- 您現在的位置：買賣IC網 > PDF目錄97842 > ADL5504ACBZ-P7 (ANALOG DEVICES INC) 450 MHz - 6000 MHz RF/MICROWAVE LINEAR DETECTOR PDF資料下載
參數資料
| 型號： | ADL5504ACBZ-P7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 檢測器 |
| 英文描述： | 450 MHz - 6000 MHz RF/MICROWAVE LINEAR DETECTOR |
| 封裝： | 1.20 X 0.80 MM, ROHS COMPLIANT, CB-6-8, WLCSP-6 |
| 文件頁數： | 6/24頁 |
| 文件大小： | 1156K |
| 代理商： | ADL5504ACBZ-P7 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
ADL5504
Rev. A | Page 14 of 24
APPLICATIONS INFORMATION
BASIC CONNECTIONS
Figure 34 shows the basic connections for the ADL5504. The
device is powered by a single supply between 2.5 V and 3.3 V,
with a quiescent current of 1.8 mA. The VPOS pin is decoupled
using 100 pF and 0.1 F capacitors.
Placing a single 75 Ω resistor at the RF input provides a
broadband match of 50 . More precise resistive or reactive
matches can be applied for narrow frequency band use (see
the RF Input Interfacing section).
The rms averaging can be augmented by placing additional
capacitance at CFLTR. The ac residual can be reduced further by
increasing the output capacitance, COUT. The combination of
the internal 100 output resistance and COUT produces a low-
pass filter to reduce output ripple of the VRMS output (see the
section for more details).
RFIN
CFLTR
+VS = 2.5V TO 3.3V
VRMS
ROUT
0.1F
100pF
COUT
FLTR
VPOS
RFIN
ENBL
VRMS
COMM
ADL5504
1
2
3
6
5
4
R10
75
08437-
034
Figure 34. Basic Connections for ADL5504
RF INPUT INTERFACING
The input impedance of the ADL5504 decreases with increasing
frequency in both its resistive and capacitive components (see
Figure 9). The resistive component varies from 370 Ω at 900 MHz
to about 240 Ω at 2600 MHz.
A number of options exist for input matching. For operation
at multiple frequencies, a 75 Ω shunt to ground, as shown in
Figure 35, provides the best overall match. For use at a single
frequency, a resistive or a reactive match can be used. By plotting
the input impedance on a Smith chart, the best value for a
resistive match can be calculated. (Both input impedance and
input capacitance can vary by up to ±20% around their nominal
values.) Where VSWR is critical, the match can be improved
with a series inductor placed before the shunt component.
ADL5504
RFIN
RF TRANSMISSION LINE
50
DIRECTIONAL
COUPLER
75
ATTN
08437-
035
Figure 35. Input Interfacing to Directional Coupler
Resistive Tap RF Input
Figure 36 shows a technique for coupling the input signal into
the ADL5504 that can be applicable when the input signal is
much larger than the input range of the ADL5504. A series
resistor combines with the input impedance of the ADL5504
to attenuate the input signal. Because this series resistor forms
a divider with the frequency-dependent input impedance, the
apparent gain changes greatly with frequency. However, this
method has the advantage of very little power being tapped
off in RF power transmission applications. If the resistor is
large compared with the impedance of the transmission line,
the VSWR of the system is relatively unaffected.
ADL5504
RFIN
RF TRANSMISSION LINE
RSERIES
08437-
036
Figure 36. Attenuating the Input Signal
The resistive tap or series resistance, RSERIES, can be expressed as
RSERIES = RIN (1 10ATTN/20)/(10ATTN/20)
(1)
where:
RIN is the input resistance of RFIN.
ATTN is the desired attenuation factor in decibels.
For example, if a power amplifier with a maximum output power
of 28 dBm is matched to the ADL5504 input at 5 dBm, then a
23 dB attenuation factor is required. At 900 MHz, the input
resistance, RIN, is 370 .
RSERIES = (370 )(1 1023/20)/(1023/20) = 4870
(2)
Thus, for an attenuation of 23 dB, a series resistance of
approximately 4.87 k is needed.
相關PDF資料 |
PDF描述 |
|---|---|
| ADL5535ARKZ-R7 | 20 MHz - 1000 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| ADL5571 | 2500 MHz - 2700 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ADRF6704ACPZ | 2500 MHz - 2900 MHz RF/MICROWAVE I/Q MODULATOR |
| AFEM-7780-BLK | 1920 MHz - 1980 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| AGB3301RS24Q1 | 250 MHz - 3000 MHz RF/MICROWAVE WIDE BAND MEDIUM POWER AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADL5504-EVALZ | 制造商:Analog Devices 功能描述:EVALUATION BOARDS - Bulk |
| ADL5504XCBZ | 功能描述:IC DETECTOR RF TRUPWR 制造商:analog devices inc. 系列:* 零件狀態:上次購買時間 標準包裝:1 |
| ADL5505 | 制造商:AD 制造商全稱:Analog Devices 功能描述:450 MHz to 6000Mhz TruPwr Detector |
| ADL5505ACBZ-P2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:450 MHz to 6000Mhz TruPwr Detector |
| ADL5505ACBZ-P7 | 功能描述:IC DETECTOR RF TRUPWR 4-WLCSP RoHS:是 類別:RF/IF 和 RFID >> RF 檢測器 系列:TruePower™ 產品變化通告:Product Discontinuation 15/May/2006 標準包裝:3,000 系列:- 頻率:100MHz ~ 2GHz RF 型:手機，GSM，DCS，PCS 輸入范圍:- 精確度:- 電源電壓:2.7 V ~ 5.5 V 電流 - 電源:300µA 包裝:帶卷 (TR) 封裝/外殼:SC-74，SOT-457 其它名稱:NCS5000SNT1GOS |
發布緊急采購，3分鐘左右您將得到回復。