- 您現在的位置：買賣IC網 > PDF目錄64112 > AMMC-5023-W10 21200 MHz - 26500 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | AMMC-5023-W10 |
| 元件分類： | 放大器 |
| 英文描述： | 21200 MHz - 26500 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| 封裝： | 0.074 X 0.0236 INCH, 0.004 INCH HEIGHT, DIE |
| 文件頁數： | 7/9頁 |
| 文件大小： | 267K |
| 代理商： | AMMC-5023-W10 |
7
Biasing and Operation
The AMMC-5023 has four cascaded gain stages as shown
in Figure 19. The first two gain stages at the input are
biased with the V
D1 drain supply. Similarly, the two output
stages are biased with the V
D2 supply. Standard LNA op-
eration is with a single positive DC drain supply voltage
(V
D1= VD2=5 V) as shown in the assembly diagram, Figure
2(a).
If desired, the output stage DC supply voltage (V
D2) can
be increased to improve output power capability while
maintaining optimum low noise bias conditions for the
input section. The output power may also be adjusted
by applying a positive voltage at V
G2 to alter the operat-
ing bias point for both the output FETs. Increasing the
voltage applied to V
G2 (more positively) results in a more
negative gate-to-source voltage and, therefore, lower
drain current. Figures 20(b) and 20(c) illustrate how the
device can be assembled for independent drain supply
operation and for output stage gate bias control.
Figure 19. AMMC-5023 Schematic.
Assembly Techniques
The backside of the MMIC chip is RF ground. For mi-
crostrip applications the chip should be attached directly
to the ground plane (e.g. circuit carrier or heatsink) using
electrically conductive epoxy [1,2]. For conductive epoxy,
the amount should be just enough to provide a thin fillet
around the bottom perimeter of the die. The ground
plane should be free of any residue that may jeopardize
electrical or mechanical attachment. Caution should be
taken to not exceed the Absolute Maximum Rating for
assembly temperature and time.
Thermosonic wedge bonding is the preferred method for
wire attachment to the bond pads. The RF connections
should be kept as short as possible to minimize induc-
tance. Gold mesh or double-bonding with 0.7 mil gold
wire is recommended.
Mesh can be attached using a 2 mil round tracking tool
and a tool force of approximately 22 grams with an ultra-
sonic power of roughly 55 dB for a duration of 76 ± 8 mS.
A guided wedge at an ultrasonic power level of 64 dB can
be used for the 0.7 mil wire. The recommended wire bond
stage temperature is 150 ± 2°C.
The chip is 100 mm thick and should be handled with
care. This MMIC has exposed air bridges on the top
surface. Handle at edges or with a custom collet (do not
pick up die with vacuum on die center.)
This MMIC is also static sensitive and ESD handling pre-
cautions should be taken.
Notes:
1. Ablebond 84-1 LM1 silver epoxy is recommended.
2. Eutectic attach is not recommended and may jeopardize reliability
of the device.
RF Input
RF Output
VG1
VD1
VG2
VD2
相關PDF資料 |
PDF描述 |
|---|---|
| AMMC-5023-W50 | 21200 MHz - 26500 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| AMMC-5024-W10 | 0.03 MHz - 40000 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
| AMMC-5024-W50 | 0.03 MHz - 40000 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
| AMMC-5024-W10 | 0.03 MHz - 40000 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
| AMMC-5024 | 0.03 MHz - 40000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMMC-5023-W50 | 功能描述:射頻放大器 Amplifier GaAs MMIC LNA RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| AMMC-5024 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:30 KHz-40GHz Traveling Wave Amplifier |
| AMMC-5024-W10 | 功能描述:射頻放大器 Amplifier GaAs MMIC TWA RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| AMMC-5024-W50 | 功能描述:射頻放大器 Amplifier GaAs MMIC TWA RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| AMMC-5025-W10 | 功能描述:射頻放大器 Amplifier GaAs MMIC TWA RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。