- 您現在的位置：買賣IC網 > PDF目錄1993 > DS1371U+C01 (Maxim Integrated Products)IC BINARY COUNTER 32-BIT 8-USOP PDF資料下載
參數資料
| 型號： | DS1371U+C01 |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BINARY COUNTER 32-BIT 8-USOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 50 |
| 類型： | 二進制計數器 |
| 特點： | 警報器，方波輸出，監視計時器 |
| 時間格式： | 二進制 |
| 數據格式： | 二進制 |
| 接口： | I²C，2 線串口 |
| 電源電壓： | 1.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 管件 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
DS1371
10 of 15
Special Purpose Registers
The DS1371 has two additional registers (07h–08h) that control the WD/
ALM counter, square-wave
output, and interrupts.
Control Register (07h)
Bit #
7
6
5
4
3
2
1
0
Name
EOSC
WACE
WD/
ALM
0
INTCN
RS2
RS1
AIE
Default
0
1
0
Bit 7: Enable Oscillator (
EOSC). When set to logic 0, the oscillator is started. When set to logic 1, the
oscillator is stopped. When this bit is set to a logic 1, the oscillator is stopped and the DS1371 is placed
into a low-power standby mode (IDDR). This bit is clear (logic 0) when power is first applied.
Bit 6: WD/
ALM Counter Enable (WACE). When set to logic 1, the WD/ALM counter is enabled.
When set to logic 0, the WD/
ALM counter is disabled, and the 24-bits can be used as general-purpose
RAM. This bit is clear (logic 0) when power is first applied.
Bit 5: WD/
ALM Counter Select (WD/ALM). When set to logic 0, the counter decrements every second
until it reaches 0 and is then reloaded and restarted. When set to logic 1, the WD/
ALM counter
decrements every 1/4096 of a second (approximately every 244μs) until it reaches 0, sets the AF bit in the
status register, and stops. If any of the WD/
ALM counter registers are read or written, or a rising edge on
the WDS pin occurs before the counter reaches 0, the counter is reloaded and restarted. This bit is clear
(logic 0) when power is first applied.
Bit 3: Interrupt Control (INTCN). This bit controls the SQW/
INT signal. When the INTCN bit is set to
logic 0, a square wave is output on the SQW/
INT pin whose frequency is defined by bits RS2 and RS1.
The oscillator must also be enabled for the square wave to be output. When the INTCN bit is set to logic
1, then this permits the alarm flag bit in the status register to assert SQW/
INT (provided that the alarm is
also enabled). The alarm flag is always set, regardless of the state of the INTCN bit. The INTCN bit is set
to logic 0 when power is first applied.
Bits 2 and 1: Rate Select 1 and 2 (RS2 and RS1). These bits control the frequency of the square-wave
output when the square wave has been enabled. Table 3 shows the square-wave frequencies that can be
selected with the RS bits. These bits are both set (logic 1) when power is first applied.
Bit 0: Alarm Interrupt Enable (AIE). When set to logic 1, this bit permits the AF bit in the status
register to assert SQW/
INT (when INTCN = 1). When set to logic 0 or INTCN is set to logic 0, the AF bit
does not initiate the SQW/
INT signal. If the WD/ALM bit is set to a logic 1 and the AF flag is set, writing
AIE to a 0 does not truncate the 250ms pulse on the SQW/
INT pin. The AIE bit is at logic 0 when power
is first applied.
Table 3. SQW/
INT Operating Modes
WACE
WD/
ALM
INTCN
AIE
RS2
RS1
SQW/
INT OUTPUT
X
0
X
0
1Hz
X
0
X
0
1
4.096kHz
X
0
X
1
0
8.192kHz
X
0
X
1
32.768kHz
1
0
1
X
Alarm
1
X
WD
相關PDF資料 |
PDF描述 |
|---|---|
| DS1372U+T&R | IC BINARY COUNTER 32-BIT 8-USOP |
| DS1374C-3# | IC RTC I2C W/CHARGER 16-SOIC |
| DS1375T+ | IC RTC SERIAL W/ALARM 6-TDFN |
| DS1384FP-12+ | IC CTRLR RTC WDOG 120NS 44-MQFP |
| DS1386P-8-120+ | IC TIMEKEEPER RAM 64K 34-PCM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1372 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:I2C, 32-Bit, Binary Counter Clock with 64-Bit ID |
| DS1372U+ | 功能描述:實時時鐘 I2C 32 bit Binary Counter w/64 Bit ID RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1372U+T&R | 制造商:Maxim Integrated Products 功能描述:RTC W/SERIAL NUMBER - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC BINARY COUNTER 32-BIT 8-USOP |
| DS1372U+T&R | 功能描述:實時時鐘 I2C 32 bit Binary Counter w/64 Bit ID RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1374 | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:I2C, 32-Bit Binary Counter Watchdog RTC with Trickle Charger and Reset Input/Output |
發布緊急采購，3分鐘左右您將得到回復。