參數資料
型號: AT1454BM-GRE
廠商: Aimtron Technology Corp.
英文描述: Photoflash Capacitor Charger for DSC
中文描述: 照相閃光燈電容充電器的數碼相機
文件頁數: 12/18頁
文件大小: 494K
代理商: AT1454BM-GRE
AT1454/AT1454A/AT1454B
Preliminary Product Information
Photoflash Capacitor Charger for DSC
Application Information
AT1454 series is designed to precise control of switching current to charge photoflash
capacitors quickly and efficiently. When the Charge pin is first driven high, a one shot
set SR latches in the correct state. The built-in power MOSFET turns on and primary
current ramps up linearly according to V
BAT
and primary inductance. Comparator
monitors the switch On-time and when the switch on-time reaches limit value,
MOSFET is turned off. During this phase, stored energy of primary transformer is
delivered to the photoflash capacitor via the secondary and diode. The secondary
current is decreased linearly at a rate determined by the secondary inductance. The
secondary current is monitored by the Isec pin. When the secondary current drops
below 10mA, the fires a one shot will turn on MOSFET. The charging cycle repeats to
deliver power to the output.
AT1454 series can adjust external resistance R
SENSE
to set N-MOS switch on-time, but
switch on-time value must match with electrical characteristic of transformer. It is
usually equal to or less than saturation current of transformer otherwise transformer
will be saturated. Therefore, efficiency will be reduced.
The output voltage is detected by a voltage divider connecting to output capacitor.
When the output voltage reaches the desired voltage set by resistive voltage-divider,
comparator output goes high which resets the master latch and disable the charging
block. The N-channel MOSFET is turned off pulling the Ready pin high, indicating
that the part has finished charging. Power delivery can be restarted automatically
when feedback voltage is less than 90% of reference voltage. Power delivery can only
be restarted by toggling the Charge pin. The Charge pin gives full control of the part
to the user. The IGBT buffer will provide a sufficient current to drive IGBT to ignite
flash tube.
7F, No.9,PARK AVENUE. II, Science-Based Industrial Park, Hsinchu 300,Taiwan, R.O.C.
Tel: 886-3-563-0878 Fax: 886-3-563-0879 WWW:
http://www.aimtron.com.tw
3/24/2006 REV:1.2 Email:
service@aimtron.com.tw
12
Transformer Design
The Fly-back transformer is a key element for AT1454 series. It must be designed
carefully and checked that it does not cause excessive current or voltage on any pin of
the part. The first transformer parameter that needs to be set is the turns ratio N,
should be high enough so that the absolute maximum voltage rating for the NMOS
drain to source voltage is not exceeded. Choose the minimum turns ratio according to
following formula:
V
N
)
(
BAT
MAX
DS
OUT
MIN
V
V
相關PDF資料
PDF描述
AT1454M-GRE Photoflash Capacitor Charger for DSC
AT15-0001 Digital Attenuator, 31 dB, 5-Bit, TTL Driver DC - 2.0 GHz
AT1504 FET BIAS CONTROLLER
AT1504R FET BIAS CONTROLLER
AT1504R-GRE FET BIAS CONTROLLER
相關代理商/技術參數
參數描述
AT1454M-GRE 制造商:AIMTRON 制造商全稱:AIMTRON 功能描述:Photoflash Capacitor Charger for DSC
AT1457 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1-CELL LITHIUM AND LITHIUM POLYMER CHARGE MANAGEMENT IC
AT-148 功能描述:揚聲器與變頻器 90 dBA 10Vpp 1300Hz RoHS:否 制造商:PUI Audio 產品:Speakers 類型:Electromagnetic 頻率:900 Hz to 12 kHz 聲壓級:88 dBA 阻抗:8 Ohms 功率額定值:1.2 W 形狀:Round 端接類型:Solder Pad 直徑:15 mm 長度: 寬度: 深度:4.4 mm 磁體材料:Neodymium Iron Boran (NdFeB) 圓錐體材料:Mylar
AT14BK 制造商:Apex Tool Group 功能描述:Wrench;Adjustable;1/2in. (13mm);4in. Long;Blk Phosphate Finish;Alloy Steel;Bulk
AT14L 功能描述:整流器/與可變電容器 250vlts 1.0pF-14.0pF RoHS:否 制造商:Xicon 電容范圍:2.8 pF to 12.5 pF 容差: 電壓額定值:200 V 工作溫度范圍:- 35 C to + 85 C 端接類型:SMD/SMT 產品:Trimmer Capacitors - Ceramic Dielectric