- 您現在的位置：買賣IC網 > PDF目錄1904 > ATA6620N-TAQY (Atmel)TXRX LIN BUS W/VREG SO-8 PDF資料下載
參數資料
| 型號： | ATA6620N-TAQY |
| 廠商： | Atmel |
| 文件頁數： | 21/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | TXRX LIN BUS W/VREG SO-8 |
| 產品變化通告： | ATA6620N-TAxY Obsolescence 03/Feb/2012 |
| 標準包裝： | 4,000 |
| 類型： | 收發器 |
| 規程： | LIN |
| 電源電壓： | 5 V ~ 18 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁
8
4850I–AUTO–09/09
ATA6620N
4.2.2
Sleep Mode
A falling edge at EN while TXD is low switches the IC into Sleep mode. The TXD Signal has to
be logic low during the Mode Select window (see Figure 4-4). We recommend using the same
microcontroller port for EN as for TXD; in this case the mode change is only one command.
In Sleep mode the transmission path is disabled. Supply current from V
Batt is typically
I
VSsleep =10A. The VCC regulator is switched off; NRES and RXD are low. The internal slave
termination between pin LIN and pin VS is disabled to minimize the power dissipation in case pin
LIN is short-circuited to GND. Only a weak pull-up current (typically 10 A) between pin LIN and
pin VS is present.
A falling edge at pin LIN followed by a dominant bus level maintained for a certain time period
(t
bus) results in a remote wake-up request. The device switches from Sleep mode to Pre-normal
mode. The V
CC regulator is activated and the internal LIN slave termination resistor is switched
on. The remote wake-up request is indicated by a low level at pin RXD to interrupt the microcon-
troller and a high level at pin TXD (see Figure 4-5 on page 9).
With EN high you can switch directly from Silent to Normal mode. In the application where the
ATA6620N supplies the microcontroller, the wake-up from Sleep mode is only possible via pin
LIN.
If the device is switched into Sleep mode, V
CC ramps down without generating an undervoltage
reset at pin NRES.
Figure 4-4.
Switch to Sleep Mode
EN
td = 3.2 s
TXD
Sleep Mode
VCC
Delay time sleep mode
td_sleep = maximum 20 s
LIN
LIN switches directly to recessive mode
Mode select window
NRES
Normal Mode
相關PDF資料 |
PDF描述 |
|---|---|
| ATA6661-TAQJ 19 | TXRX LIN 2.0 3.3V/5V 8SOIC |
| ATA6670-FFQW | IC TXRX LIN DUAL 14VDFN |
| ATAM893T-TKSYD | IC MCU FLASH 4K MTP 20SSOP |
| ATF1500ABV-15JI | IC CPLD 15NS LOW VOLT PLCC |
| ATF1500AL-20JI | IC CPLD 20NS LOW POW 44PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ATA6620N-TAQY 19 | 功能描述:LIN 收發器 LIN SBC RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| ATA6620N-TAQY 19 | 功能描述:LIN 收發器 LIN SBC RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| ATA6620N-TASY | 功能描述:射頻無線雜項 LIN SBC RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| ATA6620-TAQY | 功能描述:IC TXRX LIN BUS 5V/50MA 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
| ATA6620-TASY | 功能描述:IC TXRX LIN BUS 5V/50MA 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,140 系列:AU 類型:收發器 驅動器/接收器數:1/1 規程:CAN 電源電壓:5.3 V ~ 27 V 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:管件 其它名稱:935267940512AU5790D14AU5790D14-ND |
發布緊急采購，3分鐘左右您將得到回復。