- 您現在的位置：買賣IC網 > PDF目錄9766 > DS21349Q+T&R (Maxim Integrated Products)IC LIU T1/J1 3.3V 28-PLCC PDF資料下載
參數資料
| 型號： | DS21349Q+T&R |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 11/35頁 |
| 文件大小： | 0K |
| 描述： | IC LIU T1/J1 3.3V 28-PLCC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 500 |
| 類型： | 線路接口裝置（LIU） |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-LCC（J 形引線） |
| 供應商設備封裝： | 28-PLCC（11.51x11.51） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁
DS21349
19 of 35
9. SOFTWARE MODE
The DS21349 operates in software mode when the MODE1 pin is pulled high. In software mode, a
microprocessor controls the device and reads its status through the serial port, which provides access to
the internal registers. The host processor can completely configure the device as well as get diagnostics
and status reports through the serial port. In NRZ mode, bipolar violation insertions and logic error
insertions are controlled by the BPV and INSLER pins. Similarly, the recovered clock, data, and BPV
detection are available only at output pins. All other mode settings and diagnostic information are
available through the serial port. Figure 9-1 and Figure 9-2 show the serial port data structure. The
registers are accessible through a 16-bit word composed of an 8-bit command and address byte and a
subsequent 8-bit data byte. Software mode allows control of the output timing. The CLKE pin determines
when SDO is valid relative to SCLK and when receive data is valid relative to RCLK.
9.1
Interrupt Handling
In software mode, the DS21349 provides a latched interrupt output pin. When enabled, a change in any of
the status register bits generates an interrupt. When an interrupt occurs, the INT output pin is driven low.
The INT output pin structure is an open-drain only. Each device that shares the INT line requires an
external pullup resistor. The interrupt is cleared when the interrupt condition no longer exists, and a 1 is
written to the appropriate bit in the interrupt mask register. Leaving a 1 in any of the bits in the interrupt
mask register masks that interrupt. Clearing that bit re-enables the interrupt.
Table 9-A. CLKE Pin Selection
CLKE PIN
OUTPUT
OUTPUT UPDATED ON
RPOS
RNEG
RDATA
Falling RCLK
LOW
SDO
Rising SCLK
RPOS
RNEG
RDATA
Rising RCLK
HIGH
SDO
Falling SCLK
相關PDF資料 |
PDF描述 |
|---|---|
| MS27468E25B35SB | CONN RCPT 128POS JAM NUT W/SCKT |
| V300B48M150BL3 | CONVERTER MOD DC/DC 48V 150W |
| V300B48M150BL2 | CONVERTER MOD DC/DC 48V 150W |
| V300B48M150B3 | CONVERTER MOD DC/DC 48V 150W |
| V300B48M150B2 | CONVERTER MOD DC/DC 48V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS21352 | 制造商:Maxim Integrated Products 功能描述: |
| DS21352DK | 功能描述:網絡開發工具 T1/J1 Single Chip Tranceiver Kit RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| DS21352G | 功能描述:網絡控制器與處理器 IC T1 Single Chip Transceivers RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21352GN | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| DS21352L | 功能描述:網絡控制器與處理器 IC T1 Single Chip Transceivers RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。