- 您現在的位置：買賣IC網 > PDF目錄9172 > DS1848B-050+ (Maxim Integrated Products)IC RES/MEM TEMP 50/10K 16-BGA PDF資料下載
參數資料
| 型號： | DS1848B-050+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 8/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC RES/MEM TEMP 50/10K 16-BGA |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 810 |
| 接片： | 256 |
| 電阻（歐姆）： | 10k，50k |
| 電路數： | 2 |
| 溫度系數： | 標準值 850 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C（設備位址） |
| 電源電壓： | 3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 95°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-LBGA，CSPBGA |
| 供應商設備封裝： | 16-CSBGA（4x4） |
| 包裝： | 托盤 |
DS1848
16 of 17
NOTES:
1) All voltages are referenced to ground.
2) Inputs SDA = SCL = WP = Vcc. A0, A1, and A2 must be tied to VCC or GND.
3) Valid at 25°C only.
4) Absolute linearity is the difference of measured value from expected value at DAC position.
Expected value is a straight line from measured minimum position to measured maximum position.
5) Relative linearity the deviation of an LSB DAC setting change vs. the expected LSB change.
Expected LSB change is the slope of the straight line from measured minimum position to measured
maximum position.
6) A fast mode device can be used in a standard mode system, but the requirement tSU:DAT > 250ns must
then be met. This will automatically be the case if the device does not stretch the LOW period of the
SCL signal. If such a device does stretch the LOW period of the SCL signal, it must output the next
data bit to the SDA line tRMAX + tSU:DAT = 1000ns + 250ns = 1250ns before the SCL line is released.
7) After this period, the first clock pulse is generated.
8) The maximum t
HD:DAT has only to be met if the device does not stretch the LOW period (tLOW) of the
SCL signal.
9) A device must internally provide a hold time of at least 300ns for the SDA signal (referred to the
VI
H MIN of the SCL signal) in order to bridge the undefined region of the falling edge of SCL.
10) C
B — total capacitance of one bus line in picofarads, timing referenced to 0.9VCC and 0.1VCC.
11) EEPROM write begins after a stop condition occurs.
12) The temperature coefficient varies with resistor position from 650ppm/°C at position FFh to
1000ppm/°C at 00h (for the 50k resistor), or 1500ppm/°C at 00h (for the 10k resistor). See the graphs
below. The tempco can be significantly reduced by using the resistor calibration values. When doing
so, the average tempco over the entire temperature range is between 200ppm/°C (for the lower
positions) and 10ppm/°C (higher positions). Refer to the Programming the Look-Up Table section of
the data sheet.
13) I/O pins of fast mode devices must not obstruct the SDA and SCL lines if VCC is switched off.
14) Refer to Programming the Look-Up Table section of the data sheet for calibration.
15) Address input A1 passes Latch-up per JEDEC 78 class I. All other pins pass class II.
ORDERING INFORMATION
ORDERING
PACKAGE
OPERATING
VERSION
TEMPCO vs. RESISTANCE
10K RESISTOR
500
600
700
800
900
1000
1100
1200
1300
1400
1500
0
2000
4000
6000
8000
10000
RESISTANCE (OHMS)
PPM/
°C
TEMPCO vs. RESISTANCE
50K RESISTOR
500
600
700
800
900
1000
1100
0
10000
20000
30000
40000
50000
RESISTANCE (OHMS)
PPM/
°C
相關PDF資料 |
PDF描述 |
|---|---|
| VI-2W2-MY-F4 | CONVERTER MOD DC/DC 15V 50W |
| DS1848B-010+ | IC RES/MEM TEMP 10/10K 16-BGA |
| VI-2W2-MY-F2 | CONVERTER MOD DC/DC 15V 50W |
| V72A5H300BL3 | CONVERTER MOD DC/DC 5V 300W |
| DS1859B-050+T&R/B | IC RES DUAL TEMP-CTRL 16-CSBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1848B-050/S+ | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
| DS1848B-050/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1848B-050+ | 功能描述:數字電位計 IC Dual Temp Controlled NV Variable Resistor RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1848B-050+T&R | 制造商:Maxim Integrated Products 功能描述: 制造商:Maxim Integrated Products 功能描述:DGTL POTENTIOMETER 256POS 10KOHM/50KOHM DUAL 16CSBGA - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC RES/MEM TEMP 50/10K 16-BGA 制造商:Maxim Integrated Products 功能描述:Digital Potentiometer ICs Dual Temp Controlled NV Variable Resistor |
| DS1848B-050+T&R/S | 制造商:Maxim Integrated Products 功能描述:- Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。