- 您現在的位置：買賣IC網 > PDF目錄295504 > DS1845X-010 (DALLAS SEMICONDUCTOR) 10K DIGITAL POTENTIOMETER, 2-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, UUC14 PDF資料下載
參數資料
| 型號： | DS1845X-010 |
| 廠商： | DALLAS SEMICONDUCTOR |
| 元件分類： | 數字電位計 |
| 英文描述： | 10K DIGITAL POTENTIOMETER, 2-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, UUC14 |
| 封裝： | FCP-14 |
| 文件頁數： | 6/13頁 |
| 文件大小： | 98K |
| 代理商： | DS1845X-010 |
DS1845
2 of 13
DS1845 BLOCK DIAGRAM Figure 1
Up to eight DS1845s can be installed on a single 2-wire bus. Access to an individual device is achieved
by using a device address that is determined by the logic levels of address pins A0 though A2.
Additionally, the DS1845 will operate from 3 volt or 5 volt supplies.
Three package options are
available: Flip Chip Package, 16-ball STPBGA and 14-pin TSSOP.
PIN DESCRIPTIONS
VCC - Power Supply Terminal. The DS1845 will support supply voltages ranging from +2.7 to +5.5 volts.
GND - Ground Terminal.
SDA - 2-wire serial data interface. The serial data pin is for serial data transfer to and from the DS1845.
The pin is open drain and may be wire-ORed with other open drain or open collector interfaces.
SCL - 2-wire serial clock interface. The serial clock input is used to clock data into the DS1845 on rising
edges and clock data out on falling edges.
WP - Write Protect. Write Protect must be connected to GND before either the data in memory or
potentiometer wiper settings may be changed. Write Protect is pulled high internally and must be either
left open or connected to VCC if write protection is desired.
A0, A1, A2 - Address Inputs. These input pins specify the address of the device when used in a multi-
dropped configuration. Up to eight individual DS1845s may be addressed on a single 2-wire bus.
VCC
GND
SDA
SCL
WP
A0
A1
A2
H0
W0
L0
H1
W1
L1
248 BYTES
EEPROM
MEMORY
6 RESERVED
BYTES
1 BYTE WIPER
SETTING
POT 0
1 BYTE WIPER
SETTING
POT 1
CONTROL
DATA
POTENTIOMETER 0
2-WIRE
INTERFACE
POTENTIOMETER 1
100
Position
Pot
256
Position
Pot
相關PDF資料 |
PDF描述 |
|---|---|
| DS1845X-100 | 100K DIGITAL POTENTIOMETER, 2-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, UUC14 |
| DS1866N | DIGITAL POTENTIOMETER, 3-WIRE SERIAL CONTROL INTERFACE, 64 POSITIONS, PDIP8 |
| DS1867-100-IND | 100K DIGITAL POTENTIOMETER, 3-WIRE SERIAL CONTROL INTERFACE, 256 POSITIONS, PDIP14 |
| DS2009D-65 | 512 X 9 OTHER FIFO, 65 ns, PDIP28 |
| DS500008-12 | 8-BIT, 12 MHz, MICROCONTROLLER, PDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1845X-010/T&R | 制造商:Maxim Integrated Products 功能描述:DUAL NV POT AND MEM BUMP T&R - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC POT/MEM DUAL NV 10K 14-FCP |
| DS1845X-010/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1845X-050 | 制造商:DALLAS 制造商全稱:Dallas Semiconductor 功能描述:Dual NV Potentiometer and Memory |
| DS1845X-050/T&R | 制造商:Maxim Integrated Products 功能描述:DUAL NV POT & MEM BUMP 10K/50K T&R - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:IC POT/MEM DUAL NV 50K 14-FCP |
| DS1845X-050/T&R | 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。