參數資料
型號: CDB4382A
廠商: Cirrus Logic Inc
文件頁數: 19/50頁
文件大?。?/td> 0K
描述: BOARD EVAL FOR CS4382A DAC
標準包裝: 1
DAC 的數量: 8
位數: 24
采樣率(每秒): 192k
數據接口: 串行
DAC 型: 電壓
工作溫度: -40°C ~ 85°C
已供物品:
已用 IC / 零件: CS4382A
產品目錄頁面: 757 (CN2011-ZH PDF)
相關產品: CS4382A-DQZR-ND - IC DAC 8CH 114DB 192KHZ 48-LQFP
CS4382A-DQZ-ND - IC DAC 8CH 114DB 192KHZ 48-LQFP
CS4382A-CQZR-ND - IC DAC 8CH 114DB 192KHZ 48-LQFP
598-1061-ND - IC DAC 8CH 114DB 192KHZ 48LQFP
其它名稱: 598-1524
26
DS618F2
CS4382A
4.8
Direct Stream Digital (DSD) Mode
In Stand-alone Mode, DSD operation is selected by holding DSD_EN(LRCK) high and applying the DSD
data and clocks to the appropriate pins. The M[2:0] pins set the expected DSD rate and MCLK ratio.
In Control Port Mode, the FM bits set the device into DSD Mode (DSD_EN pin is not required to be held
high). The DIF register then controls the expected DSD rate and MCLK ratio.
During DSD operation, the PCM related pins should either be tied low or remain active with clocks (except
LRCK in Stand-alone Mode). When the DSD related pins are not being used, they should either be tied static
low or remain active with clocks (except M3 in Stand-alone Mode).
4.9
Grounding and Power Supply Arrangements
As with any high-resolution converter, the CS4382A requires careful attention to power supply and ground-
ing arrangements if its potential performance is to be realized. The Typical Connection Diagram shows the
recommended power arrangements, with VA, VD, VLC, and VLS connected to clean supplies. If the ground
planes are split between digital ground and analog ground, the GND pins of the CS4382A should be con-
nected to the analog ground plane.
All signals, especially clocks, should be kept away from the FILT+ and VQ pins in order to avoid unwanted
coupling into the DAC.
4.9.1
Capacitor Placement
Decoupling capacitors should be placed as close to the DAC as possible, with the low-value ceramic ca-
pacitor being the closest. To further minimize impedance, these capacitors should be located on the same
layer as the DAC. If desired, all supply pins with similar voltage ratings may be connected to the same
supply, but a decoupling capacitor should still be placed on each supply pin.
Notes:
All decoupling capacitors should be referenced to analog ground.
The CDB4382A evaluation board demonstrates the optimum layout and power supply arrangements.
4.10
Analog Output and Filtering
The application note “Design Notes for a 2-pole Filter with Differential Input” discusses the second-order
Butterworth filter and differential-to-single-ended converter which was implemented on the CS4382A eval-
uation board, CDB4382A, as seen in Figure 16. The CS4382A does not include phase or amplitude com-
pensation for an external filter. Therefore, the DAC system phase and amplitude response will be dependent
on the external analog circuitry. The off-chip filter has been designed to attenuate the typical full-scale out-
put level to below 2 Vrms.
Figure 15 shows how the full-scale differential analog output level specification is derived.
相關PDF資料
PDF描述
0210490183 CABLE JUMPER 1.25MM .229M 12POS
VE-B3V-EY CONVERTER MOD DC/DC 5.8V 50W
UPTW6181MRD CAP ALUM 180UF 420V 20% RADIAL
CDB4362A BOARD EVAL FOR CS4362A DAC
YLCDRSK1668S KIT DEMONSTRATION LCD H8SX1668
相關代理商/技術參數
參數描述
CDB4383 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 8-Channel D/A Converter
CDB4384 功能描述:音頻 IC 開發工具 Eval Bd 8-Ch DAC w/DSD RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V
CDB4385 功能描述:音頻 IC 開發工具 Eval Bd 8-Ch DAC w/DSD RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V
CDB4390 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit, Stereo D/A Converter for Digital Audio
CDB4391 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:24-Bit, 192 kHz Stereo DAC with Volume Control