參數資料
型號: EL5300IUZ
廠商: Intersil
文件頁數: 4/15頁
文件大?。?/td> 0K
描述: IC VFA SLEW TRPL 700MHZ 16-QSOP
標準包裝: 97
放大器類型: 電壓反饋
電路數: 3
轉換速率: 2200 V/µs
-3db帶寬: 200MHz
電流 - 輸入偏壓: 2µA
電壓 - 輸入偏移: 1000µV
電流 - 電源: 2.5mA
電流 - 輸出 / 通道: 100mA
電壓 - 電源,單路/雙路(±): 3.5 V ~ 12 V,±1.75 V ~ 6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-SSOP(0.154",3.90mm 寬)
供應商設備封裝: 16-QSOP
包裝: 管件
12
FN7330.3
May 3, 2007
The reason for that is the very small but not zero value serial
inductance of the capacitor.
The capacitor will behave as a capacitor up to its resonance
frequency, above the resonance frequency it will behave as
an inductor.
Just 1nHy inductance serial with 1nF capacitance will have
serial resonance at:
C = 1nF, L = 1nHy, F = 159 MHz
And an other 1nHy is very easy to get together with the
inductance of traces on the pcb, and therefore you could
encounter resonances from ca 50MHz and above anywhere.
So if the amplifier has a bandwidth of a few hundred MHz,
the proper power supply by-pass could become a serious if
not difficult task.
Intuitively, you would use capacitors value 0.1F parallel
with a few F tantalum, and to cure the effect of it’s serial
resonance put a smaller one parallel to it.
The result will surprise to you, because you will get even
something worse than without the small capacitor.
What is happening there? Just look what we get:
Above its serial resonance C2* the ideal capacitance of C2 is
a short, the Tantalum capacitor for high frequencies is not
effective, the left over is C1 capacitor and L1 + L2 inductors,
we get a parallel tank circuit, which is at it’s resonance a high
impedance path and do not carry any high frequency
current, it does not work as bypass at all!
The impedance of a parallel tank circuit at resonance is
dependent from it’s Q. High Q high impedance.
The Q of a parallel tank circuit could be reduced by
bypassing it with a resistor, or adding a resistor in serial to
one of the reactive components. Since the bypassing would
short the DC supply we do have to go to add resistor in serial
to the reactive component, we will ad a resistor serial with
the inductor. (See Figure 33.)
The final power supply bypass circuit will look:
FIGURE 31.
Ci
Li
Z
F
F RES
IN
DUCTIVE
CA
P
ACITIVE
C
L
2
1
F
×
π
=
C1
1n
C3
22F
C2
0.1F
L2
L1
C1
1n
C3
22F
C2
0.1F
=
<
FIGURE 32.
C3
0.1F
L3
C1
Z
F
F RES
R3 = 3
R3 = 0
R3
2 to 3
Ω
FIGURE 33.
C1
1n
C11
22F
R10
3R3
C12
33nF
Vs+
FIGURE 34.
EL5100, EL5101, EL5300
相關PDF資料
PDF描述
TA45-A143SJ20C0 CIRCUIT BRKR THERMAL 2A 2POLE
TA45-ABNTS100C0 CIRCUIT BRKR THERMAL 10A 2POLE
0031.8518 FUSE 3.15A 250VAC 5X20 FAST
0034.1736 FUSE 100MA 250V 6.3X32 FAST GLSS
NPPC231KFXC-RC CONN FMALE 23POS .1" SMD GOLD
相關代理商/技術參數
參數描述
EL5300IUZT13 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:200MHz Slew Enhanced VFA
EL5300IUZ-T13 功能描述:高速運算放大器 EL5300IUZ TRPL 350MH SEVFAW ENABLE RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
EL5300IUZ-T7 功能描述:高速運算放大器 EL5300IUZ TRPL 350MH SEVFAW ENABLE RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
EL5302 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:400MHz Slew Enhanced VFAs
EL5302IU 功能描述:運算放大器 - 運放 400 MHz V-FB RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比(最小值):63 dB 輸入補償電壓:1 mV 輸入偏流(最大值):10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel