- 您現在的位置：買賣IC網 > PDF目錄374169 > CS5207-2 (ZF Electronics Corporation) 7A, 1.5V Fixed Linear Regulator PDF資料下載
參數資料
| 型號： | CS5207-2 |
| 廠商： | ZF Electronics Corporation |
| 英文描述： | 7A, 1.5V Fixed Linear Regulator |
| 中文描述： | 第7A，1.5V的固定線性穩壓器 |
| 文件頁數： | 4/5頁 |
| 文件大?。?/td> | 128K |
| 代理商： | CS5207-2 |
4
Since the CS5207-2 is a three terminal regulator, it is not
possible to provide true remote load sensing. Load regula-
tion is limited by the resistance of the conductors connect-
ing the regulator to the load. For best results the fixed reg-
ulators should be connected as shown in Figure 2.
Figure 2. Conductor parasitic resistance effects can be minimized with
the above grounding scheme for fixed output regulators.
The CS5207-2 includes thermal shutdown and safe operat-
ing area circuitry to protect the device. High power regu-
lators such as these usually operate at high junction tem-
peratures so it is important to calculate the power dissipa-
tion and junction temperatures accurately to ensure that an
adequate heat sink is used.
The case is connected to V
OUT
on the CS5207-2, electrical
isolation may be required for some applications. Thermal
compound should always be used with high current regu-
lators such as these.
The thermal characteristics of an IC depend on the follow-
ing four factors:
1. Maximum Ambient Temperature T
A
(C)
2. Power dissipation P
D
(Watts)
3. Maximum junction temperature T
J
(C)
4. Thermal resistance junction to ambient R
Q
JA
(C/W)
These four are related by the equation
T
J
= T
A
+ P
D
′
R
Q
JA
(1)
The maximum ambient temperature and the power dissi-
pation are determined by the design while the maximum
junction temperature and the thermal resistance depend
on the manufacturer and the package type.
The maximum power dissipation for a regulator is:
P
D(max)
={V
IN(max)
DV
OUT(min)
}I
OUT(max)
+V
IN(max)
I
Q
(2)
where
V
IN(max)
is the maximum input voltage,
V
OUT(min)
is the minimum output voltage,
I
OUT(max)
is the maximum output current, for the application
I
Q
is the maximum quiescent current at I
OUT
(max).
A heat sink effectively increases the surface area of the
package to improve the flow of heat away from the IC and
into the surrounding air.
Each material in the heat flow path between the IC and the
outside environment has a thermal resistance. Like series
electrical resistances, these resistances are summed to
determine R
Q
JA
, the total thermal resistance between the
junction and the surrounding air.
1. Thermal Resistance of the junction to case, R
Q
JC
(C/W)
2. Thermal Resistance of the case to Heat Sink, R
Q
CS
(C/W)
3. Thermal Resistance of the Heat Sink to the ambient air,
R
Q
SA
(C/W)
These are connected by the equation:
R
Q
JA
= R
Q
JC
+ R
Q
CS
+ R
Q
SA
(3)
The value for R
JA
is calculated using equation (3) and the
result can be substituted in equation (1).
R
JC
is 1.6C/Watt for the CS5207-2. For a high current
regulator such as the CS5207-2 the majority of the heat is
generated in the power transistor section. The value for
R
Q
SA
depends on the heat sink type, while R
Q
CS
depends
on factors such as package type, heat sink interface (is an
insulator and thermal grease used), and the contact area
between the heat sink and the package. Once these calcula-
tions are complete, the maximum permissible value of
R
Q
JA
can be calculated and the proper heat sink selected.
For further discussion on heat sink selection, see applica-
tion note òThermal Management for Linear Regulators.ó
Calculating Power Dissipation and Heat Sink Requirements
V
OUT
R
C
V
IN
conductor parasitic
resistance
CS5207-2
V
IN
Gnd
R
LOAD
Output Voltage Sensing
Applications Information: continued
C
相關PDF資料 |
PDF描述 |
|---|---|
| CS5207-3GDP3 | 7A, 3.3V Fixed Linear Regulator |
| CS5207-3GDPR3 | 7A, 3.3V Fixed Linear Regulator |
| CS5207-3GT3 | 7A Adjustable Linear Regulator |
| CS5207-3 | 7A, 3.3V Fixed Linear Regulator |
| CS5207A-1 | Circular Connector; MIL SPEC:MIL-C-26482, Series I, Solder; Body Material:Aluminum; Series:PT08; Number of Contacts:26; Connector Shell Size:16; Connecting Termination:Solder; Circular Shell Style:Right Angle Plug |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS5207-2/D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:7A， 1.5V Fixed Linear Regulator |
| CS5207-2GT3 | 功能描述:IC REG LDO 1.5V 7A TO220AB RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式和可調式 輸出電壓:3.3V，1.25 V ~ 5.7 V 輸入電壓:4.5 V ~ 7 V 電壓 - 壓降（標準）:1.1V @ 1A 穩壓器數量:2 電流 - 輸出:1A 電流 - 限制（最?。?1A 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-252-5，DPak（4 引線 + 接片），TO-252AD 供應商設備封裝:PPAK 包裝:管件 其它名稱:497-3576-5 |
| CS5207-2T3 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Positive Fixed Voltage Regulator |
| CS5207-3 | 制造商:CHERRY 制造商全稱:CHERRY 功能描述:7A, 3.3V Fixed Linear Regulator |
| CS5207-3/D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:7A， 3.3V Fixed Linear Regulator |
發布緊急采購，3分鐘左右您將得到回復。