參數資料
型號: AT17LV65-10SI
廠商: Atmel
文件頁數: 25/26頁
文件大?。?/td> 0K
描述: IC SRL CONFIG EEPROM 64K 20SOIC
標準包裝: 38
可編程類型: 串行 EEPROM
存儲容量: 64kb
電源電壓: 3 V ~ 3.6 V,4.5 V ~ 5.5 V
工作溫度: -40°C ~ 85°C
封裝/外殼: 20-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 20-SOIC W
包裝: 管件
產品目錄頁面: 609 (CN2011-ZH PDF)
配用: ATDH2225-ND - CABLE ISP FOR AT17
ATDH2200E-ND - CONFIGURATOR PROGRAM BOARD KIT
其它名稱: AT17LV6510SI
8
2321I–CNFG–2/08
AT17LV65/128/256/512/010/002/040
4.10
A2
Device selection input, A2. This is used to enable (or select) the device during programming
(i.e., when SER_EN is Low). A2 has an internal pull-down resistor.
4.11
READY
Open collector reset state indicator. Driven Low during power-up reset, released when power-up
is complete. It is recommended to use a 4.7 k
pull-up resistor when this pin is used.
4.12
SER_EN
Serial enable must be held High during FPGA loading operations. Bringing SER_EN Low
enables the Two-Wire Serial Programming Mode. For non-ISP applications, SER_EN should be
tied to V
CC.
4.13
V
CC
3.3V (±10%) and 5.0V (±5% Commercial, ±10% Industrial) power supply pin.
5.
FPGA Master Serial Mode Summary
The I/O and logic functions of any SRAM-based FPGA are established by a configuration pro-
gram. The program is loaded either automatically upon power-up, or on command, depending
on the state of the FPGA mode pins. In Master mode, the FPGA automatically loads the config-
uration program from an external memory. The AT17LV Serial Configuration EEPROM has
been designed for compatibility with the Master Serial mode.
This document discusses the Atmel AT40K, AT40KAL and AT94KAL applications as well as Xil-
inx applications.
6.
Control of Configuration
Most connections between the FPGA device and the AT17LV Serial EEPROM are simple and
self-explanatory.
The DATA output of the AT17LV series configurator drives DIN of the FPGA devices.
The master FPGA CCLK output drives the CLK input of the AT17LV series configurator.
The CEO output of any AT17LV series configurator drives the CE input of the next
configurator in a cascaded chain of EEPROMs.
SER_EN must be connected to V
CC (except during ISP).
The READY(1) pin is available as an open-collector indicator of the device’s reset status; it is
driven Low while the device is in its power-on reset cycle and released (tri-stated) when the
cycle is complete.
Note:
1. This pin is not available for the AT17LV65/128/256 devices.
相關PDF資料
PDF描述
1250F6 BATTERY PK S-HD 9.0V D SIZE ZINC
T97E477K010CAB CAP TANT 470UF 10V 10% 2917
TPSD226K025H0200 CAP TANT 22UF 25V 10% 2917
AT17LV65-10SC IC SRL CONFIG EEPROM 64K 20SOIC
1250F5 BATTERY PK S-HD 7.5V D SIZE ZINC
相關代理商/技術參數
參數描述
AT17LV65-10TQC 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV65-10TQI 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV65A 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV65A_06 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV65A-10BJC 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory