參數資料
型號: ATMEGA325-16MUR
廠商: Atmel
文件頁數: 55/85頁
文件大?。?/td> 0K
描述: MCU AVR 32K FLASH 16MHZ 64QFN
產品培訓模塊: megaAVR Introduction
標準包裝: 4,000
系列: AVR® ATmega
核心處理器: AVR
芯體尺寸: 8-位
速度: 16MHz
連通性: SPI,UART/USART,USI
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 54
程序存儲器容量: 32KB(16K x 16)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 1K x 8
RAM 容量: 2K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
數據轉換器: A/D 8x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 64-VFQFN 裸露焊盤
包裝: 帶卷 (TR)
30
2570N–AVR–05/11
ATmega325/3250/645/6450
This clock may be selected as the system clock by programming the CKSEL Fuses as shown in
Table 9-7 on page 30. If selected, it will operate with no external components. During reset,
hardware loads the pre-programmed calibration value into the OSCCAL Register and thereby
automatically calibrates the RC Oscillator. The accuracy of this calibration is shown as Factory
By changing the OSCCAL register from SW, see “OSCCAL – Oscillator Calibration Register” on
page 32, it is possible to get a higher calibration accuracy than by using the factory calibration.
The accuracy of this calibration is shown as User calibration in Table 28-2 on page 300.
When this Oscillator is used as the chip clock, the Watchdog Oscillator will still be used for the
Watchdog Timer and for the Reset Time-out. For more information on the pre-programmed cali-
bration value, see the section “Calibration Byte” on page 268.
Note:
1. The device is shipped with this option selected.
2. The frequency ranges are preliminary values. Actual values are TBD.
3. If 8MHz frequency exceeds the specification of the device (depends on V
CC), the CKDIV8
Fuse can be programmed in order to divide the internal frequency by 8.
When this Oscillator is selected, start-up times are determined by the SUT Fuses as shown in
Note:
The device is shipped with this option selected.
9.6
External Clock
To drive the device from an external clock source, XTAL1 should be driven as shown in Figure
9-3 on page 31. To run the device on an external clock, the CKSEL Fuses must be programmed
to “0000” (see Table 9-9 on page 30).
Table 9-7.
Internal Calibrated RC Oscillator Operating Modes
Frequency Range(2) (MHz)
CKSEL3..0
7.3 - 8.1
0010
Table 9-8.
Start-up times for the internal calibrated RC Oscillator clock selection
Power Conditions
Start-up Time from Power-
down and Power-save
Additional Delay from
Reset (VCC = 5.0V)
SUT1..0
BOD enabled
6 CK
14CK
00
Fast rising power
6 CK
14CK + 4.1ms
01
Slowly rising power
6 CK
14CK + 65ms(Note:)
10
Reserved
11
Table 9-9.
Crystal Oscillator Clock Frequency
Frequency Range
CKSEL3..0
0 - 16MHz
0000
相關PDF資料
PDF描述
ATMEGA325-16AUR MCU AVR 32K FLASH 16MHZ 64TQFP
ATMEGA16M1-AU IC MCU AVR 16K FLASH 32TQFP
AT91SAM7S321-AU-999 IC MCU ARM7 32KB FLASH 64LQFP
AT91SAM7S32B-MU-999 IC MCU ARM7 32KB FLASH 48-VQFN
ATMEGA165P-16MNR IC MCU AVR 16K 16MHZ 64MLF
相關代理商/技術參數
參數描述
ATMEGA325-20AU 制造商:Atmel Corporation 功能描述:
ATMEGA325A 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 16/32/64K Bytes In-System Programmable Flash
ATMEGA325A-AN 功能描述:8位微控制器 -MCU AVR 32K FL 2K SRAM 1KB EE 20MHz 105C RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA325A-ANR 功能描述:8位微控制器 -MCU AVR 32K FL 2K SRAM 1KB EE 20MHz 105C RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ATMEGA325A-AU 功能描述:8位微控制器 -MCU AVR 32K FLSH 2K SRAM 1KB EE-20MHz IND RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT