參數資料
型號: AT17F32-30BJU
廠商: Atmel
文件頁數: 12/14頁
文件大?。?/td> 0K
描述: IC EEPROM FLASH 32MBIT 44-PLCC
標準包裝: 25
可編程類型: 閃存
存儲容量: 32Mb
電源電壓: 2.97 V ~ 3.63 V
工作溫度: -40°C ~ 85°C
封裝/外殼: 44-LCC(J 形引線)
供應商設備封裝: 44-PLCC(16.59x16.59)
包裝: 管件
配用: ATDH2225-ND - CABLE ISP FOR AT17
ATDH2200E-ND - CONFIGURATOR PROGRAM BOARD KIT
7
3393C–CNFG–6/05
AT17F32
6.
FPGA Master Serial Mode Summary
The I/O and logic functions of any SRAM-based FPGA are established by a configuration pro-
gram. The program is loaded either automatically upon power-up, or on command, depending
on the state of the FPGA mode pins. In Master mode, the FPGA automatically loads the config-
uration program from an external memory. The AT17F Serial Configuration PROM has been
designed for compatibility with the Master Serial mode.
This document discusses the Atmel AT40K, AT40KAL and AT94KAL applications as well as Xil-
inx applications.
7.
Control of Configuration
Most connections between the FPGA device and the AT17F Serial Configurator PROM are sim-
ple and self-explanatory.
The DATA output of the AT17F Series Configurator drives DIN of the FPGA devices.
The master FPGA CCLK output drives the CLK input of the AT17F Series Configurator.
The CEO output of any AT17F Series Configurator drives the CE input of the next
Configurator in a cascade chain of configurator devices.
SER_EN must be at logic high level (internal pull-up provided) except during ISP.
The READY pin is available as an open-collector indicator of the device’s reset status; it is
driven Low while the device is in its power-on reset cycle and released (tri-stated) when the
cycle is complete.
PAGE_EN must be held Low if download paging is not desired. The PAGESEL[1:0] inputs
must be tied off High or Low. If paging is desired, PAGE_EN must be High and the PAGESEL
pins must be set to High or Low such that the desired page is selected, see Table 5-2 on
8.
Cascading Serial Configuration Devices
For multiple FPGAs configured as a daisy-chain, or for FPGAs requiring larger configuration
memories, cascaded configurators provide additional memory.
After the last bit from the first configurator is read, the clock signal to the configurator asserts its
CEO output Low and disables its DATA line driver. The second configurator recognizes the Low
level on its CE input and enables its DATA output.
After configuration is complete, the address counters of all cascaded configurators are reset if
the RESET/OE on each configurator is driven to its active (Low) level.
If the address counters are not to be reset upon completion, then the RESET/OE input can be
tied to its inactive (High) level.
9.
Programming Mode
The programming mode is entered by bringing SER_EN Low. In this mode the chip can be pro-
grammed by the 2-wire serial bus. The programming is done at V
CC supply only. Programming
super voltages are generated inside the chip. The AT17F parts are read/write at 3.3V nominal.
Ref e r t o t h e AT17F Pr og ram m ing Sp ecif icat ion ava ilable on t h e Atme l we b site
(www.atmel.com) for more programming details. AT17F devices are supported by the Atmel
ATDH2200 programming system along with many third party programmers.
相關PDF資料
PDF描述
AT17F32A-30BJU IC EEPROM FLASH 32MBIT 44-PLCC
AT17LV002A-10CU IC FPGA EEPROM 2M ALTERA 8LAP
AT17LV512-10PC IC SRL CONFG EEPROM 512K LV 8DIP
AT17N512-10SI IC FPGA 512K CONFIG MEM 20SOIC
AT18F080-30XU IC FLASH CONFIG 7MBIT 20-TSSOP
相關代理商/技術參數
參數描述
AT17F32A 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration Flash Memory
AT17F32A-30BJI 功能描述:FPGA-配置存儲器 ASICS RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20
AT17F32A-30BJU 功能描述:FPGA-配置存儲器 32M CONFIG FLASH ALTERA 44 RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20
AT17LV002 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory
AT17LV002-10BJC 功能描述:FPGA-配置存儲器 Serial EEPROM RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20