參數資料
型號: AD8310ARM
廠商: ANALOG DEVICES INC
元件分類: 運動控制電子
英文描述: Fast, Voltage-Out DC-440 MHz 95 dB Logarithmic Amplifier
中文描述: LOG OR ANTILOG AMPLIFIER, 440 MHz BAND WIDTH, PDSO8
封裝: MO-187AA, MSOP-8
文件頁數: 16/16頁
文件大小: 323K
代理商: AD8310ARM
–16–
C
P
AD8310
REV. A
Table III. Evaluation Boards Setup Options
Component
TP1, TP2
SW1
Function
Supply and Ground Vector Pins
Device Enable: When in Position A, the ENBL pin is connected to +V
S
and the
AD8310 is in normal operating mode. In Position B, the ENBL pin is connected to
ground putting the device in sleep mode.
SMA Connector Grounds: Connects common of INHI and INLO SMA connectors
to ground. Can be used to isolate the generator ground from the evaluation board
ground (see Figure 26).
Input Interface: R3 (52.3
) combines with the AD8310’s 1 k
input impedance to
give an overall broadband input impedance of 50
. C1, C2, and the AD8310’s input
impedance combine to set a high-pass input corner of 32 kHz. Alternatively, R3, C1,
and C2 can be replaced by an inductor and matching capacitors to form an input
matching network. See Input Matching section for more detail.
RSSI (Video) Bandwidth Adjust: The addition of C3 (Farads) will lower the RSSI bandwidth
of the VLOG output according to the equation: C
FILT
= 1/(2
π ×
3 k
×
Video Bandwidth)
–2.1 pF.
Supply Decoupling: The nominal supply decoupling of 0.01
μ
F (C4) can be augmented by a
larger cap in C5. An inductor or small resistor can be placed in R5 for additional decoupling.
Output Source Impedance: In cable-driving applications, a resistor (typically 50
or 75
)
can be placed in R6 to give the circuit a back-terminated output impedance.
Output Loading: Resistors and capacitors can be placed in C6 and R7 to load test V
OUT
.
Jumpers W1 and W2 are used to connect/disconnect the loads.
Offset Compensation Loop:
A capacitor in C7 will reduce the corner frequency of
the offset control loop in low frequency applications.
Default Condition
Not Applicable
SW1 = A
R1/R4
R1 = R4 = 0
C1, C2, R2, R3
R3 = 52.3
R2 = 0
C1 = C2 = 0.01
μ
F
C3
C3 = Open
C4, C5, R5
C4 = 0.01
μ
F
C5 = Open, R5 = 0
R6 = 0
R6
W1, W2, C6, R7
C6 = R7 = Open
W1 = W2 = Installed
C7 = Open
C7
OUTLINE DIMENSIONS
Dimensions shown in inches and (mm).
8-Lead Mini_SO
(RM-8)
0.009 (0.23)
0.005 (0.13)
0.028 (0.70)
0.016 (0.40)
6
8
0
8
0.037 (0.95)
0.030 (0.75)
8
5
4
1
0.122 (3.10)
0.114 (2.90)
PIN 1
0.0256 (0.65) BSC
0.122 (3.10)
0.114 (2.90)
0.193
(4.90)
BSC
SEATING
PLANE
0.006 (0.15)
0.002 (0.05)
0.016 (0.40)
0.010 (0.25)
0.043
(1.10)
MAX
相關PDF資料
PDF描述
AD8310ARM-REEL Fast, Voltage-Out DC-440 MHz 95 dB Logarithmic Amplifier
AD8310ARM-REEL7 Fast, Voltage-Out DC-440 MHz 95 dB Logarithmic Amplifier
AD8315 50 dB GSM PA Controller
AD8315-EVAL 50 dB GSM PA Controller
AD8315ACP-EVAL 50 dB GSM PA Controller
相關代理商/技術參數
參數描述
AD8310ARM-REEL 制造商:Analog Devices 功能描述:SP Amp LOG Amp Single R-R I/P 5.5V 8-Pin MSOP T/R
AD8310ARM-REEL7 功能描述:IC LOGARITHMIC AMP 8-MSOP T/R RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP(5x5) 包裝:托盤
AD8310ARMZ 功能描述:IC LOGARITHMIC AMP 95DB 8-MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP(5x5) 包裝:托盤
AD8310ARMZ 制造商:Analog Devices 功能描述:Operational Amplifier (Op-Amp) IC
AD8310ARMZ-REEL1 制造商:AD 制造商全稱:Analog Devices 功能描述:Fast, Voltage-Out DC-440 MHz, 95 dB Logarithmic Amplifier