• <samp id="meeix"></samp>
    <table id="meeix"><nobr id="meeix"><sub id="meeix"></sub></nobr></table>
    <samp id="meeix"><label id="meeix"><strong id="meeix"></strong></label></samp>
  • <li id="meeix"><form id="meeix"></form></li>
    參數資料
    型號: AMS1501CM-50
    廠商: Advanced Monolithic Systems, Inc.
    元件分類: 基準電壓源/電流源
    英文描述: 1.5A LOW DROPOUT VOLTAGE REGULATORS
    中文描述: 1.5A的低壓差調節器
    文件頁數: 3/9頁
    文件大?。?/td> 76K
    代理商: AMS1501CM-50
    Advanced Monolithic Systems, Inc.
    6680B Sierra Lane, Dublin, CA 94568 Phone (925) 556-9090 Fax (925) 556-9140
    AMS1501
    ELECTRICAL CHARACTERISTICS
    Electrical Characteristics at I
    OUT
    = 0 mA, and T
    J
    = +25°C unless otherwise specified.
    Parameter
    Device
    Conditions
    Min Typ Max
    Units
    Dropout Voltage
    Note 2
    Control Dropout
    (V
    CONTROL
    - V
    OUT
    )
    AMS1501/-1.5/-2.5/
    -2.85/-3.0/-3.3/-3.5/-5.0
    V
    POWER
    =V
    OUT
    + 0.8V, I
    LOAD
    = 10mA
    V
    POWER
    =V
    OUT
    + 0.8V, I
    LOAD
    = 1.5A
    1.00
    1.15
    1.15
    1.30
    V
    V
    Power Dropout
    (V
    POWER
    - V
    OUT
    )
    AMS1501/-1.5/-2.5/
    -2.85/-3.0/-3.3/-3.5/-5.0
    V
    CONTROL
    =V
    OUT
    + 2.5V, I
    LOAD
    = 10mA
    V
    CONTROL
    =V
    OUT
    + 2.5V, I
    LOAD
    = 1.5A
    .10
    .45
    0.17
    .50
    V
    V
    Parameters identified with
    boldface type
    apply over the full operating temperature range.
    Note 1:
    Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. For guaranteed specifications and test conditions, see the
    Electrical Characteristics
    .
    The guaranteed specifications apply only for the test conditions listed.
    Note 2:
    Unless otherwise specified V
    OUT
    = V
    SENSE
    . For the adjustable device V
    ADJ
    = 0V.
    Note 3:
    The dropout voltage for the AMS1501 is caused by either minimum control voltage or minimum power voltage. The specifications represent the minimum
    input/output voltage required to maintain 1% regulation.
    Note 4:
    For the adjustable device the minimum load current is the minimum current required to maintain regulation. Normally the current in the resistor divider
    used to set the output voltage is selected to meet the minimum load current requirement.
    Note 5:
    The control pin current is the drive current required for the output transistor. This current will track output current with a ratio of about 1:100. The
    minimum value is equal to the quiescent current of the device.
    PIN FUNCTIONS
    Sense (Pin 1):
    This pin is the positive side of the
    reference voltage for the device. With this pin it is
    possible to Kelvin sense the output voltage at the load.
    Adjust (Pin 2/5):
    This pin is the negative side of the
    reference voltage for the device. Adding a small bypass
    capacitor from the Adjust pin to ground improves the
    transient response. For fixed voltage devices the Adjust
    pin is also brought out to allow the user to add a bypass
    capacitor.
    GND (Pin 2, 7-Lead only):
    For fixed voltage devices this
    is the bottom of the resistor divider that sets the output
    voltage.
    V
    POWER
    (Pin 5/6):
    This pin is the collector to the power
    device of the AMS1501. The output load current is
    supplied through this pin. The voltage at this pin must
    be between 0.1V and 0.8V greater than the output
    voltage for the device to regulate.
    V
    CONTROL
    (Pin 4/3):
    This pin is the supply pin for the
    control circuitry of the device. The current flow into
    this pin will be about 1% of the output current. The
    voltage at this pin must be 1.3V or greater than the
    output voltage for the device to regulate.
    Output (Pin 3/4):
    This is the power output of the
    device.
    相關PDF資料
    PDF描述
    AMS1501CM 1.5A LOW DROPOUT VOLTAGE REGULATORS
    AMS1501CT RES, 200, 0.0625, W 5%, 0603
    AMS1501CT-33 1.5A LOW DROPOUT VOLTAGE REGULATORS
    AMS1501CT-35 RES, FXD, MF, CHIP, 200, 1%, 1/16W, 0603
    AMS1501CT-50 1.5A LOW DROPOUT VOLTAGE REGULATORS
    相關代理商/技術參數
    參數描述
    AMS1501CT 制造商:ADMOS 制造商全稱:ADMOS 功能描述:1.5A LOW DROPOUT VOLTAGE REGULATORS
    AMS1501CT-1.5 制造商:ADMOS 制造商全稱:ADMOS 功能描述:1.5A LOW DROPOUT VOLTAGE REGULATORS
    AMS1501CT-15 制造商:ADMOS 制造商全稱:ADMOS 功能描述:1.5A LOW DROPOUT VOLTAGE REGULATORS
    AMS1501CT-2.5 制造商:ADMOS 制造商全稱:ADMOS 功能描述:1.5A LOW DROPOUT VOLTAGE REGULATORS
    AMS1501CT-2.85 制造商:ADMOS 制造商全稱:ADMOS 功能描述:1.5A LOW DROPOUT VOLTAGE REGULATORS