- 您現在的位置：買賣IC網 > PDF目錄1892 > AD8108ASTZ (Analog Devices Inc)IC VIDEO CROSSPOINT SWIT 80LQFP PDF資料下載
參數資料
| 型號： | AD8108ASTZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 22/33頁 |
| 文件大小： | 0K |
| 描述： | IC VIDEO CROSSPOINT SWIT 80LQFP |
| 標準包裝： | 1 |
| 功能： | 視頻交叉點開關 |
| 電路： | 1 x 8:8 |
| 電壓電源： | 雙電源 |
| 電壓 - 電源，單路/雙路(±)： | ±4.5 V ~ 5.5 V |
| 電流 - 電源： | 33mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 80-LQFP |
| 供應商設備封裝： | 80-LQFP（12x12） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
AD8108/AD8109
Rev. B | Page 28 of 32
EVALUATION BOARD
A 4-layer evaluation board for the AD8108/AD8109 is available.
The exact same board and external components are used for each
device. The only difference is the device itself, which offers a
selection of a gain of unity or gain of 2 through the analog
channels. This board has been carefully laid out and tested to
demonstrate the specified high speed performance of the device.
Figure 60 shows the schematic of the evaluation board. Figure 53
shows the component side silk-screen. The layouts of the board’s
four layers are given in Figure 54, Figure 55, Figure 56, and
The evaluation board package includes the following:
Fully populated board with BNC-type connectors.
Windows-based software for controlling the board from a
PC via the printer port.
Custom cable to connect evaluation board to PC.
Disk containing Gerber files of board layout.
CONTROL THE EVALUATION BOARD FROM A PC
The evaluation board includes Windows-based control software
and a custom cable that connects the board’s digital interface to
the printer port of the PC. The wiring of this cable is shown in
Figure 58. The software requires Windows 3.1 or later to
operate. To install the software, insert the disk labeled Disk 1 of
2 into the PC and run the file called SETUP.EXE. Additional
installation instructions will be given on-screen. Before
beginning installation, it is important to terminate any other
Windows applications that are running.
CLK
DATA IN
RESET
UPDATE
CE
DGND
MOLEX 0.100" CENTER
CRIMP TERMINAL HOUSING
1
6
D-SUB 25 PIN (MALE)
14 1
25
13
EVALUATION BOARD
PC
2
3
4
5
6
25
3
1
4
5
2
6
SIGNAL
DATA IN
CE
RESET
UPDATE
CLK
DGND
MOLEX
TERMINAL HOUSING
D-SUB-25
01068-059
Figure 58. Evaluation Board-PC Connection Cable
When you launch the crosspoint control software, you will be
asked to select the printer port. Most modern PCs have only
one printer port, usually called LPT1. However, some laptop
computers use the PRN port.
Figure 59 shows the main screen of the control software in its
initial reset state (all outputs off). Using the mouse, any input
can be connected with one or more outputs by simply clicking
on the appropriate radio buttons in the 8 × 8 on-screen array.
Each time a button is clicked on, the software automatically
sends and latches the required 32-bit data stream to the
evaluation board. An output can be turned off by clicking the
appropriate button in the off column. To turn off all outputs,
click on RESET.
The software offers volatile and nonvolatile storage of
configurations. For volatile storage, up to two configurations
can be stored and recalled using the Memory 1 and Memory 2
buffers. These function in an identical fashion to the memory
on a pocket calculator. For nonvolatile storage of a
configuration, the save setup and load setup functions can be
used. This stores the configuration as a data file on disk.
OVERSHOOT OF PC PRINTER PORTS’ DATA LINES
The data lines on some printer ports have excessive overshoot.
Overshoot on the pin that is used as the serial clock (Pin 6 on
the D-Sub-25 connector) can cause communication problems.
This overshoot can be eliminated by connecting a capacitor
from the CLK line on the evaluation board to ground. A pad
has been provided on the solder side of the evaluation board to
allow this capacitor to be soldered into place. Depending on the
overshoot from the printer port, this capacitor may need to be
as large as 0.01F
01068-
060
Figure 59. Evaluation Board Control Panel
相關PDF資料 |
PDF描述 |
|---|---|
| AD8110ASTZ | IC VIDEO CROSSPOINT SWIT 80LQFP |
| AD8112JSTZ | IC CROSSPOINT SWIT 16X8 100LQFP |
| AD8113JSTZ | IC VIDEO CROSSPOINT SWIT 100LQFP |
| AD8114ASTZ | IC VIDEO CROSSPOINT SWIT 100LQFP |
| AD8116JSTZ | IC VIDEO CROSSPOINT SWIT 128LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8108ASTZ | 制造商:Analog Devices 功能描述:IC SWITCH VIDEO |
| AD8108ASTZ2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:325 MHz, 8 ?? 8 Buffered Video Crosspoint Switches |
| AD8108EB | 制造商:Analog Devices 功能描述: |
| AD8108-EB | 制造商:Analog Devices 功能描述:Evaluation Board For IC Video Crosspt 325MHz 8X8 制造商:Analog Devices 功能描述:VID CROSSPT 325MHZ 8X8 - Bulk |
| AD8109 | 制造商:AD 制造商全稱:Analog Devices 功能描述:325 MHz, 8 x 8 Buffered Video Crosspoint Switches |
發布緊急采購，3分鐘左右您將得到回復。