- 您現在的位置：買賣IC網 > PDF目錄1902 > AT32UC3A3128-ALUT (Atmel)IC MCU 128KB FLASH 144LQFP PDF資料下載
參數資料
| 型號： | AT32UC3A3128-ALUT |
| 廠商： | Atmel |
| 文件頁數： | 26/94頁 |
| 文件大小： | 0K |
| 描述： | IC MCU 128KB FLASH 144LQFP |
| 產品培訓模塊： | MCU Product Line Introduction AVR® UC3 Introduction |
| 標準包裝： | 300 |
| 系列： | AVR®32 UC3 A3 |
| 核心處理器： | AVR |
| 芯體尺寸： | 32-位 |
| 速度： | 66MHz |
| 連通性： | EBI/EMI，I²C，IrDA，MMC，SPI，SSC，UART/USART，USB OTG |
| 外圍設備： | 欠壓檢測/復位，DMA，POR，WDT |
| 輸入/輸出數： | 110 |
| 程序存儲器容量： | 128KB（128K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 128K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.65 V ~ 1.95 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 144-LQFP |
| 包裝： | 托盤 |
| 配用： | ATSTK600-RC32-ND - STK600 ROUTING CARD AVR ATEVK1104-ND - KIT DEV/EVAL FOR AVR32 AT32UC3A ATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMR ATEVK1100-ND - KIT DEV/EVAL FOR AVR32 AT32UC3A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁
32
32072SH–AVR32–10/2012
AT32UC3A3
status register. Upon entry into Debug mode, hardware sets the SR[D] bit and jumps to the
Debug Exception handler. By default, Debug mode executes in the exception context, but with
dedicated Return Address Register and Return Status Register. These dedicated registers
remove the need for storing this data to the system stack, thereby improving debuggability. The
mode bits in the status register can freely be manipulated in Debug mode, to observe registers
in all contexts, while retaining full privileges.
Debug mode is exited by executing the retd instruction. This returns to the previous context.
4.5.5
Entry Points for Events
Several different event handler entry points exists. In AVR32UC, the reset address is
0x8000_0000. This places the reset address in the boot flash memory area.
TLB miss exceptions and scall have a dedicated space relative to EVBA where their event han-
dler can be placed. This speeds up execution by removing the need for a jump instruction placed
at the program address jumped to by the event hardware. All other exceptions have a dedicated
event routine entry point located relative to EVBA. The handler routine address identifies the
exception source directly.
AVR32UC uses the ITLB and DTLB protection exceptions to signal a MPU protection violation.
ITLB and DTLB miss exceptions are used to signal that an access address did not map to any of
the entries in the MPU. TLB multiple hit exception indicates that an access address did map to
multiple TLB entries, signalling an error.
All external interrupt requests have entry points located at an offset relative to EVBA. This
autovector offset is specified by an external Interrupt Controller. The programmer must make
sure that none of the autovector offsets interfere with the placement of other code. The autovec-
tor offset has 14 address bits, giving an offset of maximum 16384 bytes.
Special considerations should be made when loading EVBA with a pointer. Due to security con-
siderations, the event handlers should be located in non-writeable flash memory, or optionally in
a privileged memory protection region if an MPU is present.
If several events occur on the same instruction, they are handled in a prioritized way. The priority
ordering is presented in Table 4-4. If events occur on several instructions at different locations in
the pipeline, the events on the oldest instruction are always handled before any events on any
younger instruction, even if the younger instruction has events of higher priority than the oldest
instruction. An instruction B is younger than an instruction A if it was sent down the pipeline later
than A.
The addresses and priority of simultaneous events are shown in Table 4-4. Some of the excep-
tions are unused in AVR32UC since it has no MMU, coprocessor interface, or floating-point unit.
相關PDF資料 |
PDF描述 |
|---|---|
| AT32UC3B0512AU-Z2UR | IC MCU 512KB FLASH 64VQFN |
| AT32UC3C2512C-A2UT | IC MCU AVR32 512K FLASH 64TQFP |
| AT32UC3C2512C-A2ZT | IC MCU 32BIT 512KB FLASH 64TQFP |
| AT32UC3L016-D3HR | MCU AVR32 16K FLASH 48TTLGA |
| AT42QT5480-CU QS444 | IC SENSOR DUAL TOUCH 49-BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT32UC3A3128-CTUR | 功能描述:32位微控制器 - MCU 128KB, 144FBGA Ind, w/AES Mod. RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A3128-CTUT | 功能描述:32位微控制器 - MCU 128KB, 144FBGA Ind, w/AES Mod. RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A3128-D | 功能描述:32位微控制器 - MCU 128Kflash UC3A - Die in waffle pack - 13 RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A3128-DDW | 功能描述:32位微控制器 - MCU 128Kflash UC3A - Wafer RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A3128S | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:32-bit AVR? Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。