- 您現在的位置：買賣IC網 > PDF目錄375264 > ADS7819P CMOS Dual 4-Input NOR Gate 14-SOIC -55 to 125 PDF資料下載
參數資料
| 型號： | ADS7819P |
| 英文描述： | CMOS Dual 4-Input NOR Gate 14-SOIC -55 to 125 |
| 中文描述： | 12位800kHz采樣CMOS模擬數字轉換器 |
| 文件頁數： | 10/11頁 |
| 文件大小： | 317K |
| 代理商： | ADS7819P |
10
ADS7819
CALIBRATION
The ADS7819 can be trimmed in hardware or software. The
offset should be trimmed before the gain since the offset
directly affects the gain.
Hardware Calibration
To calibrate the offset and gain of the ADS7819, install the
proper resistors and potentiometers as shown in Figure 4a.
The calibration range is
±
12mV for bipolar zero and
±
30mV
for full scale.
Potentiometer P
1
and resistor R
1
form the offset adjust
circuit and P
2
and R
2
the gain adjust circuit. The exact values
are not critical. R
1
and R
2
should not be made any larger than
the value shown. They can easily be made smaller to provide
increased adjustment range. Reducing these below 15% of
the indicated values could begin to adversely affect the
operation of the converter.
P
1
and P
2
can also be made larger to reduce power dissipa-
tion. However, larger resistances will push the useful adjust-
ment range to the edges of the potentiometer. P
1
should
probably not exceed 20k
and P2 100k
in order to main-
tain reasonable sensitivity.
Software Calibration
To calibrate the offset and gain of the ADS7819, no external
resistors are required. See the
No Calibration
section for
details on the effects of the external resistor.
No Calibration
See Figure 4b for circuit connections. Note that the actual
voltage dropped across the 50
resistor is nearly two orders
of magnitude lower than the voltage dropped across the
internal resistor divider network. This should be taken into
consideration when choosing the accuracy and drift specifi-
cations of the external resistors. In most applications, 1%
metal-film resistors will be sufficient.
The external 50
resistor shown in Figure 4b may not be
necessary in some applications. This resistor provides trim
capability for the offset and compensates for a slight gain
adjustment internal to the ADS7819. Not using the 50
resistor will cause a small gain error but will have no effect
on the inherent offset error. Figure 5 shows typical transfer
function characteristics with and without the 50
resistor in
the circuit.
REFERENCE
The ADS7819 can operate with its internal 2.5V reference or an
external reference. By applying an external reference to pin 3,
the internal reference can be bypassed. The reference voltage at
REF is buffered internally and output on CAP (pin 4).
The internal reference has a 6 ppm/
°
C drift (typical) and
accounts for approximately 20% of the full scale error
(FSE =
±
0.5% for low grade,
±
0.25% for high grade.)
REF
REF (pin 3) is an input for an external reference or the
output for the internal 2.5V reference. A 0.1
μ
F capacitor
should be connected as close to the REF pin as possible. The
capacitor and the output resistance of REF create a low pass
filter to band limit noise on the reference. Using a smaller
value capacitor will introduce more noise to the reference
degrading the SNR and SINAD. The REF pin should not be
used to drive external AC or DC loads.
The range for the external reference is 2.3V to 2.7V and
determines the actual LSB size. Increasing the reference
voltage will increase the full scale range and the LSB size
of the converter which can improve the SNR.
FIGURE 5. Circuit Diagram With and Without External Resistors.
–2.46V
–2.5V
Digital
Output
+ Full Scale
Analog
Input
– Full Scale
Typical Transfer Function
with 50
Resistor
Typical Transfer Function
Without 50
Resistor
2.46V
2.5V
相關PDF資料 |
PDF描述 |
|---|---|
| ADS7819U | 12-Bit 800kHz Sampling CMOS ANALOG-to-DIGITAL CONVERTER |
| ADS7820 | CMOS Dual 4-Input NOR Gate 14-SOIC -55 to 125 |
| ADS7820P | 12-Bit 10ms Sampling CMOS ANALOG-to-DIGITAL CONVERTER |
| ADS7820PB | 12-Bit 10ms Sampling CMOS ANALOG-to-DIGITAL CONVERTER |
| ADS7820U | CMOS Dual 4-Input NOR Gate 14-SOIC -55 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADS7819PB | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| ADS7819U | 制造商:Texas Instruments 功能描述: |
| ADS7819UB | 制造商:Rochester Electronics LLC 功能描述:12 BIT A/D CONVERTER - Bulk |
| ADS7820 | 制造商:BB 制造商全稱:BB 功能描述:12-Bit 10ms Sampling CMOS ANALOG-to-DIGITAL CONVERTER |
| ADS7820P | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:BURR BROWN 功能描述:ANALOG 2000 DC S8J2B 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。