- 您現在的位置：買賣IC網 > PDF目錄17031 > DC1500A-A (Linear Technology)BOARD SAR ADC LTC2393-16 PDF資料下載
參數資料
| 型號： | DC1500A-A |
| 廠商： | Linear Technology |
| 文件頁數： | 7/24頁 |
| 文件大小： | 0K |
| 描述： | BOARD SAR ADC LTC2393-16 |
| 軟件下載： | QuikEval II System |
| 設計資源： | DC1500A Design File DC1500A Schematic |
| 標準包裝： | 1 |
| ADC 的數量： | 1 |
| 位數： | 16 |
| 采樣率（每秒）： | 1M |
| 數據接口： | 串行，并聯 |
| 輸入范圍： | ±4.096 V |
| 在以下條件下的電源（標準）： | 140mW @ 1MSPS |
| 工作溫度： | 0°C ~ 70°C |
| 已用 IC / 零件： | LTC2393-16 |
| 已供物品： | 板 |
| 相關產品： | DC718C-ND - DEMO QUIKEVAL-II DATA LTC2393IUK-16#TRPBF-ND - IC ADC 16BIT SER/PAR 1M 48-QFN LTC2393CUK-16#TRPBF-ND - IC ADC 16BIT SER/PAR 1M 48-QFN LTC2393ILX-16#PBF-ND - IC ADC 16BIT SER/PAR 1M 48-LQFP LTC2393IUK-16#PBF-ND - IC ADC 16BIT SER/PAR 1M 48-QFN LTC2393HLX-16#PBF-ND - IC ADC 16BIT SER/PAR 1M 48-LQFP LTC2393CUK-16#PBF-ND - IC ADC 16BIT SER/PAR 1M 48-QFN LTC2393CLX-16#PBF-ND - IC ADC 16BIT SER/PAR 1M 48-LQFP |
LTC2393-16
15
239316fa
APPLICATIONS INFORMATION
will finish and then the device will power down. The data
from that conversion can be read after PD = low is applied.
In this mode power consumption drops to a typical value
of 175μW from 140mW. This mode can be used if the
LTC2393-16 is inactive for a long period of time and the
user wants to minimize the power dissipation.
Recovery from Power Shutdown Mode
Once the PD pin is returned to a low level, ending the
power shutdown request, the internal circuitry will begin
to power up. If the internal reference is used, the 2.6kΩ
output impedance with the 1μF bypass capacitor on the
REFIN/REFOUT pins will be the main time constant for
the power-on recovery time. If an external reference is
used, typically allow 5ms for recovery before initiating a
new conversion.
Power Dissipation vs Sampling Frequency
The power dissipation of the LTC2393-16 will decrease
as the sampling frequency is reduced when nap mode
is activated. See Figure 7. In nap mode, a portion of the
circuitry on the LTC2393-16 is turned off after a conversion
has been completed. Increasing the time allowed between
conversions lowers the average power.
TIMING AND CONTROL
The LTC2393-16 conversion is controlled by CNVST. A
falling edge on CNVST will start a conversion. CS and RD
control the digital interface on the LTC2393-16. When
either CS or RD is high, the digital outputs are high
impedance.
CNVST Timing
The LTC2393-16 conversion is controlled by CNVST. A
falling edge on CNVST will start a conversion. Once a
conversion has been initiated, it cannot be restarted until
the conversion is complete. For optimum performance
CNVST should be a clean low jitter signal. Converter status
is indicated by the BUSY output which remains high while
the conversion is in progress. To ensure no errors occur
in the digitized results return the rising edge either within
40ns from the start of the conversion or wait until after
the conversion has been completed. The CNVST timing
needed to take advantage of the reduced power mode of
operation is described in the Nap Mode section.
Internal Conversion Clock
The LTC2393-16 has an internal clock that is trimmed
to achieve a maximum conversion time of 600ns. No
external adjustments are required and with a maximum
acquisition time of 385ns, a throughput performance of
1Msps is guaranteed.
DIGITAL INTERFACE
The LTC2393-16 allows both parallel and serial digital
interfaces. The flexible OVP supply allows the LTC2393-16
to communicate with any digital logic operating between
1.8V and 5V, including 2.5V and 3.3V systems.
Figure 7. Power Dissipation of the LTC2393-16
Decreases with Decreasing Sampling Frequency
SAMPLING FREQUENCY (kHz)
10
POWER
SUPPL
Y
CURRENT
(mA)
20
30
5
15
25
0.1
10
100
1000
239316 G15
0
1
相關PDF資料 |
PDF描述 |
|---|---|
| STD17W-V | WIRE & CABLE MARKERS |
| MLG1005S47NJ | INDUCTOR MULTILAYER 47NH 0402 |
| STD17W-D | WIRE & CABLE MARKERS |
| STD17W-J | WIRE & CABLE MARKERS |
| STD17W-6 | WIRE & CABLE MARKERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1500A-A | 制造商:Linear Technology 功能描述:LTC2393-16 W/ LT6350 OPTIMIZED DRIVER 5 |
| DC1500A-B | 功能描述:BOARD SAR ADC LTC2392-16 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| DC1500A-C | 功能描述:BOARD SAR ADC LTC2391-16 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| DC1500B2 PK2 | 制造商:Duracell 功能描述:Battery, Rechargeable, Nickel Metal Hydride, AA cell, 2 pk, 1.2 V |
| DC1500B4 PK4 | 制造商:Duracell 功能描述:Battery, Rechargeable, Nickel Metal Hydride, AA cell, 4 PK, 1.2 V |
發布緊急采購，3分鐘左右您將得到回復。