參數資料
型號: AT90USB162-16AUR
廠商: Atmel
文件頁數: 28/38頁
文件大小: 0K
描述: IC AVR MCU 16K FLASH 32TQFP
產品培訓模塊: MCU Product Line Introduction
megaAVR Introduction
標準包裝: 2,000
系列: AVR® 90USB
核心處理器: AVR
芯體尺寸: 8-位
速度: 16MHz
連通性: EBI/EMI,PS/2,SPI,UART/USART,USB
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 22
程序存儲器容量: 16KB(16K x 8)
程序存儲器類型: 閃存
EEPROM 大?。?/td> 512 x 8
RAM 容量: 512 x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 32-TQFP
包裝: 標準包裝
配用: ATSTK600-TQFP32-ND - STK600 SOCKET/ADAPTER 32-TQFP
ATSTK526-ND - KIT STARTER FOR AT90USB82/162
ATAVRDRAGON-ND - KIT DRAGON FLASH MEM AVR
ATSTK525-ND - KIT STARTER FOR AT90USB
AT90USBKEY2-ND - KIT DEMO FOR AT90USB
其它名稱: AT90USB162-16AURDKR
34
7707F–AVR–11/10
AT90USB82/162
6.6
External Clock
The device can utilize a external clock source as shown in Figure 6-5. To run the device on an
external clock, the CKSEL Fuses must be programmed as shown in Table 6-1.
Figure 6-5.
External Clock Drive Configuration
When this clock source is selected, start-up times are determined by the SUT Fuses as shown in
When applying an external clock, it is required to avoid sudden changes in the applied clock fre-
quency to ensure stable operation of the MCU. A variation in frequency of more than 2% from
one clock cycle to the next can lead to unpredictable behavior. If changes of more than 2% is
required, ensure that the MCU is kept in Reset during the changes.
Note that the System Clock Prescaler can be used to implement run-time changes of the internal
clock frequency while still ensuring stable operation. Refer to “System Clock Prescaler” on page
34 for details.
6.7
Clock Output Buffer
The device can output the system clock on the CLKO pin. To enable the output, the CKOUT
Fuse has to be programmed. This mode is suitable when the chip clock is used to drive other cir-
cuits on the system. The clock also will be output during reset, and the normal operation of I/O
pin will be overridden when the fuse is programmed. Any clock source, including the internal RC
Oscillator, can be selected when the clock is output on CLKO. If the System Clock Prescaler is
used, it is the divided system clock that is output.
6.8
System Clock Prescaler
The AT90USB82/162 has a system clock prescaler, and the system clock can be divided by set-
ting the “Clock Prescale Register – CLKPR” on page 35. This feature can be used to decrease
Table 6-8.
Start-up Times for the External Clock Selection
Power Conditions
Start-up Time from Power-
down and Power-save
Additional Delay from
Reset (VCC = 5.0V)
SUT1..0
BOD enabled
6 CK
14CK
00
Fast rising power
6 CK
14CK + 4.1 ms
01
Slowly rising power
6 CK
14CK + 65 ms
10
Reserved
11
NC
EXTERNAL
CLOCK
SIGNAL
XTAL2
XTAL1
GND
相關PDF資料
PDF描述
AT91FR40162SB-CU-999 IC MCU 32BIT RISC 121BGA
AT91M40800-33AI SL383 IC ARM MCU 16BIT 100TQFP
AT91M42800A-33CJ IC ARM7 MCU 144 BGA
AT91M55800A-33AU IC ARM MCU 33MHZ 176-LQFP
AT91R40008-66AU IC ARM7 MCU 100 LQFP
相關代理商/技術參數
參數描述
AT90USB162-16MU 功能描述:8位微控制器 -MCU AVR USB 16K FLASH RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT90USB162-16MUR 功能描述:8位微控制器 -MCU 16K Flash RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
AT90USB646 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Microcontroller with 64/128K Bytes of ISP Flash and USB Controller
AT90USB646_0607 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 64/128K Bytes of ISP Flash and USB Controller
AT90USB646_08 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8-bit Microcontroller with 64/128K Bytes of ISP Flash and USB Controller