- 您現在的位置：買賣IC網 > PDF目錄1902 > AMIS42700WCGA4RH (ON Semiconductor)IC TXRX CAN DUAL HS 20SOIC PDF資料下載
參數資料
| 型號： | AMIS42700WCGA4RH |
| 廠商： | ON Semiconductor |
| 文件頁數： | 12/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX CAN DUAL HS 20SOIC |
| 標準包裝： | 1,500 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 2/2 |
| 規程： | CAN |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 20-SOIC |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | AMIS42700WCGA4RH-ND AMIS42700WCGA4RHOSTR |
AMIS42700
http://onsemi.com
7
Short Circuits
As specified in the maximum ratings, short circuits of the
bus wires CANHx and CANLx to the positive supply
voltage Vbat or to ground must not destroy the transceiver.
A short circuit between CANHx and CANLx must not
destroy the IC as well.
The dedicated comparator (L2VBAT) on CANL pin
detects the short to battery and after debounce timeout
switches off the affected driver only. The receiver of the
affected driver has to operate normally.
Faulty Supply
In case of a faulty supply (missing connection of the
electronic unit or the transceiver to ground, missing
connection of the electronic unit to Vbat or missing
connection of the transceiver to Vcc), the power supply
module of the electronic unit will operate such that the
transceiver is not supplied, i.e. the voltage Vcc is below the
POR level. In this condition the bus connections of the
transceiver must be in the POR state.
If the ground line of the electronic unit is interrupted, Vbat
may be applied to the Vcc pin (measured relative to the
original ground potential, to which the other units on the bus
are connected).
Reverse Electronic Unit (ECU) Supply
If the connections for ground and supply voltage of an
electronic unit (ECU) (max. 50 V) which provides Vcc for
the transceiver are exchanged, this transceiver has a ground
potential which may be up to 50 V higher than that of the
other transceivers. In this case no transceiver must be
destroyed even if several of them are connected via the bus
system.
Any exchange among the six connections CANH1,
CANH2, CANL1, CANL2, ground, and supply voltage of
the electronic unit at the connector of the unit must never
lead to the destruction of any transceiver of the bus system.
Electrical Characteristics
Definitions
All voltages are referenced to GND. Positive currents
flow into the IC. Sinking current means that the current is
flowing into the pin. Sourcing current means that the current
is flowing out of the pin.
Absolute Maximum Ratings
Stresses above those listed in Table 4 may cause
permanent device failure. Exposure to absolute maximum
ratings for extended periods may affect device reliability.
Table 4. Absolute Maximum Ratings
Symbol
Parameter
Conditions
Min.
Max.
Unit
VCC
Supply voltage
0.3
+7
V
VCANHx
DC voltage at pin CANH1/2
0 < VCC < 5.25 V; no time limit
45
+45
V
VCANLx
DC voltage at pin CANL1/2
0 < VCC < 5.25 V; no time limit
45
+45
V
VdigIO
DC voltage at digital IO pins (EN1B, EN2B,
Rint, Rx0, Text, Tx0)
0.3
VCC + 0.3
V
VREF
DC voltage at pin VREF
0.3
VCC + 0.3
V
Vtran(CANHx)
Transient voltage at pin CANH1/2
(Note 4)
150
+150
V
Vtran(CANLx)
Transient voltage at pin CANL1/2
(Note 4)
150
+150
V
Vesd(CANLx/CANHx)
ESD voltage at CANH1/2 and CANL1/2 pins
(Note 5)
(Note 7)
4
500
+4
+500
kV
V
Vesd
ESD voltage at all other pins
(Note 5)
(Note 7)
2
250
+2
+250
kV
V
Latchup
Static latchup at all pins
(Note 6)
100
mA
Tstg
Storage temperature
55
+155
°C
Tamb
Ambient temperature
40
+125
°C
Tjunc
Maximum junction temperature
40
+150
°C
4. Applied transient waveforms in accordance with “ISO 7637 part 3”, test pulses 1, 2, 3a, and 3b (see Figure 5).
5. Standardized human body model (HBM) ESD pulses in accordance to MIL883 method 3015. Supply pin 8 is ±2 kV.
6. Static latchup immunity: static latchup protection level when tested according to EIA/JESD78.
7. Standardized charged device model ESD pulses when tested according to EOS/ESD DS5.31993.
相關PDF資料 |
PDF描述 |
|---|---|
| AMIS42770ICAW1G | IC TXRX CAN DUAL HS 20SOIC |
| AMIS49587C5872G | IC MODEM PLC 50/60MHZ 52QFN |
| AOZ6184QT | IC USB 2.0 SWITCH DPDT 10QFN |
| AOZ6185QT | IC USB/AUDIO SWITCH DPDT 10QFN |
| AOZ6186QT | IC USB 2.0 SWITCH DPDT 10QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS-42770 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Dual High Speed CAN Transceiver |
| AMIS42770ICAW1G | 功能描述:CAN 接口集成電路 HS CAN REPEATER RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| AMIS42770ICAW1RG | 功能描述:CAN 接口集成電路 HS CAN REPEATER RoHS:否 制造商:Texas Instruments 類型:Transceivers 工作電源電壓:5 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:SOIC-8 封裝:Tube |
| AMIS42770ICAW1RG | 制造商:ON Semiconductor 功能描述:IC, CAN TXRX, 1MBPS, 1/1, 5.25V, SOIC-20 |
| AMIS-49200 | 制造商:AMI 制造商全稱:AMI 功能描述:Fieldbus MAU Chip |
發布緊急采購，3分鐘左右您將得到回復。