing
diagram.
If the Remote Wakeup option is enabled in the internal EEPROM, during USB
suspend mode (PWREN# = 1) RXF# becomes an input. This can be used to
wake up the USB host from suspend mode by strobing this pin low for a
minimum of 20ms which will cause the device to request a resume on the
USB bus.
Table 3.8 FIFO Interface Group (see note 3)
Notes:
1. The minimum operating voltage VCC must be +4.0V (could use VBUS=+5V) when
using the internal clock generator. Operation at +3.3V is possible using an external
crystal oscillator.
2. For details on how to use an external crystal, ceramic resonator, or oscillator with the FT245R,
please refer to Section 8.2
3. When used in Input Mode, the input pins are pulled to VCCIO via internal 200kΩ
resistors. These pins can be programmed to gently pull low during USB suspend (
PWREN# = “1”) by setting an option in the internal EEPROM.
相關PDF資料 |
PDF描述 |
|---|---|
| V48A12E500BG2 | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BF3 | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BF2 | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BF | CONVERTER MOD DC/DC 12V 500W |
| V48A12E500BL2 | CONVERTER MOD DC/DC 12V 500W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| FT245RQ-TRAY | 制造商:Future Technology Devices International (FTDI Chip) 功能描述:Single Chip USB Tray |
| FT24B3 031175 | 制造商:Comair Rotron 功能描述:FAN 120X120X25MM 24VDC |
| FT24B3-E2 | 制造商:Comair Rotron 功能描述:FAN FLIGHT II 120X120X25MM 24V |
| FT24B3-E2 | 制造商:Comair Rotron 功能描述:FAN FLIGHT II 120X120X25 24V |
| FT24C02A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Two-Wire Serial EEPROM |
發布緊急采購，3分鐘左右您將得到回復。