- 您現在的位置：買賣IC網 > PDF目錄10811 > ADM488ANZ (Analog Devices Inc)IC TXRX RS485 LO SLEW 8DIP PDF資料下載
參數資料
| 型號： | ADM488ANZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX RS485 LO SLEW 8DIP |
| 標準包裝： | 50 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | RS422，RS485 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 8-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 8-PDIP |
| 包裝： | 管件 |
| 產品目錄頁面： | 790 (CN2011-ZH PDF) |
ADM488/ADM489
Rev. D | Page 12 of 16
300ms
16ms
V
t
V
0.2/0.4ms
t
5ns
50ns
00
07
9-
02
5
Figure 25. IEC1000-4-4 Fast Transient Waveform
Table 8 shows the peak voltages for each of the environments.
Table 8. Peak Voltages
Level
VPEAK (kV) PSU
VPEAK (kV) I/O
1
0.5
0.25
2
1
0.5
3
2
1
4
2
A simplified circuit diagram of the actual EFT generator is
shown in Figure 26.
These transients are coupled onto the signal lines using an EFT
coupling clamp. The clamp is 1 m long and completely sur-
rounds the cable, providing maximum coupling capacitance
(50 pF to 200 pF typical) between the clamp and the cable. High
energy transients are capacitively coupled onto the signal lines.
Fast rise times (5 ns), as specified by the standard, result in very
effective coupling. This test is very severe because high voltages
are coupled onto the signal lines. The repetitive transients often
cause problems, while single pulses do not. Destructive latch-up
can be induced due to the high energy content of the transients.
Note that this stress is applied while the interface products are
powered up and transmitting data. The EFT test applies hun-
dreds of pulses with higher energy than ESD. Worst-case
transient current on an I/O line can be as high as 40 A.
RC
CC
ZS
L
RM CD
HIGH
VOLTAGE
SOURCE
50
OUTPUT
00
07
9-
0
26
Figure 26. EFT Generator
Test results are classified according to the following:
Normal performance within specification limits.
Temporary degradation or loss of performance that is self-
recoverable.
Temporary degradation or loss of function or performance
that requires operator intervention or system reset.
Degradation or loss of function that is not recoverable due
to damage.
The ADM488/ADM489 have been tested under worst-case
conditions using unshielded cables, and meet Classification 2 at
Severity Level 4. Data transmission during the transient
condition is corrupted, but it can be resumed immediately
following the EFT event without user intervention.
RADIATED IMMUNITY (IEC1000-4-3)
IEC1000-4-3 (previously IEC801-3) describes the measurement
method and defines the levels of immunity to radiated electro-
magnetic fields. It was originally intended to simulate the
electromagnetic fields generated by portable radio transceivers
or any other device that generates continuous wave-radiated
electromagnetic energy. Its scope has been broadened to include
spurious EM energy, which can be radiated from fluorescent
lights, thyristor drives, inductive loads, and so on.
Testing for immunity involves irradiating the device with an
EM field. Test methods include the use of anechoic chamber,
stripline cell, TEM cell, and GTEM cell. These consist of two
parallel plates with an electric field developed between them.
The device under test is placed between the plates and exposed
to the electric field. The three severity levels have field strengths
ranging from 1 V/m to 10 V/m. Results are classified as follows:
Normal operation.
Temporary degradation or loss of function that is self-
recoverable when the interfering signal is removed.
Temporary degradation or loss of function that requires
operator intervention or system reset when the interfering
signal is removed.
Degradation or loss of function that is not recoverable due
to damage.
相關PDF資料 |
PDF描述 |
|---|---|
| ADM488ARZ | IC TX/RX RS-485 LO-SLEW 8SOIC |
| VE-J1T-MY-S | CONVERTER MINIMOD DC/DC 6.5V 50W |
| VI-J1T-MY-S | CONVERTER MINIMOD DC/DC 6.5V 50W |
| VE-J1V-MY-S | CONVERTER MINIMOD DC/DC 5.8V 50W |
| VI-J1V-MY-S | CONVERTER MINIMOD DC/DC 5.8V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM488ANZ | 制造商:Analog Devices 功能描述:IC CMOS BUS TRANSCEIVER DIP8 488 |
| ADM488AR | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 8-Pin SOIC N 制造商:Analog Devices 功能描述:LOW POWER SLEW RATE RS-485 ((NS)) |
| ADM488AR-REEL | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 8-Pin SOIC N T/R 制造商:Analog Devices 功能描述:LINE TRNSCVR 1TR 1TX 1RX 8SOIC N - Tape and Reel |
| ADM488AR-REEL7 | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 8-Pin SOIC N T/R |
| ADM488ARZ | 功能描述:IC TX/RX RS-485 LO-SLEW 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
發布緊急采購，3分鐘左右您將得到回復。