參數資料
| 型號： | AT32UC3A0512-ALTR |
| 廠商： | Atmel |
| 文件頁數： | 94/97頁 |
| 文件大小： | 0K |
| 描述： | MCU AVR32 512K FLASH 144LQFP |
| 產品培訓模塊： | MCU Product Line Introduction AVR® UC3 Introduction |
| 標準包裝： | 800 |
| 系列： | AVR®32 UC3 A0 |
| 核心處理器： | AVR |
| 芯體尺寸： | 32-位 |
| 速度： | 66MHz |
| 連通性： | EBI/EMI，以太網，I²C，SPI，SSC，UART/USART，USB OTG |
| 外圍設備： | 欠壓檢測/復位，POR，PWM，WDT |
| 輸入/輸出數： | 109 |
| 程序存儲器容量： | 512KB（512K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 64K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.65 V ~ 1.95 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 144-LQFP |
| 包裝： | 帶卷 (TR) |
| 配用： | ATEVK1105-ND - KIT EVAL FOR AT32UC3A0 ATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMR ATEVK1100-ND - KIT DEV/EVAL FOR AVR32 AT32UC3A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁當前第94頁第95頁第96頁第97頁
2006 Microchip Technology Inc.
DS70119E-page 93
dsPIC30F6010
15.13 PWM Update Lockout
For a complex PWM application, the user may need to
write up to four duty cycle registers and the time base
period register, PTPER, at a given time. In some appli-
cations, it is important that all buffer registers be written
before the new duty cycle and period values are loaded
for use by the module.
The PWM update lockout feature is enabled by setting
the UDIS control bit in the PWMCON2 SFR. The UDIS
bit affects all duty cycle buffer registers and the PWM
time base period buffer, PTPER. No duty cycle
changes or period value changes will have effect while
UDIS = 1.
15.14 PWM Special Event Trigger
The PWM module has a special event trigger that
allows A/D conversions to be synchronized to the PWM
time base. The A/D sampling and conversion time may
be programmed to occur at any point within the PWM
period. The special event trigger allows the user to min-
imize the delay between the time when A/D conversion
results are acquired and the time when the duty cycle
value is updated.
The PWM special event trigger has an SFR named
SEVTCMP, and five control bits to control its operation.
The PTMR value for which a special event trigger
should occur is loaded into the SEVTCMP register.
When the PWM time base is in an Up/Down Counting
mode, an additional control bit is required to specify the
counting phase for the special event trigger. The count
phase is selected using the SEVTDIR control bit in the
SEVTCMP SFR. If the SEVTDIR bit is cleared, the spe-
cial event trigger will occur on the upward counting
cycle of the PWM time base. If the SEVTDIR bit is set,
the special event trigger will occur on the downward
count cycle of the PWM time base. The SEVTDIR
control bit has no effect unless the PWM time base is
configured for an Up/Down Counting mode.
15.14.1
SPECIAL EVENT TRIGGER
POSTSCALER
The PWM special event trigger has a postscaler that
allows a 1:1 to 1:16 postscale ratio. The postscaler is
configured by writing the SEVOPS<3:0> control bits in
the PWMCON2 SFR.
The special event output postscaler is cleared on the
following events:
Any write to the SEVTCMP register
Any device Reset
15.15 PWM Operation During CPU Sleep
Mode
The Fault A and Fault B input pins have the ability to
wake the CPU from Sleep mode. The PWM module
generates an interrupt if either of the Fault pins is
driven low while in Sleep.
15.16 PWM Operation During CPU Idle
Mode
The PTCON SFR contains a PTSIDL control bit. This
bit determines if the PWM module will continue to
operate or stop when the device enters Idle mode. If
PTSIDL = 0, the module will continue to operate. If
PTSIDL = 1, the module will stop operation as long as
the CPU remains in Idle mode.
相關PDF資料 |
PDF描述 |
|---|---|
| ATMEGA88PV-10PU | MCU AVR 8K ISP FLASH 10MHZ 28DIP |
| HM2R06P1 | MILLIPACS RCP HSG |
| ATMEGA88PV-10MU | MCU AVR 8K ISP FLASH 10MHZ 32QFN |
| ATMEGA88PV-10AU | MCU AVR 8K ISP FLSH 10MHZ 32TQFP |
| ATMEGA88P-20PU | MCU AVR 8K ISP FLASH 20MHZ 28DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT32UC3A0512-ALTRA | 功能描述:32位微控制器 - MCU UC3A0 512Kb flash -40/+85DEG AUTO RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A0512-ALTT | 功能描述:32位微控制器 - MCU 512KB, 144LQFP -40/+85deg. Green RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A0512-ALTTA | 功能描述:32位微控制器 - MCU UC3A0 512Kb flash -40/+85DEG AUTO RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
| AT32UC3A0512-ALU | 制造商:Atmel Corporation 功能描述: |
| AT32UC3A0512-ALUR | 功能描述:32位微控制器 - MCU 512KB, 144LQFP 85deg. Green RoHS:否 制造商:Texas Instruments 核心:C28x 處理器系列:TMS320F28x 數據總線寬度:32 bit 最大時鐘頻率:90 MHz 程序存儲器大小:64 KB 數據 RAM 大小:26 KB 片上 ADC:Yes 工作電源電壓:2.97 V to 3.63 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:LQFP-80 安裝風格:SMD/SMT |
發(fā)布緊急采購，3分鐘左右您將得到回復。