- 您現在的位置：買賣IC網 > PDF目錄5415 > ADA4891-4ARZ-RL (Analog Devices Inc)IC OPAMP GP R-R CMOS 14SOIC PDF資料下載
參數資料
| 型號： | ADA4891-4ARZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 7/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP R-R CMOS 14SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 通用 |
| 電路數： | 4 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 210 V/µs |
| -3db帶寬： | 240MHz |
| 電流 - 輸入偏壓： | 2pA |
| 電壓 - 輸入偏移： | 2500µV |
| 電流 - 電源： | 4.4mA |
| 電流 - 輸出 / 通道： | 125mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 14-SOIC |
| 包裝： | 帶卷 (TR) |
Data Sheet
ADA4891-1/ADA4891-2/ADA4891-3/ADA4891-4
Rev. E | Page 15 of 24
APPLICATIONS INFORMATION
USING THE ADA4891
Understanding the subtleties of the ADA4891 family of amplifiers
provides insight into how to extract the peak performance from
the device. The following sections describe the effect of gain,
component values, and parasitics on the performance of the
ADA4891. The wideband, noninverting gain configuration of
the ADA4891 is shown in Figure 50; the wideband, inverting
gain configuration of the ADA4891 is shown in Figure 51.
WIDEBAND, NONINVERTING GAIN OPERATION
08054-
023
ADA4891
RF
RG
RT
50
SOURCE
RL
+VS
–VS
10F
0.1F
VI
VO
10F
0.1F
Figure 50. Noninverting Gain Configuration
respectively. Together, RF and RG determine the noise gain of the
amplifier. The value of RF defines the 0.1 dB bandwidth (for
more information, see the Effect of RF on 0.1 dB Gain Flatness
section). Typical RF values range from 549 Ω to 698 Ω for the
ADA4891-1/ADA4891-2. Typical RF values range from 301 Ω
to 453 Ω for the ADA4891-3/ADA4891-4.
In a controlled impedance signal path, RT is used as the input
termination resistor designed to match the input source imped-
ance. Note that RT is not required for normal operation. RT is
generally set to match the input source impedance.
WIDEBAND, INVERTING GAIN OPERATION
08054-
024
ADA4891
RF
RT
RG
50
SOURCE
RL
+VS
–VS
VI
VO
10F
0.1F
10F
0.1F
Figure 51. Inverting Gain Configuration
Figure 51 shows the inverting gain configuration. For the
inverting gain configuration, set the parallel combination of
RT and RG to match the input source impedance.
Note that a bias current cancellation resistor is not required in
the noninverting input of the amplifier because the input bias
current of the ADA4891 is very low (less than 2 pA). Therefore,
the dc errors caused by the bias current are negligible.
For both noninverting and inverting gain configurations, it is
often useful to increase the RF value to decrease the load on the
output. Increasing the RF value improves harmonic distortion at
the expense of reducing the 0.1 dB bandwidth of the amplifier.
This effect is discussed further in the Effect of RF on 0.1 dB Gain
Flatness section.
RECOMMENDED VALUES
Table 5 and Table 6 provide a quick reference for various configu-
rations and show the effect of gain on the 3 dB small-signal
bandwidth, slew rate, and peaking of the ADA4891-1/ADA4891-2/
ADA4891-3/ADA4891-4. Note that as the gain increases, the
small-signal bandwidth decreases, as is expected from the gain
bandwidth product relationship. In addition, the phase margin
improves with higher gains, and the amplifier becomes more
stable. As a result, the peaking in the frequency response is
reduced (see Figure 7 and Figure 10).
Table 5. Recommended Component Values and Effect of Gain on ADA4891-1/ADA4891-2 Performance (RL = 1 k)
Feedback Network Values
3 dB Small-Signal Bandwidth (MHz)
Slew Rate (V/s)
Peaking (dB)
Gain
RF ()
RG ()
VOUT = 200 mV p-p
tR
tF
1
604
118
188
192
1.3
+1
0
Open
240
154
263
2.6
+2
604
120
170
210
1.4
+5
604
151
32.5
149
154
0
+10
604
67.1
12.7
71
72
0
相關PDF資料 |
PDF描述 |
|---|---|
| AD8602DR-REEL7 | IC OPAMP GP CMOS 8.4MHZ 8SOIC |
| ADA4891-4ARUZ-RL | IC OPAMP GP R-R CMOS 14TSSOP |
| 3412.0115.26 | FUSE 1A 32V 0603 FAST |
| AD8638ARZ-REEL | IC OPAMP CHOPPER R-R 37MA 8SOIC |
| MP2-SS096-41P1-TR30 | CONN SOCKET 2-FB 96POS 4ROW |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4891-4WARUZ-R7 | 功能描述:高速運算放大器 Lw Cst CMOS Hgh Spd RR Amp Quad RoHS:否 制造商:NXP Semiconductors 通道數量: 電壓增益 dB: 輸入補償電壓: 轉換速度: 工作電源電壓: 電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SO-20 封裝:Tube 產品: |
| ADA4895-1ARJZ-R2 | 功能描述:IC OPAMP GP 236MHZ RRO SOT23-6 制造商:analog devices inc. 系列:- 包裝:剪切帶（CT） 零件狀態:在售 放大器類型:通用 電路數:1 輸出類型:滿擺幅 壓擺率:943 V/μs -3db 帶寬:236MHz 電流 - 輸入偏置:11μA 電壓 - 輸入失調:53μV 電流 - 電源:3mA 電壓 - 電源，單/雙（±）:3 V ~ 10 V，±1.5 V ~ 5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商器件封裝:SOT-23-6 標準包裝:1 |
| ADA4895-1ARJZ-R7 | 功能描述:高速運算放大器 6Lead SOT23 Decomp L/N L/P Op Amp Single RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 產品: |
| ADA4895-1ARJZ-RL | 功能描述:高速運算放大器 6Lead SOT23 Decomp L/N L/P Op Amp Single RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 產品: |
| ADA4895-1ARZ | 功能描述:高速運算放大器 8-Lead SOIC Decomp L/N L/P Op Amp Single RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 產品: |
發布緊急采購，3分鐘左右您將得到回復。