- 您現在的位置：買賣IC網 > PDF目錄17024 > EA-QSB-002 (Embedded Artists)BOARD QUICK START LPC2106 PDF資料下載
參數資料
| 型號： | EA-QSB-002 |
| 廠商： | Embedded Artists |
| 文件頁數： | 11/41頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD QUICK START LPC2106 |
| 標準包裝： | 1 |
| 系列： | LPC2100 |
| 類型： | MCU |
| 適用于相關產品： | LPC2106 |
| 所含物品： | 板 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁
LPC2104_2105_2106_7
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 07 — 20 June 2008
19 of 41
NXP Semiconductors
LPC2104/2105/2106
Single-chip 32-bit microcontrollers
6.14.1 Features
A 32-bit Timer/Counter with a programmable 32-bit Prescaler.
Up to four (Timer 1) and three (Timer 0) 32-bit capture channels, that can take a
snapshot of the timer value when an input signal transitions. A capture event may also
optionally generate an interrupt.
Four 32-bit match registers that allow:
– Continuous operation with optional interrupt generation on match.
– Stop timer on match with optional interrupt generation.
– Reset timer on match with optional interrupt generation.
Up to four (Timer 1) and three (Timer 0) external outputs corresponding to match
registers, with the following capabilities:
– Set LOW on match.
– Set HIGH on match.
– Toggle on match.
– Do nothing on match.
6.14.2 Features available in LPC2104/2105/2106/01 only
The LPC2104/2105/2106/01 can count external events on one of the capture inputs if the
external pulse lasts at least one half of the period of the PCLK. In this conguration,
unused capture lines can be selected as regular timer capture inputs or used as external
interrupts.
Timer can count cycles of either the peripheral clock (PCLK) or an externally supplied
clock.
When counting cycles of an externally supplied clock, only one of the timer’s capture
inputs can be selected as the timer’s clock. The rate of such a clock is limited to
PCLK
4. Duration of HIGH/LOW levels on the selected CAP input cannot be shorter
than 1
(2PCLK).
6.15 Watchdog timer
The purpose of the Watchdog is to reset the microcontroller within a reasonable amount of
time if it enters an erroneous state. When enabled, the Watchdog will generate a system
reset if the user program fails to ‘feed’ (or reload) the Watchdog within a predetermined
amount of time.
6.15.1 Features
Internally resets chip if not periodically reloaded.
Debug mode.
Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be
disabled.
Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.
Flag to indicate watchdog reset.
相關PDF資料 |
PDF描述 |
|---|---|
| GBA32DRMI | CONN EDGECARD 64POS .125 SQ WW |
| 0210490229 | CABLE JUMPER 1.25MM .254M 16POS |
| EA-EDU-009 | BOARD EDUCATION LPC2103 |
| 0210490228 | CABLE JUMPER 1.25MM .229M 16POS |
| 0210490227 | CABLE JUMPER 1.25MM .229M 16POS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EA-QSB-003 | 功能描述:開發板和工具包 - ARM LPC2129 CAN QUICKSTART BRD RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| EA-QSB-010 | 功能描述:開發板和工具包 - ARM LPC2148 USB QUICKSTART BRD RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| EA-QSB-012 | 功能描述:開發板和工具包 - ARM QUICK START BOARD LPC1343 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| EA-QSB-015 | 功能描述:開發板和工具包 - ARM QUICK START BOARD LPC11U35 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V |
| EA-QSB-016 | 制造商:Embedded Artists 功能描述:BOARD QUICK START LPC4088 |
發布緊急采購，3分鐘左右您將得到回復。