- 您現在的位置：買賣IC網 > PDF目錄374178 > CSR13B565MD (KEMET Corporation) TANTALUM HERMETICALLY SEALED / AXIAL PDF資料下載
參數資料
| 型號： | CSR13B565MD |
| 廠商： | KEMET Corporation |
| 英文描述： | TANTALUM HERMETICALLY SEALED / AXIAL |
| 中文描述： | 鉭密封/軸流 |
| 文件頁數： | 76/84頁 |
| 文件大小： | 590K |
| 代理商： | CSR13B565MD |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁當前第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Capacitance typically changes with temperature
according to the curve of Figure 2.
6. DISSIPATION FACTOR (DF)
DF is measured at 120 Hz and 25° C with up to 1 volt
rms applied. Note that, in either operation, peak AC plus
DC bias must not exceed either rated voltage (normally
polarized) or 15% of rated voltage in the reverse direction
at 25°C. Measurement circuits are of high impedance,
however, and under these conditions 1 volt rms may be
applied even to 6 volt capacitors (23% peak reversal) with-
out a DC bias. DC bias is thus normally not used, except
when rated voltage is below 6 volts and the AC signal level
exceeds 0.3 vrms. However, MIL-C-39003 provides for up
to 2.2 volts DC.
Dissipation Factor (DF) is a useful low-frequency
measure of the resistive component in capacitors. It is the
ratio of the unavoidable resistance to the capacitive reac-
tance, usually expressed in percent. DF increases with
temperature above +25° C and may also increase at lower
temperatures. Unfortunately, one general limit for DF can-
not be specified for all capacitance/voltage combinations,
nor can response to temperature be simply stated.
Catalogs for the respective series list DF limits under var-
ious conditions.
Dissipation factor increases with increasing frequen-
cy as would be expected from the decreasing capacitive
reactance. DF is not a very useful parameter above about
1 kHz. The DF of larger capacitance values increases
more rapidly than that of smaller ratings. Figure 3 shows
typical effect of frequency on DF.
DC bias causes a small reduction in capacitance, up
to about 2% when full rated voltage is applied, as bias. DF
is also reduced by the presence of DC bias. Rated voltage
may cause a decrease in DF of about 0.2% (e.g., a
decrease from 3.6 to 3.4% DF).
ESR
x
c
DF is defined as
and is also referred to occa-
sionally, as tan d or “l(fā)oss tangent.” The “Quality
Factor,” Q, is the reciprocal of DF (DF is not expressed in
percent in this calculation). Another expression, rarely
used, is the “power factor,” or
while DF is ctn u.
.Power factor is cos u,
7. DC LEAKAGE (DCL)
DC leakage is affected by voltage to a much larger
extent, and this effect can frequently be used to advantage
in circuits where only very low leakage currents can be tol-
erated. Typical response of DCL to applied voltage is illus-
trated in Figure 4.
DC leakage current (DCL) increases with increasing
temperature according to the typical curve of Figure 5.
Leakage current is measured at a rated voltage
through +85°C and may also be measured at +125°C with
2/3 of rated voltage applied.
8. RATED VOLTAGE
This term refers to the maximum continuous DC
working voltage permissible at temperatures of +85° C or
below. The lower operating temperature is specified as
-55° C. Operation above +85° C is permissible, with
reduced working voltage. Typical working voltage reduc-
tion is to 2/3 of rated voltage at +125° C.
ESR
Z
KEMET
APPLICATION NOTES FOR TANTALUM CAPACITORS
76
KEMET Electronics Corporation, P.O. Box 5928, Greenville, S.C. 29606 (864) 963-6300
+20
+10
0
-10
-20
C
-80
-60 -40 -20
0
+20 +40 +60 +80 +100 +120
Operating Temperature
°
C
Figure 2.
Typical Effect of Temperature upon Capacitance
1.0
10.0
20.0
M
100
1K
10K
Frequency - Hertz
Figure 3.
Normal Effect of Frequency upon
Dissipation Factor
M
10.0
1.0
0.1
Operating Temperature –C
-60 -40 -20
0
+20 +40 +60 +80 +100 +125
Reference 1.0
at + 25
°
C
M
Percentage of Rated Voltage
Typical Range of DC Leakage as
a Function of Applied Voltage
100 110
100
90
80
80
70
70
60
60
50
50
40
40
30
30
20
20
10
10
0
0
0.0001
0.01
0.1
1.0
1.0
Figure 4.
Figure 5.
Typical Effect of Temperature
upon DC Leakage Current
M
90
0.1
0.01
相關PDF資料 |
PDF描述 |
|---|---|
| CSR13B565MM | TANTALUM HERMETICALLY SEALED / AXIAL |
| CSR13B565MP | TANTALUM HERMETICALLY SEALED / AXIAL |
| CSR13B565MR | TANTALUM HERMETICALLY SEALED / AXIAL |
| CSR13B565MS | TANTALUM HERMETICALLY SEALED / AXIAL |
| CSR21B564JR | TANTALUM HERMETICALLY SEALED / AXIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CSR13B565MM | 制造商:KEMET 制造商全稱:Kemet Corporation 功能描述:TANTALUM HERMETICALLY SEALED |
| CSR13B565MP | 制造商:KEMET 制造商全稱:Kemet Corporation 功能描述:TANTALUM HERMETICALLY SEALED |
| CSR13B565MR | 制造商:KEMET 制造商全稱:Kemet Corporation 功能描述:TANTALUM HERMETICALLY SEALED |
| CSR13B565MS | 制造商:KEMET 制造商全稱:Kemet Corporation 功能描述:TANTALUM HERMETICALLY SEALED |
| CSR13B566JC | 制造商:KEMET Corporation 功能描述:LOADED FOR CROSS REF. ONLY MIL PN: M39003/01-7009 - Bulk 制造商:Vishay Sprague 功能描述:LOADED FOR CROSS REF. ONLY MIL PN: M39003/01-7009 |
發布緊急采購，3分鐘左右您將得到回復。