- 您現在的位置：買賣IC網 > PDF目錄17031 > DC1500A-B (Linear Technology)BOARD SAR ADC LTC2392-16 PDF資料下載
參數資料
| 型號： | DC1500A-B |
| 廠商： | Linear Technology |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD SAR ADC LTC2392-16 |
| 軟件下載： | QuikEval II System |
| 設計資源： | DC1500A Design File DC1500A Schematic |
| 標準包裝： | 1 |
| ADC 的數量： | 1 |
| 位數： | 16 |
| 采樣率（每秒）： | 500k |
| 數據接口： | 串行，并聯 |
| 輸入范圍： | ±4.096 V |
| 在以下條件下的電源（標準）： | 110mW @ 500kSPS |
| 工作溫度： | 0°C ~ 70°C |
| 已用 IC / 零件： | LTC2392-16 |
| 已供物品： | 板 |
| 相關產品： | DC718C-ND - DEMO QUIKEVAL-II DATA LT6350IMS8#TRPBF-ND - IC DIFF CONVERT/ADC DRIVER 8MSOP LT6350IMS8#PBF-ND - IC DIFF CONVERT/ADC DRIVER 8MSOP LT6350IDD#TRPBF-ND - IC DIFF CONVERT/ADC DRIVER 8-DFN LT6350IDD#PBF-ND - IC DIFF CONVERT/ADC DRIVER 8-DFN LT6350HMS8#TRPBF-ND - IC DIFF CONVERT/ADC DRIVER 8MSOP LT6350HMS8#PBF-ND - IC DIFF CONVERT/ADC DRIVER 8MSOP LT6350HDD#TRPBF-ND - IC DIFF CONVERT/ADC DRIVER 8-DFN LT6350HDD#PBF-ND - IC DIFF CONVERT/ADC DRIVER 8-DFN LT6350CMS8#TRPBF-ND - IC DIFF CONVERT/ADC DRIVER 8MSOP 更多... |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
LTC2392-16
16
239216fa
applications inFormation
down. The data from that conversion can be read after PD
= low is applied. In this mode power consumption drops
to a typical value of 175W from 110mW. This mode can
be used if the LTC2392-16 is inactive for a long period of
timeandtheuserwantstominimizethepowerdissipation.
Recovery from Power Shutdown Mode
Once the PD pin is returned to a low level, ending the
power shutdown request, the internal circuitry will begin
to power up. If the internal reference is used, the 2.6kΩ
output impedance with the 1F bypass capacitor on the
REFIN/REFOUT pins will be the main time constant for
the power-on recovery time. If an external reference is
used, typically allow 5ms for recovery before initiating a
new conversion.
Power Dissipation vs Sampling Frequency
The power dissipation of the LTC2392-16 will decrease
as the sampling frequency is reduced when nap mode is
activated. See Figure 7. In nap mode, a portion of the cir-
cuitry on the LTC2392-16 is turned off after a conversion
has been completed. Increasing the time allowed between
conversions lowers the average power.
TIMING AND CONTROL
The LTC2392-16 conversion is controlled by CNVST. A
falling edge on CNVST will start a conversion. CS and RD
control the digital interface on the LTC2392-16. When
either CS or RD is high, the digital outputs are high
impedance.
CNVST Timing
The LTC2392-16 conversion is controlled by CNVST. A
falling edge on CNVST will start a conversion. Once a
conversion has been initiated, it cannot be restarted until
the conversion is complete. For optimum performance
CNVST should be a clean low jitter signal. Converter status
is indicated by the BUSY output which remains high while
the conversion is in progress. To ensure no errors occur
in the digitized results return the rising edge either within
40ns from the start of the conversion or wait until after
the conversion has been completed. The CNVST timing
needed to take advantage of the reduced power mode of
operation is described in the Nap Mode section.
Internal Conversion Clock
The LTC2392-16 has an internal clock that is trimmed
to achieve a maximum conversion time of 1300ns. No
external adjustments are required and with a maximum
acquisition time of 685ns, a throughput performance of
500ksps is guaranteed.
DIGITAL INTERFACE
The LTC2392-16 allows both parallel and serial digital
interfaces.TheflexibleOVPsupplyallowstheLTC2392-16
to communicate with any digital logic operating between
1.8V and 5V, including 2.5V and 3.3V systems.
Figure 7. Power Dissipation of the LTC2392-16
Decreases with Decreasing Sampling Frequency
SAMPLING FREQUENCY (kHz)
10
POWER
SUPPL
YCURRENT
(mA)
20
30
5
15
25
0.1
10
100
1000
239216 G15
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| STD17W-Y | WIRE & CABLE MARKERS |
| DC1500A-A | BOARD SAR ADC LTC2393-16 |
| STD17W-V | WIRE & CABLE MARKERS |
| MLG1005S47NJ | INDUCTOR MULTILAYER 47NH 0402 |
| STD17W-D | WIRE & CABLE MARKERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1500A-C | 功能描述:BOARD SAR ADC LTC2391-16 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| DC1500B2 PK2 | 制造商:Duracell 功能描述:Battery, Rechargeable, Nickel Metal Hydride, AA cell, 2 pk, 1.2 V |
| DC1500B4 PK4 | 制造商:Duracell 功能描述:Battery, Rechargeable, Nickel Metal Hydride, AA cell, 4 PK, 1.2 V |
| DC1500B4N | 制造商:Duracell 功能描述:BATTERY, RECHARGEABLE, NIMH, 2.45AH; Battery Size Code:AA; Battery Capacity:2.45Ah; Battery Voltage:1.2V; Battery Technology:Nickel Metal Hydride; External Diameter:14.5mm; External Height:49.5mm; Weight:28g; Battery NEDA Code:1.2H1 |
| DC1500B4N005 | 制造商:Duracell 功能描述:AA NiMH Rechargeable Batteries - 4 pack |
發布緊急采購，3分鐘左右您將得到回復。