- 您現在的位置：買賣IC網 > PDF目錄1995 > DSD1792DB (Texas Instruments)IC 24BIT STEREO AUD DAC 28-SSOP PDF資料下載
參數資料
| 型號： | DSD1792DB |
| 廠商： | Texas Instruments |
| 文件頁數： | 11/57頁 |
| 文件大小： | 0K |
| 描述： | IC 24BIT STEREO AUD DAC 28-SSOP |
| 產品培訓模塊： | Data Converter Basics |
| 標準包裝： | 47 |
| 位數： | 24 |
| 數據接口： | 串行 |
| 轉換器數目： | 2 |
| 電壓電源： | 模擬和數字 |
| 功率耗散（最大）： | 335mW |
| 工作溫度： | -25°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 4 電流，單極 |
| 采樣率（每秒）： | 200k |
| 產品目錄頁面： | 902 (CN2011-ZH PDF) |
| 其它名稱： | 296-15310-5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
DSD1792
SLES067B MARCH 2003 REVISED NOVEMBER 2006
www.ti.com
19
External Digital Filter Interface and Timing
The DSD1792 supports an external digital filter interface comprising a 3- or 4-wire synchronous serial port, which allows
the use of an external digital filter. External filters include the Texas Instruments’ DF1704 and DF1706, the Pacific
Microsonics PMD200, or a programmable digital signal processor.
In the external DF mode, PLRCK (pin 4), PBCK (pin 6) and PDATA (pin 5) are defined as WDCK, the word clock; BCK,
the bit clock; and DATA, the monaural data, respectively. The external digital filter interface is selected by using the DFTH
bit of control register 20, which functions to bypass the internal digital filter of the DSD1792.
When the DFMS bit of control register 19 is set, the DSD1792 can process stereo data. In this case, DSDL (pin 1) and DSDR
(pin 2) are defined as L-channel data and R-channel data, respectively.
Detailed information for the external digital filter interface mode is provided in the APPLICATION FOR EXTERNAL
DIGITAL FILTER INTERFACE section of this data sheet.
Direct Stream Digital (DSD) Format Interface and Timing
The DSD1792 supports the DSD-format interface operation, which includes out-of-band noise filtering using an internal
analog FIR filter. The DSD-format interface consists of a 3-wire synchronous serial port, which includes DBCK (pin 3),
DSDL (pin 1), and DSDR (pin 2). DBCK is the serial bit clock. DSDL and DSDR are L-channel and R-channel DSD data
input, respectively. They are clocked into the DSD1792 on the rising edge of DBCK. PLRCK (pin 4) and PBCK (pin 6) should
be connected to GND in the DSD mode. The DSD-(DSD mode) format interface is activated by setting the DSD bit of control
register 20.
Detailed information for the DSD mode is provided in the APPLICATION FOR DSD FORMAT (DSD MODE) INTERFACE
section of this data sheet.
TDMCA Interface
The DSD1792 supports the time-division-multiplexed command and audio (TDMCA) data format to enable control of and
communication with a number of external devices over a single serial interface.
Detailed information for the TDMCA format is provided in the TDMCA Format section of this data sheet.
Serial Control Interface
The serial control interface is a 4-wire synchronous serial port, which operates asynchronously with the serial audio
interface and the system clock (SCK). The serial control interface is used to program and read the on-chip mode registers.
The control interface includes MDO (pin 13), MDI (pin 11), MC (pin 12), and MS (pin 10). MDO is the serial data output,
used to read back the values of the mode registers; MDI is the serial data input, used to program the mode registers; MC
is the bit clock, used to shift data in and out of the control port, and MS is the mode control enable, used to enable the internal
mode register access.
Register Read/Write Operation
All read/write operations for the serial control port use 16-bit data words. Figure 29 shows the control data word format.
The most significant bit is the read/write (R/W) bit. For write operations, the R/W bit must be set to 0. For read operations,
the R/W bit must be set to 1. There are seven bits, labeled IDX[6:0], that set the register index (or address) for the read
and write operations. The least significant eight bits, D[7:0], contain the data to be written to the register specified by
IDX[6:0] or to be read from, the register specified by IDX[6:0].
Figure 30 shows the functional timing diagram for writing or reading the serial control port. MS is held at a logic 1 state until
a register needs to be written or read. To start the register write or read cycle, MS is set to logic 0. Sixteen clocks are then
provided on MC, corresponding to the 16 bits of the control data word on MDI and readback data on MDO. After the eighth
clock cycle has completed, the data from the indexed-mode control register appears on MDO during the read operation.
After the sixteenth clock cycle has completed, the data is latched into the indexed-mode control register during the write
operation. To write or read subsequent data, MS must be set to 1 once.
MSB
LSB
Register Index (or Address)
Register Data
R/W
IDX6
IDX5
IDX4
IDX3
IDX2
IDX1
IDX0
D7
D6
D4
D5
D3
D2
D1
D0
Figure 29. Control Data Word Format for MDI
相關PDF資料 |
PDF描述 |
|---|---|
| EL5001IRE-T7 | IC CLOCK DRIVER 6-CHAN 20-HTSSOP |
| FT10001L6X | IC RESET TIMER 6-MICROPAK |
| FT3001MPX | IC RESET TIMER 8-MLP |
| FT7521L6X | IC RESET TIMER 7.5SEC 6MICROPAK |
| FT7522L6X | IC RESET TIMER 6-MICROPAK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSD1792DBG4 | 功能描述:音頻數/模轉換器 IC 24-Bit 192kHz Smplng Adv Stg Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| DSD1792DBR | 功能描述:音頻數/模轉換器 IC 24-Bit 192kHz Smplng Adv Stg Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| DSD1792DBRG4 | 功能描述:音頻數/模轉換器 IC 24B 192kHz Sampl Adv Segment Aud St DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
| DSD1793 | 制造商:BB 制造商全稱:BB 功能描述:24 BIT 192 KHZ SAMPLING ADVANCED SEGMENT AUDIO STEREO DIGITAL TO ANALOG CONVERTER |
| DSD1793DB | 功能描述:音頻數/模轉換器 IC 24-Bit 192kHz Smplng Adv Stg Stereo DAC RoHS:否 制造商:Texas Instruments 轉換器數量: 分辨率:16 bit 接口類型:I2S, UBS 轉換速率: 信噪比:98 dB 工作電源電壓:5 V DAC 輸出端數量:2 工作溫度范圍:- 25 C to + 85 C 電源電流:23 mA 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-32 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。