• <var id="iedo3"></var>
    <table id="iedo3"></table>
    <var id="iedo3"><pre id="iedo3"></pre></var>
    參數資料
    型號: BU-61843F3-412
    廠商: DATA DEVICE CORP
    元件分類: 微控制器/微處理器
    英文描述: 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    封裝: 25.40 X 25.40 MM, 3.94 MM HEIGHT, CERAMIC, FP-72
    文件頁數: 29/60頁
    文件大?。?/td> 457K
    代理商: BU-61843F3-412
    35
    Data Device Corporation
    www.ddc-web.com
    BU-6174X/6184X/6186X
    F-10/02-300
    HOST
    Enhanced
    55
    55
    CH. A
    TX/RXA
    55
    55
    CH. B
    TX/RXB
    RTAD4-RTAD0
    RT
    ADDRESS,
    PARITY
    RTADP
    D15-D0
    +5V (3.3V)
    (NOTE 5)
    CLK IN
    CLOCK
    OSCILLATOR
    N/C
    POLARITY_SEL
    (NOTE 2)
    ZERO_WAIT
    (NOTE 3)
    ADDRESS
    DECODER
    SELECT
    MEM/REG
    RD/WR
    STRBD
    READYD
    TAG_CLK
    RD/WR
    CPU STROBE
    CPU ACKNOWLEDGE
    (NOTE 4)
    RESET
    +5V
    MSTCLR
    SSFLAG/EXT_TRIG
    INT
    CPU INTERRUPT REQUEST
    NOTES:
    3. ZERO_WAIT SHOULD BE STRAPPED TO
    LOGIC "1" FOR NON-ZERO WAIT INTERFACE
    AND TO LOGIC "0" FOR ZERO WAIT INTERFACE.
    4. CPU ACKNOWLEDGE PROCESSOR INPUT ONLY
    FOR NON-ZERO WAIT TYPE OF INTERFACE.
    5. +3.3V POWER FOR BU-61743 / 61843 / 61864 ONLY
    1. CPU ADDRESS LATCH SIGNAL PROVIDED BY
    PROCESSORS WITH MULTIPLEXED ADDRESS/DATA
    BUSES. FOR PROCESSORS WITH NON-MULTIPLEXED
    ADDRESS AND DATA BUSSES, ADDR_LAT SHOULD BE
    CONNECTED TO +5V.
    2. IF POLARITY_SEL = "1", RD/WR IS HIGH TO READ,
    LOW TO WRITE.
    IF POLARITY_SEL = "0", RD/WR IS LOW TO READ,
    HIGH TO WRITE.
    A15-A12
    A11-A0
    N/C
    ADDR_LAT
    TRANSPARENT/BUFFERED
    CPU ADDRESS LATCH (NOTE 1)
    +5V
    16/8_BIT
    TRIGGER_SEL
    MSB/LSB
    +5V
    Mini-ACE/
    -ACE
    FIGURE 12. HOST PROCESSOR INTERFACE - 16-BIT BUFFERED CONFIGURATION
    The Enhanced Mini-ACE/-ACE's maximum host holdoff time
    (time prior to the assertion of the READYD handshake signal)
    has been significantly reduced. For ACE/Mini-ACE, this maxi-
    mum holdoff time is 17 internal word transfer cycles, resulting in
    an overall holdoff time of approximately 4.6 s, using a 16 MHz
    clock. By comparison, using the Enhanced Mini-ACE/-ACE's
    ENHANCED CPU ACCESS feature, this worst-case holdoff time
    is reduced significantly, to a single internal transfer cycle. For
    example, when operating the Enhanced Mini-ACE/-ACE in its
    16-bit buffered, non-zero wait configuration with a 16 MHz clock
    input, this results in a maximum overall host transfer cycle time
    of 632 ns for a read cycle, or 570 ns for a write cycle.
    In addition, when using the ACE or Mini-ACE in the transpar-
    ent/DMA configuration, the maximum request-to-grant time,
    which occurs prior to an RT start-of-message sequence, is 4.0
    s with a 16 MHz clock, or 3.5 s with a 12 MHz clock. For the
    Enhanced Mini-ACE/-ACE functioning as a MIL-STD-1553B
    RT, this time has been increased to 8.5 s at 10 MHz, 9 s at 12 MHz,
    10 s at 16 MHz, and 10.5 s at 20MHz. This provides greater
    flexibility, particularly for systems in which a host has to arbitrate
    among multiple DMA requestors.
    By far, the most commonly used processor interface configura-
    tion is the 16-bit buffered, non-zero wait mode. This configuration
    may be used to interface between 16-bit or 32-bit microproces-
    sors and an Enhanced Mini-ACE/-ACE. In this mode, only the
    Enhanced Mini-ACE/-ACE's internal 4K or 64K words of inter-
    nal RAM are used for storing 1553 message data and associat-
    ed "housekeeping" functions. That is, in this configuration, the
    Enhanced Mini-ACE/-ACE will never attempt to access memo-
    ry on the host bus.
    FIGURE 12 illustrates a generic connection diagram between a
    16-bit (or 32-bit) microprocessor and an Enhanced Mini-ACE/-
    ACE for the 16-bit buffered configuration, while FIGURES 13 and
    14, and associated tables illustrate the processor read and write
    timing respectively.
    相關PDF資料
    PDF描述
    BU-61864F4-420 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-61865F3-112 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-61865G3-102 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-61865G3-400 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    BU-61743F3-170Z 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72
    相關代理商/技術參數
    參數描述
    BU-61843F4-100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU-61843F4-110 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU-61843G3-100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU-61843G3-110 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC
    BU-61843G4-100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC