- 您現在的位置：買賣IC網 > PDF目錄375346 > AP393S Low Power Low Offset Voltage Dual Comparators PDF資料下載
參數資料
| 型號： | AP393S |
| 英文描述： | Low Power Low Offset Voltage Dual Comparators |
| 中文描述： | 低功耗低失調電壓雙比較器 |
| 文件頁數： | 4/13頁 |
| 文件大?。?/td> | 260K |
| 代理商： | AP393S |
AP393
Low Power Low Offset Voltage Dual Comparators
Note 1:
For operating at high temperatures, the AP393 must be derated based on a 125°C maximum junction temperature and a
thermal resistance of 170°C/W which applies for the device soldered in a printed circuit board, operating in a still air ambient.
The AP393 must be derated based on a 150°C maximum junction temperature. The low bias dissipation and the “ON-OFF”
characteristic of the outputs keeps the chip dissipation very small (P
D
<100 mW), provided the output transistors are allowed
to saturate.
Note 2:
Short circuits from the output to V
+
can cause excessive heating and eventual destruction. When considering short circuits to
ground, the maximum output current is approximately 20 mA independent of the magnitude of V
.
Note 3:
This input current will only exist when the voltage at any of the input leads is driven negative. It is due to the collector-base
junction of the input PNP transistors becoming forward biased and thereby acting as input diode clamps. In addition to this
diode action, there is also lateral NPN parasitic transistor action on the IC chip. This transistor action can cause the output
voltages of the comparators to go to the V
voltage level (or to ground for a large overdrive) for the time duration that an input
is driven negative. This is not destructive and normal output states will re-establish when the input voltage, which is negative,
again returns to a value greater than -0.3V.
Note 4:
The AP393 temperature specifications are limited to 0°C < T
A
< +70°C.
Note 5:
The direction of the input current is out of the IC due to the PNP input stage. This current is essentially constant, independent
of the state of the output so no loading change exists on the reference or input lines.
Note 6:
The input common-mode voltage or either input signal voltage should not be allowed to go negative by more than 0.3V. The
upper end of the common-mode voltage range is V
-1.5V at 25°C, but either or both inputs can go to 36V without damage,
independent of the magnitude of V
.
Note 7:
The response time specified is for a 100 mV input step with 5 mV overdrive. For larger overdrive signals 300 ns can be
obtained, see typical performance characteristics section.
Note 8:
Positive excursions of input voltage may exceed the power supply level. As long as the other voltage remains within the
common-mode range, the comparator will provide a proper output state. The low input voltage state must not be less than
-0.3V (or 0.3V below the magnitude of the negative power supply, if used).
Note 9:
At output switch point, V
O
~ 1.4V, R
S
=0
with V
from 5V to 30V; and over the full input common-mode range (0V to V
+
-1.5V),
at 25°C.
Note 10:
Refer to RETS193AX for AP393 military specifications.
Typical Circuit
(V
CC
Anachip Corp.
www.anachip.com.tw Rev. 1.0 Sep 7, 2004
4/13
=5.0V
DC
)
V
O
3.0K
V
+
+V
IN
+V
REF
Basic Comparator
+
-
AP393
Driving CMOS
+
-
+5.0V
DC
100K
AP393
1/4 MM54CXX
Driving TTL
+
-
AP393
1/4 DM54XX
+5V
DC
10K
+
-
V
O
100K
100K
100K
100K
75 pF
4.3K
V
+
V
+
0
V
+
Squarewave Oscillator
1:100kHz
1/2 AP393
相關PDF資料 |
PDF描述 |
|---|---|
| AP393SA | Low Power Low Offset Voltage Dual Comparators |
| AP400-B10 | AC Current transducer AP-B10 |
| AP-B10 | ER 9C 6#12 3#8 SKT RECP |
| AP50-B10 | AB 9C 1#8 8#16 PIN RECEP |
| AP40N03GS | N-CHANNEL ENHANCEMENT MODE POWER MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AP393SA | 制造商:ANACHIP 制造商全稱:Anachip Corp 功能描述:Low Power Low Offset Voltage Dual Comparators |
| AP393SG-13 | 功能描述:開關變換器、穩壓器與控制器 BIPOLAR 16MA 36V INTERFACE RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| AP393SG-U | 功能描述:IC COMP DUAL LOW POWER 8-SOIC RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:帶電壓基準 元件數:4 輸出類型:開路漏極 電壓 - 電源，單路/雙路(±):2.5 V ~ 11 V，±1.25 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:10mV @ 5V 電流 - 輸入偏壓（最小值）:- 電流 - 輸出（標準）:0.015mA @ 5V 電流 - 靜態（最大值）:8.5µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:- 磁滯:- 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 安裝類型:表面貼裝 包裝:管件 產品目錄頁面:1386 (CN2011-ZH PDF) |
| AP393SL-13 | 功能描述:校驗器 IC INTRF OPAMP OPA BI 16MA 36V RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| AP393SL-U | 功能描述:校驗器 IC INTRF OPAMP OPA BI 16MA 36V RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。