- 您現在的位置：買賣IC網 > PDF目錄97869 > DS2432P (DALLAS SEMICONDUCTOR) 1K X 1 1-WIRE SERIAL EEPROM, PDSO6 PDF資料下載
參數資料
| 型號： | DS2432P |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | Programmable ROM |
| 英文描述： | 1K X 1 1-WIRE SERIAL EEPROM, PDSO6 |
| 封裝： | 0.150 INCH, TSOC-6 |
| 文件頁數： | 24/30頁 |
| 文件大?。?/td> | 165K |
| 代理商： | DS2432P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁
PRELIMINARY
DS2432
30 of 30
AC ELECTRICAL CHARACTERISTICS
OVERDRIVE SPEED
(VPUP=2.8V to 5.25V; -40°C to +85°C)
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
NOTES
Time Slot
tSLOT
616
s
Write 1 Low Time
tLOW1
12
s
Write 0 Low Time
tLOW0
616
s
Read Low Time
tLOWR
12
s
Read Data Valid
tRDV
2s
10
Release Time
tRELEASE
0
1.5
4
s
Read Data Setup
tSU
1s
4
Recovery Time
tREC
1s
Reset High Time
tRSTH
48
s
Reset Low Time
tRSTL
48
80
s
Presence Detect High
tPDHIGH
26
s
Presence Detect Low
tPDLOW
824
s
Programming Time
tPROG
10
ms
SHA Computation Time
tCSHA
1.0
2.0
ms
9
NOTES:
1. All voltages are referenced to ground.
2. VPUP = external pull-up voltage.
3. Input load is to ground.
4. Read data setup time refers to the time the host must pull the 1-Wire bus low to read a bit. Data is
guaranteed to be valid within 1 s of this falling edge.
5. Capacitance on the data pin could be 800 pF when power is first applied. If a 5 k
resistor is used to
pull up the data line to VPUP, 5 s after power has been applied the parasite capacitance will not affect
normal communications.
6. The reset low time (tRSTL) should be restricted to a maximum of 960 s, to allow interrupt signaling,
otherwise, it could mask or conceal interrupt pulses.
7. VIH is a function of the external pull-up resistor and VPUP.
8. Under certain low voltage conditions VILMAX may have to be reduced to as much as 0.5V to always
guarantee a Presence Pulse. VIL is a function of VPUP and the reset low time.
9. During write operations to the EEPROM and during the computation of Message Authentication
Codes (MAC) the voltage on the 1-Wire bus must not fall below 2.8V. The computation of a MAC
takes maximum 2.0 ms. Copying scratchpad data to the EEPROM takes max. 10 ms.
10. The optimal sampling point for the master is as close as possible to the end time of the tRDV period
without exceeding tRDV. For the case of a Read-one time slot, this maximizes the amount of time for
the pull-up resistor to recover the line to a high level. For a Read-zero time slot it ensures that a read
will occur before the fastest 1-Wire device releases the line (tRELEASE = 0).
相關PDF資料 |
PDF描述 |
|---|---|
| DS2433 | 512 X 8 1-WIRE SERIAL EEPROM, PBCY3 |
| DS2433X | 4K X 1 1-WIRE SERIAL EEPROM, UUC2 |
| DS2433S | 512 X 8 1-WIRE SERIAL EEPROM, PDSO8 |
| DS2434S | SPECIALTY MEMORY CIRCUIT, PDSO16 |
| DS2434 | SPECIALTY MEMORY CIRCUIT, PBCY3 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS2432P R | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1Kb Protected 1-Wire EEPROM with SHA-1 Engine |
| DS2432P T | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1Kb Protected 1-Wire EEPROM with SHA-1 Engine |
| DS2432P/T&R | 功能描述:電可擦除可編程只讀存儲器 RoHS:否 制造商:Atmel 存儲容量:2 Kbit 組織:256 B x 8 數據保留:100 yr 最大時鐘頻率:1000 KHz 最大工作電流:6 uA 工作電源電壓:1.7 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 |
| DS2432P+ | 制造商:Maxim Integrated Products 功能描述:EEPROM SERL-1WIRE 1KBIT 4PAGES X 256 3.3V/5V 6PIN TSOC - Rail/Tube 制造商:Maxim Integrated Products 功能描述:1-WIRE 1KB EE W/SHA-1 TSOC PBFREE 制造商:Maxim Integrated Products 功能描述:EEPROM 1KB 1-WIRE 6TSOC 制造商:Maxim Integrated Products 功能描述:EEPROM, 1KB, 1-WIRE, 6TSOC 制造商:Maxim Integrated Products 功能描述:OPTOCOUPLERS; Memory Size:1Kbit; Memory Configuration:256 x 4; Supply Voltage Min:2.8V; Supply Voltage Max:5.25V; Memory Case Style:TSOC; No. of Pins:6; IC Interface Type:Serial; Operating Temperature Min:-40C ;RoHS Compliant: Yes |
| DS2432P+R | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:1Kb Protected 1-Wire EEPROM with SHA-1 Engine |
發布緊急采購，3分鐘左右您將得到回復。