- 您現在的位置：買賣IC網 > PDF目錄1913 > DS1841N+ (Maxim Integrated Products)IC RES LOG NV I2C 5.5V 10-TDFN PDF資料下載
參數資料
| 型號： | DS1841N+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/17頁 |
| 文件大小： | 0K |
| 描述： | IC RES LOG NV I2C 5.5V 10-TDFN |
| 標準包裝： | 368 |
| 接片： | 128 |
| 電阻（歐姆）： | 22k |
| 電路數： | 1 |
| 溫度系數： | 標準值 250 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 100°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-TDFN-EP（3x3） |
| 包裝： | 管件 |
DS1841
Temperature-Controlled, NV, I2C,
Logarithmic Resistor
10
______________________________________________________________________________________
Memory Description
The DS1841’s internal memory consists of both volatile
and NV registers that are organized into eight byte
rows. Three control registers as well as specialized
data registers are used to control the wiper and drive
the LUT.
Register 00h: Initial Value Register (IVR)
FACTORY DEFAULT (IVR)
00h
MEMORY TYPE
NV
MEMORY TYPE
Volatile
00h
IVR
Bit 7
Bit 0
If
SEE bit = 0, an I2C READ retrieves the IVR value and an I2C WRITE sets the wiper position in volatile memory and
updates IVR in NV memory with this new value. If
SEE bit = 1, an I2C READ retrieves the WR value and an I2C WRITE
sets the wiper position (volatile) and the IVR value is not modified. During power-up, IVR’s value is used to set the wiper
position.
Register 02h: Control Register 0 (CR0)
FACTORY DEFAULT
00h
MEMORY TYPE
Volatile
02h
SEE
Reserved
Bit 7
Bit 0
Bit 7
SEE Controls IVR and WR functionality, as well as the memory type for Control Register 1.
0 = (Default) Issuing an I2C READ of the value in address 00h retrieves the IVR value. Issuing an I2C
WRITE to address 00h sets both the wiper’s position (volatile) and the IVR value (nonvolatile) to the
same value. Writes to Control Register 1 (03h) are stored in shadowed SRAM and EEPROM.
1 = Issuing an I2C READ of the value in address 00h retrieves the WR value. Issuing an I2C WRITE to
address 00h only sets the wiper’s position (volatile). The IVR value is not modified. Writes to Control
Register 1 (03h) are stored in shadowed SRAM only.
Bits 6 to 0
Reserved.
Control Register 0 determines how the wiper position values (volatile and NV versions) are set, as well as how writes to
Control Register 1 are stored.
The IVR is located at memory address 00h and is implemented as EEPROM shadowed SRAM. This register can be
visualized as an SRAM byte (the WR portion) in parallel with an EEPROM byte (the IVR portion). The operation of the
register is controlled by the Shadow EEPROM (
SEE) bit in Control Register 0, address 02h, bit 7. When the SEE bit = 0
(default), data written to memory address 00h by I2C actually gets stored in both SRAM (WR) and EEPROM (IVR). When
SEE = 1, only the SRAM (WR) is written to the new value. The EEPROM byte (IVR) continues to store the last value
written to it when
SEE was 0. Reading memory address 00h reads the value stored in WR. The SEE bit is volatile and its
power-up default state is 0.
Register Descriptions
相關PDF資料 |
PDF描述 |
|---|---|
| DS1844S-100/T&R | IC POT DIG QUAD 100K 20-SOIC |
| DS1845E-100/T&R | IC POT/MEM DUAL NV 100K 14-TSSOP |
| DS1846E-010+T&R | IC NV TRI-POT MEM MON 20TSSOP |
| DS1847E-010/T&R | IC RES TEMP-CNTRL 10/10K 14TSSOP |
| DS1848B-C10+ | IC RES/MEM TEMP 10/10K 16-CSBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1841N+ | 功能描述:數字電位計 IC Temp-Cntrlld NV I2C Logarithmic Resistor RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1841N+T&R | 制造商:Maxim Integrated Products 功能描述:TEMP-CNTRLD, NV, I2C, LOGARITHMIC RES - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC RES LOG NV I2C 10-TDFN |
| DS1841N+T&R | 功能描述:數字電位計 IC Temp-Cntrlld NV I2C Logarithmic Resistor RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel |
| DS1841T+ | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Temperature-Controlled, NV, I2C, Logarithmic Resistor |
| DS1841T+T&R | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:Temperature-Controlled, NV, I2C, Logarithmic Resistor |
發布緊急采購，3分鐘左右您將得到回復。